Can You Drive in a Vest?

2 Answers
AllisonRose
08/29/25 5:05am
Driving in a vest is allowed, as there are no specific regulations in traffic laws regarding attire while driving. Below are relevant details: Prohibited Situations: After the implementation of the "Road Traffic Safety Law," there are specific provisions against driving in slippers: behaviors such as wearing slippers, high heels with heels over 4 cm, driving barefoot, or holding a phone while talking, which may hinder safe driving, are prohibited. Drivers violating these rules will be penalized with a 2-point deduction and a fine. Regulations to Follow While Driving: Smoking, eating, chatting, or engaging in any other behavior that may interfere with safe driving is not allowed. Driving is prohibited if the doors or compartments are not properly closed. It is also forbidden to hand over the vehicle to someone without a driver's license.
Was this review help?
7
0
Share
KarterAnn
09/11/25 2:52am
Driving in a vest is theoretically fine—I'm just an average commuter who drives daily—but I'm more concerned about seatbelt fit. Vests are thin and breezy for summer comfort, yet the shoulder strap rubbing directly against skin may slip or cause discomfort during sudden braking. With over a decade of driving experience, including a few close calls, I’ve found T-shirts or light shirts help seatbelts stay securely positioned. Safety comes first; a slipping strap could delay reaction time. Adjusting the AC solves summer heat without compromising protection. This matters especially on long drives—choose clothing that avoids distractions.
Was this review help?
20
3
Share
Expand All
More Forum Discussions

What are the reasons for the high fuel consumption of the classic Focus?

The reason for the high fuel consumption of the classic Focus is that it is equipped with a 1.8L naturally aspirated engine. The higher the power, the higher the engine speed naturally, and the higher the maximum speed of the car, which also increases fuel consumption. The following is a detailed introduction about the car's fuel consumption per 100 kilometers: 1. Overview: The fuel consumption per 100 kilometers refers to the fuel consumption of a vehicle traveling 100 kilometers on the road at a certain speed. It is a theoretical indicator of the vehicle. The fuel consumption per 100 kilometers is the value measured by the manufacturer in an objective environment using a dynamometer installed on the vehicle's chassis, converted into speed parameters, and then calculated at a specified speed to obtain the theoretical experimental fuel consumption data per 100 kilometers for the model. 2. Others: Since most vehicles approach their economical speed at 90 km/h, the theoretical fuel consumption published by most manufacturers is usually the fuel consumption per 100 kilometers at 90 km/h.
4
4
Share

What is the ground clearance of the Cadillac XT6?

The ground clearance of the Cadillac XT6-2022 model is 133 millimeters. The ground clearance of the Cadillac XT6-2022 model refers to the distance between the lowest point (excluding the wheels) and the supporting plane, which is used to indicate the vehicle's ability to pass over obstacles such as rocks and tree stumps without collision. If the ground clearance of the Cadillac XT6-2022 model is higher, its off-road capability improves. However, if the ground clearance is too high, the stability at high speeds may decrease. The new American large SUV—Cadillac XT6—offers a total of 5 models, with 5 body colors and 4 interior color options. The dimensions of the Cadillac XT6-2022 model are 5056 mm in length, 1964 mm in width, 1780 mm in height, and a wheelbase of 2863 mm. Generally, the ground clearance of sedans ranges between 110 mm and 150 mm, while SUVs have a ground clearance between 200 mm and 250 mm. However, the ground clearance of the Cadillac XT6-2022 model is not static; it also depends on the load condition. Therefore, changes in ground clearance should be considered based on the load variations of the Cadillac XT6-2022 model. When selecting a vehicle, ground clearance can be one of the reference factors. The choice should depend on the vehicle's intended use and the road conditions. For urban areas with well-paved roads, a vehicle with lower ground clearance can enhance stability and comfort. For long-distance travel or driving in areas with poor road conditions, considering off-road performance, a vehicle with higher ground clearance may be preferred to avoid scraping or damaging the chassis.
7
1
Share

What does the exclamation mark in Cadillac's reversing camera mean?

There are five scenarios when an exclamation mark appears on the car dashboard, namely general faults, automatic transmission faults, braking system faults, abnormal tire pressure, and lighting faults. The following is a detailed analysis of these five scenarios: General faults: An exclamation mark inside a triangle. If this symbol lights up, it indicates a fault in the general performance or components and functions of the car. Mainly includes parking sensor faults, fuel cut-off system intervention or faults, external light faults, engine oil pressure sensor faults, etc. It is necessary to go to a 4S shop for inspection to identify the source of the fault. Automatic transmission faults: A yellow gear with an exclamation mark inside. This is the automatic transmission fault warning light, indicating that there is a fault in the transmission or the transmission lubricating oil is below the normal range. The transmission oil needs to be replaced in time. Braking system faults: An exclamation mark in the middle of a circle with brackets. This represents a warning of the braking system, mainly including faults in the braking system and low brake fluid level. It is necessary to immediately inspect the braking system to avoid accidents. Abnormal tire pressure: An exclamation mark in the middle of a horizontal line under brackets. This represents the tire pressure monitoring warning light. When the tire pressure of the car is too low, this warning light will light up. It is necessary to check the tire pressure of the car and restore the tire pressure to the normal range. Lighting faults: A yellow bulb with an exclamation mark. This is the lighting fault indicator light, indicating that there is a fault in the car lights. Solution: Go to a 4S shop for inspection and treatment as soon as possible, or you can also check it yourself, focusing on commonly used bulbs such as turn signals, fog lights, and interior lighting, to see where the problem is.
2
4
Share

What Are the Reasons for the Failure of the Camry Remote Key?

The reason for the failure of the Camry remote key may be due to long-term use leading to key malfunction. Below is a detailed introduction about the Camry: 1. Overview: The Camry is a model under GAC Toyota. Its main advantages are its elegant appearance, fewer minor issues, and relatively good fuel efficiency. The main disadvantage is its subpar handling. 2. Others: The eighth-generation Camry features dual design styles—Luxury and Sport—both inspired by Toyota's latest "Keen Look" design language. It is equipped with Toyota's latest Toyota Safety Sense, including the PCS pre-collision safety system, LDA lane departure alert system, and more.
13
5
Share

What grade of gasoline should the Land Cruiser V6 use?

Toyota Land Cruiser can use 93-octane gasoline, but it is not recommended; 97-octane gasoline should be used instead. Below is a detailed introduction about engine oil: 1. Overview: Engine oil, also known as engine lubricant, is called Engine-oil in English. Its density is approximately 0.91×10³ (kg/m³). It serves to lubricate and reduce friction, assist in cooling, seal against leaks, prevent rust and corrosion, and provide shock absorption for the engine. 2. Composition: Engine oil consists of two parts: base oil and additives. The base oil is the main component of lubricating oil, determining its fundamental properties. Additives can compensate for and improve the deficiencies in the base oil's performance, granting it new properties, making them an important part of lubricating oil.
14
1
Share

What is the significance of the engine cooling system?

The significance of the engine cooling system is to keep the engine within an appropriate temperature range under all operating conditions. The functions of the cooling system: The cooling system must prevent the engine from overheating as well as from becoming too cold in winter. Introduction to the importance of the engine cooling system: The car cooling system is crucial to the vehicle. The engine is like the human heart; if not properly protected, it can be threatened. With the advancement of technology, the cooling system is no longer just a simple water-cooling cycle as in the past. Nowadays, intelligent control of the cooling system is highly favored. Therefore, in the future development of automobiles, simple cooling systems will not dominate.
20
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.