Can Vehicle Inspections Be Conducted During the Mid-Autumn Festival?

1 Answers
Juniper
07/29/25 12:49pm
Vehicle inspections cannot be conducted during the Mid-Autumn Festival. Below is the relevant information: Annual Inspection: The vehicle annual inspection process refers to the fixed procedure that motor vehicles must undergo each year for inspection. It is a mandatory test for every vehicle, equivalent to a physical examination for the vehicle, aimed at promptly eliminating potential safety hazards and reducing the occurrence of traffic accidents, commonly referred to as vehicle inspection. Inspection Schedule: For passenger vehicles used for commercial purposes, inspections are required once a year within the first 5 years; after 5 years, once every 6 months. For trucks and large or medium-sized non-commercial passenger vehicles, inspections are required once a year within the first 10 years; after 10 years, once every 6 months. For small and mini non-commercial passenger vehicles, inspections are required once every 2 years within the first 6 years; after 6 years, once a year; after 15 years, once every 6 months.
Was this review help?
10
0
Share
More Forum Discussions

What Causes the Tire Pressure Light to Illuminate?

The reasons for the tire pressure light illuminating are: 1. A tire puncture caused by a nail; 2. Excessive tire pressure; 3. Driving with low tire pressure for an extended period; 4. Malfunction of the tire pressure sensor; 5. Prolonged lack of air leading to low tire pressure. The tire pressure warning light is designed to indicate the tire pressure status of the vehicle. Under normal circumstances, this indicator remains off. The methods to address the illuminated tire pressure warning light are: 1. Pull over safely, exit the vehicle, and inspect the tire pressure of all four tires. If no obvious loss of pressure is visible, reset the tire pressure system after getting back in the vehicle to turn off the warning light; 2. If the tire pressure warning light comes on again, it indicates an issue with the tire pressure of a specific tire, requiring prompt inspection and repair.
15
4
Share

Can You Press the Clutch in an S-Turn?

You can press the clutch in an S-turn. The driving force of the car gradually increases, allowing the car to start smoothly, facilitating gear shifting, preventing overload of the transmission system, and reducing torsional vibration impact. Below is relevant information about pressing the clutch in an S-turn: Techniques for S-Turns in Subject 2: Use the rearview mirror as a reference. During driving, maintain a certain distance from the S-turn boundary line based on the relative distance between the rearview mirror and the line, adjusting according to your actual situation. Alternatively, you can use the outermost edge of the car's hood visible in your line of sight as a reference. Depending on individual perspectives, choose a suitable position for yourself. During driving, the curve of the S-turn should stay near your chosen reference point. If the reference point is not the middle of the hood, you need to change the reference point according to the curve's direction—look at the right side of the hood for left turns and the left side for right turns. No adjustment is needed if the reference point is the middle. Clutch Working Principle: The driving and driven parts of the clutch transmit torque through friction between contact surfaces, using liquid as a transmission medium, or magnetic transmission. This allows temporary separation and gradual engagement between the two parts, permitting mutual rotation during transmission. Clutch Function: There is a sliding friction phenomenon between the driving and driven parts of the clutch, enabling the torque transmitted by the clutch to gradually increase from zero. This results in a gradual increase in the car's driving force, ensuring a smooth start, facilitating gear shifting, preventing transmission system overload, and reducing torsional vibration impact.
11
3
Share

What does 'No Tag Displayed' on ETC mean?

ETC displaying 'Tag Removed' indicates that the device is currently unavailable and needs to be reinstalled and reactivated at the original processing point or any highway ETC service center. The ETC installation process is as follows: Upon receiving the device, first check if the ETC card and electronic tag (OBU) are damaged. Press the anti-tamper button on the back of the OBU. A red light will briefly illuminate, and the OLED screen will display 'Tag Invalid' or 'Please Insert Card,' indicating the device is functioning normally. Clean the front windshield, ensuring the glass surface is smooth, clean, and dry. Then, peel off the adhesive backing of the OBU and stick it to the installation location. Press firmly for 2-3 minutes to remove any air bubbles. Insert the ETC card with the front side facing the driver and the back side facing the windshield, ensuring the chip is inserted into the OBU device. ETC activation method: Insert and remove the ETC card twice consecutively until the electronic tag screen displays 'Bluetooth On.' If 'Tag Invalid' appears when inserting and removing the card twice without the electronic tag attached, this is normal and does not affect activation. Alternatively, press the button on the top of the electronic tag to enable Bluetooth directly. Turn on your phone's Bluetooth and open the corresponding mobile app (usually a download QR code is provided on the electronic tag), then enter the device activation interface. Click 'Device Connection' and wait patiently for the 'Connection Successful' prompt. Once connected, upload a photo of the vehicle's front to complete activation.
11
1
Share

How to Open the Fuel Tank Cap of a Sedan?

There are several methods to open the fuel tank cap of a sedan: 1. Use a mechanical key to twist it open; 2. Press the fuel tank cap switch inside the car; 3. Press the fuel tank cap to open it. The fuel tank of a sedan is a container made of stainless steel, designed to store gasoline, featuring good sealing. It consists of a fuel filler pipe, tank body, fuel tank cap, fuel gauge, and fuel pump. Notes on refueling: 1. Refuel in the morning or evening when the temperature is relatively low, as gasoline of the same volume can have a higher mass; 2. Avoid filling the tank completely when driving in the city, as it increases the engine's load; 3. Do not wait until the tank is empty to refuel, as insufficient fuel not covering the fuel pump can shorten its lifespan; 4. Avoid refueling during thunderstorms, as the fuel nozzle might introduce stray currents into the fuel tank, exacerbating the movement of unstable gasoline molecules and posing fire and explosion hazards.
10
1
Share

What is the Volkswagen Touran?

Volkswagen Touran is the Volkswagen Touran MPV, which is positioned as an MPV model but is actually a crossover vehicle, combining the comfort of a sedan with the versatility of an MPV. Taking the 2021 Volkswagen Touran as an example, its body dimensions are: length 4527mm, width 1829mm, height 1659mm, with a wheelbase of 2791mm and a curb weight of 1515kg. The 2021 Volkswagen Touran features a MacPherson strut front suspension and a four-link independent rear suspension. It is equipped with a 1.4T turbocharged engine, delivering a maximum horsepower of 150PS, a maximum torque of 250Nm, and a maximum power of 110kW, paired with a 7-speed dual-clutch transmission.
2
1
Share

What are the reasons for a car not starting and making a clicking sound?

The reasons for a car not starting and making a clicking sound are: 1. The car battery is low on power; 2. Low temperature reduces the viscosity and rotation speed of the car oil; 3. Issues with the ignition system; 4. Insufficient fuel in the car; 5. Excessive carbon deposits inside the vehicle engine; 6. Damaged fuel pump, preventing fuel from the fuel tank from being supplied for combustion. The solutions for a car not starting and making a clicking sound are: 1. Check if the battery is low on power and charge it; 2. Repair or replace a damaged fuel pump promptly; 3. Check if the fuel level is sufficient and add enough fuel; 4. Inspect whether the engine sensors are damaged; 5. Replace spark plugs and ignition coils; 6. Use a heating rod to warm up the oil.
13
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.