Can you park by the roadside white solid line?

2 Answers
LaHector
07/24/25 4:01pm
Roadside white solid lines may allow temporary parking in some areas, while in others they do not. If you wish to park, please use designated parking spaces. Central single or double solid lines on urban roads, lane division lines in intersection solid zones, and separation lines between motor vehicle lanes and non-motor vehicle lanes are important traffic markings designed to ensure that motor vehicles and non-motor vehicles stay in their respective lanes and promote safe driving. Traffic regulations explicitly prohibit motor vehicles from crossing single or double solid lines. The white solid line next to the curb is actually the boundary line of the vehicle lane, used to separate the vehicle lane from non-vehicle lanes or sidewalks. There is no direct correlation between the white solid line and whether parking is allowed. On roadsides with white solid lines, drivers must refer to other markings and signs to determine if parking is permitted.
Was this review help?
18
1
Share
MarcusDella
08/11/25 8:58am
I've been driving for over a decade and always avoid those solid white lines. When painted roadside, they're basically warning you not to park there. Last time I saw my neighbor park beside the white line at our community entrance for ten minutes - instant ticket with points deducted and fine imposed. Remember from driver's license materials: solid white lines at road edges indicate no parking or driving over the line, only dashed lines or P-marked zones allow parking. Get caught by traffic cameras during daytime or patrol officers at night - the fine's the least concern, what's scary is rear-end collisions when following vehicles can't see clearly. Better find proper parking spots or temporary stopping zones to avoid both trouble and danger.
Was this review help?
14
2
Share
Expand All
More Forum Discussions

What Are the Consequences of Not Cleaning the Throttle Body?

Not cleaning the throttle body can lead to increased fuel consumption, more carbon deposits, unstable idling or abnormal fluctuations in the vehicle, and over time, it may even prevent the vehicle from starting. If you experience unstable idling, difficulty starting the engine, or the engine starts but the vehicle doesn't move, accompanied by noticeable vibrations, it's time to clean the throttle body. The function of the throttle body: The throttle body is a controllable valve that regulates the air entering the engine, located between the air filter and the intake manifold. Its primary role is to adjust the amount of air entering the engine. The depth of pressing the accelerator pedal directly affects the throttle opening, so idle speed, power performance, etc., are all related to the cleanliness of the throttle body.
18
5
Share

Where is the cabin air filter located in the 2010 Sylphy?

The cabin air filter in the 2010 Sylphy is located behind the glove compartment on the passenger side. To replace it, you must remove the glove compartment by unscrewing the three screws at the bottom of the glove box. Functions of the cabin air filter: 1. Ensures the filter tightly fits the housing to prevent unfiltered air from entering the cabin; 2. Separates solid impurities such as dust, pollen, and abrasive particles from the air; 3. Adsorbs moisture, soot, ozone, odors, carbon oxides, SO2, CO2 in the air with strong and lasting adsorption capability; 4. Prevents car windows from fogging up, ensuring clear visibility and driving safety; 5. Provides fresh air to the cabin, preventing occupants from inhaling harmful gases and ensuring driving safety; 6. Effectively sterilizes and deodorizes.
9
4
Share

What are the tips for parallel parking in Subject 2?

Parallel parking tips are as follows: Start the car in low gear, and turn the steering wheel to the right when the driver aligns with the third reference point. When the car moves to the position where the front of the car is between the third and fourth reference points, quickly turn the steering wheel to the left to steer the car toward the left side of the road. When the front of the car approaches the left edge of the road, quickly turn the steering wheel back and stop immediately. Shift the car into reverse gear and back up. When the rear of the car approaches the right edge of the parking space (garage), quickly turn the steering wheel to the left to the maximum position. When both sides of the car body are parallel to the edge of the parking space (garage), quickly straighten the steering wheel and stop. Precautions: Maintain an upright sitting posture, which is crucial for accurately judging each reference point; when entering the parking area, park as close to the right side of the road as possible, but do not cross the yellow right edge line to avoid backing up too far and crossing the line. Subject 2 has a full score of 100 points, with evaluation criteria set for failing, deducting 20 points, deducting 10 points, and deducting 5 points. The test is passed if the following conditions are met: ① For applicants applying for large passenger vehicles, tractors, city buses, medium-sized passenger vehicles, or large trucks, a score of 90 or above is required; ② For applicants applying for other vehicle types, a score of 80 or above is required.
16
4
Share

How to Check the Oil Dipstick on a Volkswagen?

Volkswagen Sagitar oil dipstick checking method: Pull out the dipstick by gripping its top end (hand on top, dipstick hanging down). Typically, there are three marks on the dipstick—upper, middle, and lower—or sometimes just upper and lower marks. The lowest mark indicates the minimum oil level; the top mark indicates the maximum oil level; the middle mark represents the standard oil level. The oil level should not be below the minimum mark nor exceed the maximum mark—it should ideally be at the middle mark. The oil dipstick is a commonly used measuring tool to check the static oil level height, indicating whether the engine oil level is within the reasonable range (between the upper and lower limits). The oil dipstick is usually located next to the engine and has a distinctive feature—a pull ring. You can pull it out by firmly tugging the ring upwards.
3
1
Share

How to Deal with Water or Fog Inside a Car Camera?

First, use a dry cloth to clean the lens of the camera, then use a hair dryer to blow air at the camera. Remove the camera to dry it thoroughly, then apply sealant for reinforcement. Seek professional repair at a maintenance shop.
18
0
Share

How to Deal with Natural Peeling of Car Paint Clear Coat?

To handle the peeling of the car paint clear coat, first clean the scratched or peeling area with a cloth. Apply toothpaste gently to the peeling area, then use a cotton cloth with a bit of force to clean off the debris, followed by removing the toothpaste. Use paint repair liquid.
19
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.