Can You Pour Water on Hot Brake Pads?

What is the content of the Subject 3 theoretical test?

Subject 3 theoretical test mainly includes: safety and civilized driving operation requirements, safe driving knowledge under adverse weather and complex road conditions, emergency handling methods in critical situations such as tire blowouts, and knowledge of handling after traffic accidents. The following is a detailed introduction: 1. Carefully review the questions: Pay attention to the key words. 2. Answer order adjustment: The test questions are basically the same as those the students have done before, but don't choose the answer directly when you see familiar questions, as it is easy to make mistakes at this time. Although the questions are the same, the order of the answer options may be adjusted, so be very careful during the test. 3. Check carefully: The test time is very sufficient, so don't rush when answering the questions. Be sure to check repeatedly and confirm that there are no mistakes before proceeding to the next question. For multiple-choice questions, carefully read the options and filter them one by one to prevent omissions.

4

1

Share

Should You Tap the Brake When Driving Straight Through an Intersection in Subject Three?

When driving straight through an intersection in Subject Three, it is necessary to tap the brake. Here are the specific details: 1. Driving straight through an intersection: When approaching an intersection ahead, follow the traffic signals if present; if there are no signals, adhere to safety principles. In either case, it is essential to tap the brake in advance to slow down, then proceed when the light turns green or after confirming it is safe. 2. Turning left or right at an intersection: The gear requirements may vary by region, but before entering the turn, tapping the brake to reduce speed is always correct. 3. Passing through a crosswalk: Upon seeing a crosswalk ahead, regardless of whether there are pedestrians crossing, you must press the brake to slow down. 4. On flat roads with light traffic: If the speed is above 30 km/h and only a brief brake application is needed, lightly tap the brake pedal without pressing the clutch pedal.

3

5

Share

Can You Steer with One Hand in Subject Three?

Subject Three does not allow steering with one hand. Here are the specific details: 1. Regulation: While driving, except for necessary operations like shifting gears, both hands must not leave the steering wheel. The left and right hands should be placed at the "nine o'clock" and "three o'clock" positions on the steering wheel, respectively. 2. Reason: If the steering wheel is viewed as a clock face, the correct hand position is for the left hand to grip between nine and ten o'clock and the right hand between three and four o'clock. In the event of a collision, this posture is more conducive to supporting the body. If only four fingers are used to grip the steering wheel with the thumb extended and resting on it, when the wheel hits a rock or a high curb, the front wheel may suddenly turn to one side, causing the steering wheel to rotate rapidly, which could potentially break the thumb.

10

3

Share

Can You Start in Second Gear for Subject 3?

Subject 3 does not allow starting in second gear. Here are the details: 1. Introduction: Subject 3, also known as the Road Safety Driving Test, is part of the motor vehicle driver's license assessment. It is the abbreviation for the road driving skills and safe civilized driving knowledge test in the motor vehicle driver's examination. 2. Gear Selection: Turning: Use second gear, signal three seconds in advance, and try to keep second gear for less than 20 seconds. U-turn: Change to the opposite fast lane, accelerate, and shift to third gear. Pull over: Do not release the clutch, shift to first gear. Upshift indicators: 1st to 2nd (10 km/h); 2nd to 3rd (20 km/h); 3rd to 4th (30 km/h); 4th to 5th (40 km/h). Downshift indicators: 5th to 4th (30 km/h), 4th to 3rd (25 km/h), 3rd to 2nd (20 km/h), 2nd to 1st (10 km/h).

15

4

Share

Can I Apply the Brake to Slow Down When Pulling Over in Subject Three?

Yes, you can apply the brake to slow down when pulling over in Subject Three. Here are the details: 1. Reason: From a rule perspective, there is no prohibition against using the clutch to control speed, so using the clutch to regulate speed is acceptable. After the pull-over instruction is given, applying the brake counts as stopping, indicating that the examinee has completed the required action, hence the requirement to use the clutch for speed control. 2. Exam Tips: During the Subject Three test, try to avoid prolonged semi-clutch operation, as this can easily cause the engine to stall, leading to test failure. Especially when completing maneuvers like U-turns or pull-overs that require slow speeds, using first gear at idle speed is relatively safer than semi-clutch (semi-engagement). Pulling over is not difficult; it mainly depends on the individual's ability to judge the distance from the side line, and controlling speed with the brake is sufficient.

6

5

Share

What is the reason for failing to engage the gear twice consecutively in Subject Three?

Failing to engage the gear twice consecutively in Subject Three may be due to not releasing the hand immediately after shifting but instead pulling the gear again, thus being judged as failing to engage the gear twice consecutively. Below are the specific details: 1. Changing lanes: Before changing lanes, observe and assess the traffic flow behind, beside, and in the lane you intend to change to. After confirming safety, turn on the turn signal, and then check again through the rearview mirror to see if any vehicles are overtaking on both sides of the road. Ensure there is a safe distance allowed in the lane you are about to enter. Without hindering the normal flow of traffic in that lane, smoothly steer into the desired lane and then turn off the turn signal. 2. Gear introduction: Use first gear when pulling over to park. For turns: Use second gear, signal three seconds in advance, and try to keep second gear engaged for no more than 20 seconds. For U-turns: Shift to the opposite fast lane, accelerate, and shift to third gear. When pulling over to park: Do not release the clutch, shift to first gear.

12

4

Share

Can You Pour Water on Hot Brake Pads?

What is the content of the Subject 3 theoretical test?

Should You Tap the Brake When Driving Straight Through an Intersection in Subject Three?

Can You Steer with One Hand in Subject Three?

Can You Start in Second Gear for Subject 3?

Can I Apply the Brake to Slow Down When Pulling Over in Subject Three?

What is the reason for failing to engage the gear twice consecutively in Subject Three?

Is Skoda Produced by SAIC Volkswagen or FAW Volkswagen?

Which gear to use when pulling over in Subject 3?

How many points are deducted for temporary parking exceeding 30 cm in Subject 3?

How to Adjust the Carburetor Needle for Fuel Saving?