Can the turn signal be directly reattached if it falls off during Subject 3?

1 Answers
VonGage
09/08/25 7:37am
If the turn signal falls off during Subject 3, it can be directly reattached; otherwise, 10 points will be deducted. Below is relevant information: Introduction: Subject 3, which includes the road driving skills test and the safety and civilized driving knowledge test, is part of the motor vehicle driver's license assessment. It is the abbreviated name for the road driving skills and safety and civilized driving knowledge test subjects in the motor vehicle driver's examination. The content of the road driving skills test varies for different types of vehicles eligible for driving. Test Content: The road driving skills test for Subject 3 generally includes: preparation before getting on the vehicle, simulated lighting test, starting, driving straight, shifting gears, changing lanes, pulling over, going straight through intersections, turning left at intersections, turning right at intersections, passing pedestrian crossings, passing school zones, passing bus stops, meeting oncoming vehicles, overtaking, making U-turns, and nighttime driving.
Was this review help?
11
4
Share
More Forum Discussions

What are the methods to deal with excessive carbon monoxide in car exhaust?

Clean the three-way catalytic converter. Once this component is clogged or too dirty, it will lose its ability to convert carbon monoxide. Check the dashboard for any engine warning lights. If the air-fuel ratio of the engine cannot stabilize, incomplete combustion may occur.
8
1
Share

What to Do When the Battery is Undercharged and Won't Charge?

Check if the fuse has poor contact and reconnect it. Replace the wiring. If the battery has been used for a long time, the electrolyte may decrease, and it needs to be refilled. Replace the battery.
1
3
Share

How to Shift to Neutral in an Automatic Transmission Without Starting the Engine?

Turn on the power without starting the engine. Press the brake pedal and shift the gear. First shift to N (Neutral) gear, then start the engine, and then shift to D (Drive) gear. Release the parking brake. Lift your foot off the brake pedal and start driving.
17
0
Share

What is the simplest way to reset a car's ECU?

Drive for a while to allow the car to reach normal operating temperature, then park and turn off the engine, shutting down all electrical devices in the car. Open the car's hood, locate the battery, and disconnect the battery's power cables. Wait for 10 minutes before reconnecting, then turn on the power without starting the engine and activate the car's electrical devices, waiting for 30 seconds. Remove the key, and the reset is successful.
12
5
Share

What are the starting and parking procedures for the Volvo XC40?

Make preparations before starting the car. Press the start button to start the engine while holding down the foot brake. Shift the gear to D (Drive), gently release the foot brake to move forward, and press the accelerator pedal if acceleration is needed. Press the foot brake to stop the car. Shift to P (Park) and turn off the engine.
5
3
Share

What is the voltage of the ABS sensor connector?

The voltage of the ABS sensor connector is 5V to 8V, with an output voltage of 650mV to 850mV. During actual measurement, due to the fault protection function of the electronic stability control module, the voltage cannot be sustained after unplugging the ABS sensor connector, so voltage data cannot be used as a judgment criterion. The ABS sensor is an important component of the ABS system. ABS can maintain the directional stability of the vehicle during braking while driving, shorten the braking time and distance, and effectively prevent wheel lock-up and uncontrolled skidding during emergency braking, thereby enhancing the vehicle's controllability and making driving safer.
18
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.