···
Log in / Register

Can You Make a U-Turn Over Double Yellow Lines?

4 Answers
LaRyder
07/29/25 6:32am

Double yellow lines do not permit U-turns. Relevant information about double yellow lines is as follows: Violations involving double yellow lines: Double yellow lines must not be crossed, and overtaking or reversing over them is strictly prohibited. U-turns or turns are only permitted when the double yellow lines are broken or become dashed lines, provided that traffic signs allow it and it is safe to do so. Making a U-turn over solid double yellow lines constitutes a violation of crossing the line, which may result in a fine and a deduction of 3 points from the driver's license. Composition of double yellow lines: If one of the double yellow lines is solid and the other is dashed, vehicles on the side with the dashed line may temporarily cross it for maneuvers such as overtaking or turning. Double yellow lines consist of two parallel solid yellow lines, typically painted in the center of roads without a central divider to separate opposing lanes of traffic, serving as boundary markers for vehicle lanes. Neither double yellow lines nor single yellow lines should be crossed arbitrarily. Single solid lines are used for the center of two-way roads, while double solid yellow lines are used for roads with four or more lanes.

Was this review help?
3
0
Share
EvangelineLynn
08/12/25 10:12pm

I used to drive large trucks for transportation, and my experience tells me that you must never make a U-turn over double yellow lines. According to traffic rules, double yellow lines are strictly prohibited center dividing lines, meaning you cannot cross them to overtake or make a U-turn, as it can easily lead to severe collisions with oncoming traffic. I’ve encountered some novice drivers who tried to do this for convenience, only to end up in rear-end accidents or being fined by traffic police. This is especially dangerous on highways or busy urban roads due to high speeds and limited visibility. Remember, when both sides of the double yellow lines are solid, it’s absolutely forbidden—this design is meant to reduce traffic accidents. If there’s a dashed section, it might allow turns in specific directions, but not random U-turns. Safety first; following the rules protects you and others. After driving for a long time, I’ve developed the habit of slowing down and observing whenever I see double yellow lines—never take the risk.

Was this review help?
2
2
Share
Expand All
DeGabriel
10/04/25 3:34am

I just got my driver's license recently, and I learned this during driving school: you usually can't make a U-turn over double yellow lines. The instructor said double yellow lines represent a no-go zone, like a wall separating lanes. Making a U-turn there would be equivalent to illegally crossing, which is very risky. At first, I didn't understand, but later when I tried to make a U-turn on a suburban road, I almost got hit by a truck and broke out in a cold sweat. Traffic regulations clearly state that when double yellow lines are solid, crossing them is strictly prohibited, including making U-turns. In daily driving, if you really need to turn, you should find an appropriate intersection or a section with dashed lines near traffic lights. This rule is for public safety, to avoid chaos and accidents. I suggest that new drivers review traffic regulations more often, especially the meanings of road markings, and not be as reckless as I was. Develop good habits by starting with simple rules.

Was this review help?
4
4
Share
Expand All
DiKaylee
11/17/25 5:09am

I usually follow a lot of automotive news and know that the double yellow line rule is quite simple: generally, U-turns are not allowed unless there is a dashed line indicating permission. Double yellow lines are set up to divide lanes and prevent crossing into oncoming traffic, which could lead to collisions. They are commonly seen on urban streets, and violating the rule may result in penalty points and fines—news reports suggest the fines can be quite hefty. From a safety perspective, even when traffic is light at night, it's not advisable to take the risk. Some sections, like intersections, might have exceptions, such as dashed lines indicating a dedicated turn lane, but those are special cases, not the norm. In short, always drive cautiously, stay aware of road conditions, and protect yourself and others.

Was this review help?
4
0
Share
Expand All
More Forum Discussions

Is it necessary to use gasoline water remover?

Gasoline water remover is generally not necessary, but it is required when using ethanol-blended gasoline. Here are some key points about water removers: 1. Principle of water remover: Water removers are mainly used when switching from regular gasoline to ethanol-blended gasoline. This is because some free water inevitably exists in the fuel tank, and when the air in the tank cools, the moisture condenses into water and settles at the bottom of the tank. 2. Usage scenarios: Ethanol-blended gasoline is prone to phase separation when it contains a high water content, which can cause the vehicle to stall or fail to start. Therefore, a water remover is needed when using ethanol-blended gasoline to eliminate water.
12
0
Share

What does it mean when the cruise light is on in a car?

The cruise light being on in a car indicates that the cruise control system is active. In this state, the computer continuously adjusts the fuel supply based on road conditions and the vehicle's driving resistance to maintain the set speed without the need to operate the throttle, reducing driver fatigue and unnecessary speed variations. The cruise control system is an electronic device that uses advanced electronic technology to automatically regulate the vehicle's speed, allowing it to maintain a preset speed. When driving on highways for extended periods, activating the system's automatic control switch enables the cruise control system to automatically increase or decrease the throttle opening based on driving resistance.
4
1
Share

What does the 'Pro' version of a car mean?

In the context of automobiles, 'Pro' signifies a high-end or premium configuration, indicating a more professional and higher-tier positioning. Below is more information about 'Pro': 1. Introduction to 'Pro': The term 'Pro' originally appeared in electronic products as an abbreviation of the English word 'professional,' denoting a more specialized and high-end performance in certain aspects. 2. Meaning of 'Pro': Adding 'Pro' to a car's name carries the same implication, representing a more advanced product. Simultaneously, the value of the car is elevated to a higher level.
20
5
Share

Can Car Body Film Be Applied on Rainy Days?

Car body film can be applied on rainy days. Overcast days and post-rain conditions with higher air humidity reduce static electricity, and indoor/outdoor dust is significantly diminished, making it more suitable for film application. During the process, first spray clean water on the inner side of the cleaned glass, then remove the protective film from the car film and spray water on the adhesive surface. The car film can then be applied to the glass, followed by using a plastic squeegee to eliminate bubbles and excess moisture. Generally, glass cleaning involves three steps: glass inspection, adhesive particle removal, and dust cleaning. Take care to prevent water from entering the car's audio or electronic control systems during cleaning. When cleaning the rear windshield before film application, be cautious to protect the heating wires.
14
0
Share

Can Car Wash Shops Inflate Tires?

Car wash shops can inflate tires. Here are the precautions for tire inflation and tire maintenance methods: Precautions for tire inflation: Pay attention to safety when inflating, and always check the pressure with a pressure gauge; After stopping driving, wait for the tire to cool down before inflating; Pay attention to cleanliness when inflating. The air being filled should not contain moisture or oil to prevent deterioration and damage to the inner tube rubber; Regularly calibrate the onboard pressure gauge to ensure accurate pressure checks. Methods for car tire maintenance: Cool down before inflating; Pay attention to cleanliness when inflating; Pay attention to safety when inflating; Check the valve; Check for leaks, etc.
11
1
Share

What Causes the Car Key Light to Flash?

The reasons for the car key light flashing include a malfunction in the key's transmission module or the remote key being out of control range. Specific causes and solutions are as follows: Malfunction in the key's transmission module: If the car key light on the dashboard is flashing, it means the car cannot detect the key, which may be due to a malfunction in the key's transmission module. The solution is to have the key repaired. Remote key out of control range: The car key light flashing usually occurs when the remote key leaves the control range while the vehicle is not turned off or fully powered down, such as being more than 0.8 meters away from the car. In this case, the vehicle's anti-theft system activates, which is a normal phenomenon.
4
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.