Can you sit in the driver's seat without starting the car after drinking?

1 Answers
Dale
07/30/25 1:05am
It is not considered drunk driving if you sit in the driver's seat without starting the vehicle after drinking. Criteria for determining drunk driving: Determining drunk driving depends on the blood alcohol content, which is related to the amount of alcohol consumed and the body's ability to metabolize alcohol. According to relevant regulations, a blood alcohol content of 20mg/100ml or higher is considered drunk driving, while 80mg/100ml or higher is considered driving under severe intoxication. Breathalyzer tests are not included in the determination of severe intoxication. Following the standards for criminal evidence collection, drivers suspected of severe intoxication must undergo blood tests for evidence. The data from alcohol monitoring devices used in drunk driving checks are only preliminary methods for traffic police to assess severe intoxication. A conclusive determination is made by comparing the suspect's blood alcohol content. Penalties: The penalty includes a 6-month suspension of the motor vehicle driver's license and a fine.
Was this review help?
3
2
Share
More Forum Discussions

Where is the high beam relay located in a Chevrolet Cruze?

The high beam relay in a Chevrolet Cruze is located inside the engine compartment fuse box. A relay, also known as an electric relay, is an electronic control device that consists of a control system and a controlled system, commonly used in automatic control circuits. The Chevrolet Cruze is a compact car with the following body dimensions: length 4666 mm, width 1807 mm, height 1460 mm, wheelbase 2700 mm, and a fuel tank capacity of 52 liters. The Chevrolet Cruze is equipped with a 1.5L naturally aspirated engine, producing a maximum horsepower of 114 hp and a maximum power output of 84 kW, with a maximum power speed of 6600 rpm. It is paired with a 6-speed manual transmission.
20
3
Share

Will the 16-inch wheels interfere with the rear drum brakes on the new Santana?

The 16-inch wheels on the new Santana do not interfere with the rear drum brakes. Below is the relevant information for the 2021 Santana model: 1. Model: The new Santana and the new Jetta share the same platform, so their body dimensions and wheelbase are highly similar, with some parts even completely overlapping. 2. Body dimensions: The 2021 Santana has a body length of 4282mm, a wheelbase of 2603mm, and a width of 1706mm. The new Jetta is 14mm longer than the new Santana, which is the biggest difference in body dimensions between the two models, though this difference is hardly noticeable from the side view.
19
0
Share

Can You Drive with a Faulty Camshaft Position Sensor?

You cannot drive with a faulty camshaft position sensor. Symptoms of a faulty sensor include: 1. Difficulty accelerating; 2. Ignition failure and unstable idling; 3. Persistent engine warning light; 4. Sudden engine stall during warm operation. The camshaft position sensor is a sensing device, also known as a synchronization signal sensor. Since it can identify when a cylinder's piston is about to reach top dead center, it is also referred to as a cylinder identification sensor. The working principle of the camshaft position sensor is: 1. Collecting the position signal of the camshaft and transmitting it to the ECU; 2. The ECU identifies the top dead center of cylinder 1's compression stroke to perform sequential fuel injection control, ignition timing control, and knock control.
4
4
Share

How to Adjust the Rearview Mirror of Baojun 730?

The adjustment method for the Baojun 730 rearview mirror is as follows: 1. Turn the electric adjustment knob on the driver's side door panel handle to the left or right to select the side of the rearview mirror to be adjusted; 2. Move the adjustment lever to adjust the angle. The Baojun 730 is a 5-door, 7-seat MPV with body dimensions of 4780mm in length, 1780mm in width, and 1740mm in height, with a wheelbase of 2750mm. The Baojun 730 is equipped with a 1.5T turbocharged engine, delivering a maximum power of 108kW and a maximum torque of 250Nm. It features a MacPherson strut independent front suspension and a torsion beam non-independent rear suspension.
16
3
Share

What Causes the Abnormal Noise from the Chassis After the Car Stops?

The reasons for abnormal noise from the chassis after the car stops are: 1. Corrosion or aging of the stabilizer bar bushings; 2. Damaged brake pads; 3. Malfunction in the connecting parts between the suspension and shock absorber; 4. Abnormal noise from the wheel bearings; 5. Deformation of the shock absorber spring; 6. Aging or wear of the shock absorber pressure bearings. Daily maintenance methods for the car chassis include: 1. Proper adjustment of the front wheel toe-in; 2. Good lubrication and proper adjustment of the wheel hub bearings; 3. Pay attention to changes in the front and rear axles and the frame; 4. Check for any damage to the leaf springs; 5. Proper adjustment of the brake clearance; 6. Monitor the working condition of the clutch.
18
2
Share

How to One-Touch Power Window Up for Honda Civic?

Honda Civic one-touch power window up method is: 1. Press and hold the lock button for 5 seconds without releasing to make all windows roll up simultaneously; 2. Release the button when you hear a click sound. Taking the 2019 Civic as an example, its body dimensions are: length 4658mm, width 1800mm, height 1416mm, wheelbase 2700mm, minimum ground clearance 105mm, and fuel tank capacity 47L. The 2019 Civic is equipped with a 1.0T turbocharged engine, with maximum power of 92kW and maximum torque of 173Nm, matched with a CVT continuously variable transmission. It uses MacPherson strut front suspension and multi-link independent rear suspension.
3
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.