Can the Rear Door Top of Baojun 310 Be Replaced?

What does fuel consumption of 10 liters mean?

Fuel consumption of 10 liters means: The amount of fuel required for a car to travel 100 kilometers is 10 liters. "Fuel consumption per 100 kilometers" can serve as a standard for measuring a vehicle's fuel economy. "Fuel consumption per 100 kilometers" is also affected by various factors such as vehicle condition, road conditions, and driving habits. Methods to reduce fuel consumption per 100 kilometers include: 1. Ensure proper tire pressure. Regularly check tire pressure to avoid underinflation or overinflation. 2. Maintain consistent speed and gear to prevent incomplete combustion in the engine. 3. Develop good driving habits and avoid rapid acceleration by stomping on the gas pedal. 4. Warm up the car moderately. Prolonged idling to warm up the engine increases fuel consumption. Instead, warm up the car by driving slowly for about one kilometer.

12

3

Share

What is the real fuel consumption of the Volkswagen Tharu 1.4T?

According to statistics from actual owner usage, the real fuel consumption range of the Tharu 1.4T is 6.98~9.12L/100km, with an average consumption of 8.04L/100km. For the Tharu 2.0T, the real fuel consumption range is 8.02~10.73L/100km, with an average consumption of 9.37L/100km. Overall, the Tharu's fuel efficiency performance is quite good. Below is an introduction to the Tharu: 1. In terms of space, the dimensions are 4453/1841/1632mm (length/width/height), with a wheelbase of 2680mm and an unladen ground clearance of 182mm. 2. In terms of power, the Tharu is equipped with 1.4T and 2.0T turbocharged engines, with maximum power outputs of 110kW and 137kW respectively, and peak torques of 175Nm, 250Nm, and 320Nm.

8

0

Share

Can You Continue Driving When the Vehicle's Coolant Temperature is Too High on the Dashboard?

You should not continue driving when the vehicle's coolant temperature is too high on the dashboard. Continuing to drive can easily lead to increased mechanical wear of the engine, overheating and aging of the wiring, and even smoke or spontaneous combustion in the engine compartment. If there is a fault in the cooling system, it can easily cause the coolant to boil, and excessive internal pressure may result in the radiator cracking or pipes bursting. The following are the steps to handle excessive coolant temperature: 1. When the coolant temperature light turns red, you should pull over and stop driving as soon as possible to check the vehicle's condition. 2. Do not rush to open the radiator cap. Check if the cooling fan is running and look for signs of blockage or damage to the radiator. 3. After the vehicle's coolant temperature has decreased, open the radiator cap to release pressure. If you find the coolant level is low, you can add new coolant or distilled water as an emergency measure.

1

2

Share

What does ECO mean in the Highlander?

ECO in the Highlander refers to the vehicle's economic driving mode. ECO is an English abbreviation derived from the combination of Ecology (environmental protection), Conservation (energy saving), and Optimization (power). The Eco mode is further divided into active Eco driving mode and non-active Eco driving mode. When the ECO indicator light on the dashboard illuminates, it indicates that the vehicle's economic mode has been activated. ECO mode is categorized into active and non-active types. The difference lies in the fact that the active type has its own dedicated button, allowing the driver to choose whether to activate it. When the driver presses the ECO mode switch, the dashboard indicator light immediately turns on, and the vehicle automatically begins adjusting settings such as throttle opening, transmission shift logic, and air conditioning output power. The non-active ECO mode does not have a dedicated button. When the ECO indicator light on the dashboard illuminates, it merely serves as a reminder function. The ECO system automatically evaluates your driving behavior. If your current driving operation achieves the optimal fuel supply, the dashboard will simultaneously display the ECO indicator light. Most vehicles employ the active ECO driving mode, meaning they have their own switch button. In daily driving, we can generally activate the ECO mode. However, it is unnecessary to enable ECO mode when driving at speeds exceeding 120 km/h, during idle parking, in N/P gear, or in manual mode, especially when climbing hills. Doing so would not only fail to demonstrate the fuel-saving characteristics of ECO but also impact the vehicle's power performance. Additionally, the ECO mode typically becomes ineffective under the following circumstances: When the vehicle speed exceeds 120 kilometers per hour, the system prioritizes speed, causing the ECO mode to automatically deactivate. During idle parking or when in N/P gear or manual mode, the ECO mode may also become ineffective. When high torque output is required, such as when climbing a hill, the engine control unit prioritizes ensuring sufficient power to drive the vehicle, and the ECO mode will not function in such scenarios.

11

3

Share

What does it mean when the electronic power steering warning light comes on?

When the yellow "EPS" warning light or "steering wheel" shaped warning light illuminates on the dashboard, the following symptoms may occur: heavy steering, abnormal steering noise, steering wheel vibration, and poor steering wheel return capability. Possible causes of electronic power steering system failure include: 1. Excessive air in the power steering system. 2. Foreign objects in the hydraulic lines causing steering pump flow blockage. 3. Loose steering connections leading to steering fluid leakage. Below is relevant information about this component: On the steering shaft there is a hub with grooves that rotates when turning the steering wheel. There are four equally spaced grooves around the hub. When the turn signal is activated, a plastic lever on the turn signal switch gets pushed into the path of these grooves. As the hub continues rotating clockwise, these grooves strike the plastic lever, causing it to oscillate and allowing each groove to pass. When the steering wheel returns left, the hub rotates counterclockwise, pushing the plastic lever in the opposite direction. This forces the spring-loaded roller out of the switch housing's groove, causing the turn signal lever to snap back to its central position.

16

5

Share

Where is the AC switch for the 2005 Audi A6?

2005 Audi A6's AC switch is located on the central control air conditioning panel. Press the auto switch once and lower the temperature to turn on the air conditioning. The Audi A6 is a luxury car produced by Audi, available in both sedan and station wagon models. The Audi A6 incorporates Audi's high-tech proprietary technologies, further enriches its luxurious configurations, and is endowed with strong sporty characteristics. Its features include luxury, dynamism, and sophistication. Below is an introduction to the 2005 Audi A6: 1. The dimensions of the 2005 Audi A6 2.4AT model are 4796mm in length, 1810mm in width, and 1453mm in height, with a wheelbase of 2850mm. 2. The 2005 Audi A6 2.4AT uses a multi-link independent suspension for the front and a double-wishbone independent suspension for the rear, with mechanical hydraulic power steering and tire specifications of 215/55R16.

3

4

Share

Can the Rear Door Top of Baojun 310 Be Replaced?

What does fuel consumption of 10 liters mean?

What is the real fuel consumption of the Volkswagen Tharu 1.4T?

Can You Continue Driving When the Vehicle's Coolant Temperature is Too High on the Dashboard?

What does ECO mean in the Highlander?

What does it mean when the electronic power steering warning light comes on?

Where is the AC switch for the 2005 Audi A6?

Can a car be equipped with a reverse camera?

Which cars have gear shifts on the steering wheel?

How to Use the Manual Mode in a Semi-Automatic Transmission Car?

How Long Does It Take to Learn Parallel Parking?