Can You Still Drive If the Tensioner Is Broken?

How Long Should You Wait Before Turning Off the Engine After a Jump Start?

After a jump start, you should wait at least 30 minutes before turning off the engine to ensure sufficient battery charge. Here is some additional information: Battery: Also known as a storage battery, it is a device that converts chemical energy into electrical energy. Car batteries typically refer to lead-acid batteries, which are mainly made of lead and its oxides, with sulfuric acid solution as the electrolyte. The normal service life of a car battery ranges from 1 to 8 years, depending largely on the vehicle's usage. Battery Replacement: If the battery is dead, it is recommended to first measure the battery voltage. If using a multimeter, measure the battery voltage while cranking the engine. You can first use a high-frequency discharge machine or a battery tester to measure. Under a load current of no less than 110 amps, the minimum voltage should not be lower than 9.6 volts and should remain stable for 5 seconds. If the voltage is below 9.6 volts but remains stable for 5 seconds, it indicates over-discharge, and the battery should be recharged promptly. If the voltage is below 9.6 volts and cannot remain stable for 5 seconds, dropping rapidly to 0 volts or close to 0 volts, it suggests a battery fault, and the battery may need replacement.

20

0

Share

What is the purpose of a voltage regulator?

Voltage regulator is a device that stabilizes the output voltage. It consists of voltage adjustment circuit, control circuit, servo motor, etc. When the input voltage or load changes, the control circuit performs sampling, comparison, and amplification, driving the servo motor to rotate, thereby changing the position of the voltage regulator's carbon brush. By automatically adjusting the coil turns ratio, it maintains the stability of the output voltage. The function of a voltage regulator is to stabilize the power supply voltage, which may fluctuate significantly or fail to meet the requirements of electrical equipment, within its set value range, ensuring that various circuits or electrical equipment can operate normally at the rated working voltage. Voltage regulators can be widely used in industrial and mining enterprises, oil fields, railways, construction sites, schools, hospitals, post and telecommunications, hotels, scientific research departments, etc., for electronic computers, precision machine tools, computed tomography (CT) scanners, precision instruments, experimental devices, elevator lighting, imported equipment, and production lines where stable power supply voltage is required.

8

0

Share

How to reset the wrench light on a 2019 CR-V?

2019 CR-V reset the wrench light method is: 1. Turn the power to ON mode, repeatedly press the display information button until "Maintenance" appears on the screen; 2. Press the ENTER button, the engine oil monitor will appear on the display; 3. Hold the ENTER button for about 10 seconds, the maintenance light will reset. The 2019 CR-V is a compact SUV with body dimensions of: length 4585mm, width 1855mm, height 1679mm, wheelbase 2660mm, fuel tank capacity 53L, and curb weight 642kg. The 2019 CR-V features MacPherson strut front suspension and multi-link rear suspension. It is equipped with a 2.0L naturally aspirated engine producing 146PS maximum horsepower, 107kW maximum power, and 175Nm maximum torque, paired with an electronic continuously variable transmission.

2

0

Share

What engine does the Everus S1 use?

Everus S1 uses a 1.3L naturally aspirated engine and a 1.5L naturally aspirated engine. The function of the engine is to convert the thermal energy of gasoline or diesel into mechanical energy by burning and expanding gas in a sealed cylinder, thereby pushing the piston to perform work. Taking the 2014 Everus S1 as an example, it is a compact car with body dimensions of length 4460mm, width 1690mm, height 1495mm, and a wheelbase of 2450mm. The 2014 Everus S1 is equipped with a 1.3L naturally aspirated engine, with a maximum horsepower of 82ps, a maximum power of 60kw, and a maximum torque of 116nm, paired with a 5-speed manual transmission.

7

1

Share

Where is the engine number of the Lynk & Co 03 located?

The engine number of the Lynk & Co 03 is located behind the throttle body and can be seen by removing the engine cover. Taking the 2021 Lynk & Co 03 as an example, it belongs to the compact car category with body dimensions of: length 4639mm, width 1840mm, height 1472mm, and a wheelbase of 2730mm. The curb weight is 1395kg. The 2021 Lynk & Co 03 features a MacPherson strut front suspension and a multi-link independent rear suspension. It is equipped with a 1.5T turbocharged engine, delivering a maximum horsepower of 156PS, a maximum power of 115kW, and a maximum torque of 245Nm, paired with a 6-speed manual transmission.

8

0

Share

How Many Kilometers is the Break-in Period?

The break-in period ranges from one thousand to three thousand kilometers. Precautions during the break-in period include: 1. Warm up the engine before starting; 2. Avoid emergency braking; 3. Prevent overloading; 4. Avoid long-distance driving; 5. Do not drive at high speeds; 6. Use high-quality gasoline; 7. Do not remove the speed limiter prematurely; 8. Shift gears promptly; 9. Properly adjust the ignition and fuel supply systems. Methods for using the car during the break-in period are: 1. Pre-warm a cold engine—proper warming allows the oil to lubricate the engine effectively, reducing wear; 2. Shift gears in a timely manner while driving, especially for manual transmission cars. During the break-in period, it is necessary to change gears appropriately to avoid high gear at low RPM or low gear at high RPM; 3. New cars require timely maintenance during the break-in period.

13

5

Share

Can You Still Drive If the Tensioner Is Broken?

How Long Should You Wait Before Turning Off the Engine After a Jump Start?

What is the purpose of a voltage regulator?

How to reset the wrench light on a 2019 CR-V?

What engine does the Everus S1 use?

Where is the engine number of the Lynk & Co 03 located?

How Many Kilometers is the Break-in Period?

Can ETC be installed in the black dotted area?

What Are the Hazards of Flood-Damaged Vehicles?

What does it mean when a car displays 'Check Coolant Level'?

What are the causes of idling vibration in the Refine engine?