Can You Drive Without the Key After OnStar Remote Start?

1 Answers
StLeonardo
07/29/25 7:06am
You cannot drive without the key after OnStar remote start. Below is an introduction to the relevant content: Key Recognition: After remotely starting the vehicle using the mobile app, the car needs to recognize the key to confirm the owner. If the key is not recognized, the vehicle cannot be started. Remote Start: Some vehicles are set up so that when the owner uses remote start, the doors cannot be opened remotely and can only be unlocked with the car key. If the car door is opened in advance, the remote start function cannot be used to prevent unauthorized driving by non-owners.
Was this review help?
14
2
Share
More Forum Discussions

How to reset the maintenance light on a Qingling?

Method to reset the maintenance light on a Qingling: Turn off the ignition switch, press and hold the mileage reset button, keep it pressed, turn the key to the position where all dashboard lights are on. At this point, you can see the mileage on the dashboard changing. When the mileage stops changing, release the mileage reset button, turn off the ignition switch, and then turn it back on to complete the maintenance reset. The new Qingling Isuzu TF pickup, judging from its overall contour, differs from the current rounded and full-bodied pickup products, maintaining a more square design. The body dimensions are 5524mm in length, 1690mm in width, 1675mm in height, and the wheelbase is 3379mm.
8
4
Share

How to Turn Off the Car Interior Light?

The switch for the car's interior lighting is generally located above the middle area between the driver's seat and the front passenger seat. The interior light switch has several modes that can be toggled. To turn off the interior light, simply switch it to the off mode.
19
4
Share

How to use the rain-sensing wipers on the Volkswagen Tayron?

Usage of the rain-sensing wipers on the Volkswagen Tayron: 1. Pull the lever towards the driver to spray windshield washer fluid onto the windshield with the front wipers; 2. Push the lever towards the front of the vehicle to activate the rear wiper. If pushed all the way and held, the rear wiper will spray water; 3. The default position is AUTO, where the wipers automatically activate when the vehicle detects increased rainfall. The adjustment button on the right controls the sensitivity of the rain sensor; 4. The higher the wiper switch is lifted, the faster the frequency. LOW is the low-speed setting, and HIGH is the high-speed setting; 5. The OFF position turns the wipers off. Turn the switch to this position when not using the wipers; 6. The 1X position: The wipers sweep once, and the lever automatically returns. The Volkswagen Tayron is a premium German mid-size SUV with body dimensions of 4595mm in length, 1860mm in width, and 1660mm in height.
8
5
Share

How to Install a Roof Rack?

First, secure the crossbars onto the roof rails, then mount the entire roof rack onto the crossbars (for detailed instructions, refer to the roof rack's manual). A prerequisite for installing a roof rack is that the vehicle must come with pre-installed roof rails designated for rack installation; otherwise, installation is not possible.
6
5
Share

How to Replace the Battery in a Mercedes-Benz GLB Key?

First, flip open the tab at the rear end of the key to remove the mechanical key. Insert the mechanical key into the slot at the tab position, apply slight force, and the back cover will open. Then, take out the depleted old battery, replace it with a new one, close the back cover, and the key battery replacement is complete.
4
4
Share

How to Turn on Bluetooth for the Car Radio?

First, confirm whether the car radio supports Bluetooth functionality, then turn on the Bluetooth on both your phone and the car radio. Search for the car radio device from your phone and click to connect. Once successfully connected, you can start using it.
1
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.