Can the plug of a dash cam be replaced?

What to Do If the Vehicle Stalls Suddenly While Driving?

If the car stalls suddenly while driving, depending on the road conditions at that time and if there is no emergency, you can slowly apply the brakes to prevent a rear-end collision. After the speed decreases, steer slowly to move the car to the roadside lane. Once parked at the roadside, turn on the hazard lights, set up the warning triangle, and call for a tow truck. Common causes of stalling are as follows: 1. Stalling due to carbon deposits: Especially at the electronic throttle, this is an intake system fault. When there is excessive carbon buildup at the throttle, releasing the accelerator while driving may cause the engine to stall, which often occurs in very old cars. However, this can be prevented. Normally, you may notice difficulty starting the engine, or even needing to press the accelerator to start it—these are signs of excessive carbon deposits at the throttle, which require timely cleaning. 2. Fuel supply failure: Usually caused by a damaged fuel pump, which cannot pump fuel. The fuel pump has a long lifespan, so damage typically occurs in older cars. Some fuel pumps fail while the car is parked, making it impossible to start, while others fail during driving. 3. Power supply failure: Usually caused by a damaged ignition coil, resulting in no high-voltage electricity to all spark plugs.

19

1

Share

Does Installing a Spoiler Increase Drag?

Installing a spoiler does increase the drag of a car. A car spoiler refers to the protrusion installed along the upper edge of the rear end of the car's trunk lid, and it is one of the components of aerodynamics. The primary purpose of installing a spoiler is to increase the downforce at the rear of the car, thereby reducing drag during driving to enhance the car's stability. This technology was initially used in racing cars. However, installing a spoiler on a car is considered illegal modification and is a violation of the law. The penalties and relevant regulations for illegal modifications are as follows: Penalties for Illegal Modification: Driving an illegally modified car on the road will result in the vehicle being impounded by the traffic management department of the public security authority, the illegal device being confiscated, and the owner being ordered to restore the vehicle to its original condition, along with a fine imposed according to the law. Relevant Regulations: For illegally modified cars, the traffic management department of the public security authority will not issue a safety technical inspection compliance mark. If the modification constitutes a violation of public security management, the public security authority will impose penalties such as fines or detention in accordance with the relevant provisions of the "Public Security Administration Punishment Law." When modifying your car, it is essential to apply for a modification registration with the traffic management department of the public security authority to ensure that the modified car can pass annual inspections and routine safety checks.

4

Share

How many cylinders does the Hongqi HS5 engine have?

4-cylinder 2.0T, 224 horsepower turbocharged engine is the engine equipped in the Hongqi HS5, paired with a 6-speed automatic transmission. The cylinder block and head are made of aluminum alloy, and the fuel supply method is direct injection. The four-cylinder, also known as a four-cylinder engine, is a machine capable of converting one form of energy into another. Its structure consists of the cylinder block, crankcase, cylinder head, and cylinder gasket components. The Hongqi HS5 is a mid-size SUV with a 5-door, 5-seat body structure. The vehicle dimensions are 4760mm in length, 1907mm in width, and 1700mm in height, with a wheelbase of 2870mm. The front and rear tire specifications are 235/60R18, and the spare tire is a non-full-size tire. The suspension uses MacPherson independent suspension and multi-link independent suspension. The engine model is CA4GC20TD32, which is a domestically developed engine that meets the China 6B emission standards. The maximum power is 165kw, the maximum torque is 340nm, and the maximum horsepower reaches 224.

10

5

Share

What are the methods to reset the wrench indicator on the JAC S2?

There are the following methods to reset the wrench indicator on the JAC S2: 1. Insert the car key and press the small button on the lower right side of the dashboard. 2. Turn the car key to the ACC position (power-on position) and wait for 3 seconds. 3. Power off by turning the key. 4. Turn the key to the ACC position again to reset the wrench indicator. Related information: 1. The wrench symbol on the car dashboard is a maintenance reminder light. When it lights up, it indicates that the car needs maintenance. 2. The maintenance reminder light is very convenient for managing the car's maintenance cycle.

16

0

Share

What are the body dimensions of the Haval H6?

Haval H6's body dimensions are 4600mm in length, 1860mm in width, and 1720mm in height, as per official data. The length of the Haval H6 refers to the distance between two vertical planes perpendicular to the vehicle's longitudinal symmetry plane, touching the foremost and rearmost protruding points of the vehicle. The width refers to the distance between two parallel planes parallel to the vehicle's longitudinal symmetry plane, touching the outermost rigid fixed protruding points on both sides of the vehicle. The height refers to the distance between the highest point of the vehicle and its supporting plane. The third-generation Haval H6 equipped with a 2.0T engine delivers a peak power of 155 kW and a peak torque of 325 Nm, paired with a second-generation 7DCT transmission. National regulations stipulate specific standards for vehicle dimensions. According to the national standard 'GB1589-89,' the total width of a vehicle excludes side mirrors. The limitation on vehicle width ensures sufficient lateral clearance for overtaking between adjacent lanes. This means that, under national standards, the significance of vehicle width data lies in providing adequate space during overtaking to prevent accidents or situations where road markings are narrower than the vehicle's width. Additionally, national regulations stipulate that the total width of a vehicle must not exceed 2.5m to meet the requirements of public road usage.

8

2

Share

What are the differences between Mercedes-Benz E-Class and S-Class?

Mercedes-Benz E-Class and Mercedes-Benz S-Class differ in the following aspects: 1. Positioning: The E-Class is a mid-to-high-end luxury car, while the S-Class is a top-tier luxury vehicle. 2. Exterior design: The E-Class features softer side lines with a cigar-shaped waistline, whereas the S-Class has triangular headlights that appear more aggressive, and its side lines show a more inclined rear. The Mercedes-Benz E-Class is a large high-end business sedan developed by Mercedes-Benz, positioned between the C-Class and S-Class. Its body dimensions are 5026mm in length, 1854mm in width, and 1477mm in height, with a wheelbase of 3014mm.

11

1

Share

Can the plug of a dash cam be replaced?

What to Do If the Vehicle Stalls Suddenly While Driving?

Does Installing a Spoiler Increase Drag?

How many cylinders does the Hongqi HS5 engine have?

What are the methods to reset the wrench indicator on the JAC S2?

What are the body dimensions of the Haval H6?

What are the differences between Mercedes-Benz E-Class and S-Class?

What is the actual fuel consumption of the Emgrand GL 1.4t?

How to Remove a Dash Cam?

Can You Lock the Car Without Turning Off the Engine?

What is the gap size of a car spark plug?