Can the idle speed of Haojue EFI be adjusted?

1 Answers
SanMariana
07/30/25 6:48am
Yes, the idle speed is controlled by the ECU. Here is the detailed information: Related introduction: For Haojue EFI motorcycles, the idle speed is controlled by the ECU and cannot be adjusted higher or lower like carburetor motorcycles. EFI motorcycles do not require idle speed adjustment. An idle speed around 1500 RPM is considered normal. Do not set the idle speed too low as it offers no benefits. Adjustment method: Preparation: Ensure there is some free play when the throttle grip is fully released, and the air filter is properly installed. Pre-adjustment: Adjust the throttle screw and the air adjustment screw to maximize the engine speed as much as possible. Then adjust the throttle screw to minimize the engine speed as much as possible.
Was this review help?
14
1
Share
More Forum Discussions

What is the tire pressure for Wuling Zhiguang 165 tires?

Wuling Zhiguang 165 tires have a front tire pressure of 2.5bar and a rear tire pressure of 3bar. Methods to check tire pressure: The most standard tire pressure value can be found on the tire pressure label located on the front door frame on the driver's side, which indicates the original tires and their corresponding tire pressures. The tire pressure data refers to the cold tire pressure. This applies to both summer and winter tires. Hazards of too low or too high tire pressure: Both underinflation and overinflation can shorten the tire's lifespan. Underinflation increases tire deformation, making the sidewalls prone to cracking, and the resulting flexing motion leads to excessive heat buildup, accelerating rubber aging and even causing blowouts. It also increases the tire's contact area, accelerating shoulder wear. Overinflation causes the tire to over-expand, reducing elasticity, and may lead to blowouts upon significant impact. Additionally, overinflation accelerates tread wear.
9
2
Share

Is the Audi A6 Front-Wheel Drive or Rear-Wheel Drive?

The Audi A6 is a front-wheel-drive vehicle, featuring a front-engine, front-wheel-drive layout where the engine is positioned at the front of the car, and the front wheels drive the entire vehicle. More details about the Audi A6 are as follows: 1. The dimensions of the domestic version of the Audi A6 are 5038 mm in length, 1886 mm in width, and 1475 mm in height, with a wheelbase of 3024 mm. 2. The Audi A6 is equipped with three engines: a low-power 2.0-liter turbocharged engine, a high-power 2.0-liter turbocharged engine, and a 3.0-liter turbocharged engine. 3. The low-power 2.0-liter turbocharged engine delivers a maximum power of 190 horsepower and a maximum torque of 320 Nm; the high-power 2.0-liter turbocharged engine produces a maximum power of 224 horsepower and a maximum torque of 350 Nm; the 3.0-liter turbocharged engine generates a maximum power of 340 horsepower and a maximum torque of 500 Nm.
6
3
Share

Will I be penalized for driving 105 in a 100 km/h speed limit zone?

No, you won't be fined as it doesn't exceed 10% of the speed limit. Here are some long-distance driving precautions: 1. Pre-trip inspection: Before your journey, thoroughly check all vehicle components, tires, lights, fluids, wipers, etc. Especially for long highway trips, pay special attention to tire conditions and address any issues immediately, as a blowout on the highway can be extremely dangerous. Take breaks every 2 hours of continuous highway driving to adjust your condition, and let your vehicle rest too - this ensures safety for the next leg of your trip. 2. Speed control: Slow down, observe carefully, and proceed cautiously. While this advice may sound repetitive, it's genuinely life-saving. The saying "Nine out of ten accidents are caused by speeding" holds true. To reduce accident risks and improve survival chances, maintain appropriate (but not excessively slow) speeds according to regulations. Particularly when exiting highways via ramps, consciously reduce speed as many drivers tend to overspeed in these sections. 3. Avoid frequent lane changes: Most highways have three lanes. As a rule, don't occupy the passing lane or slow lane for extended periods - the middle lane is generally safest as it provides more space on both sides. If accidents occur with vehicles on either side or ahead/behind, the middle lane allows more reaction time. Unless necessary, avoid frequent lane changes as they cause many accidents. When overtaking or changing lanes, always signal for at least 3 seconds before maneuvering. 4. Keep distance from large vehicles: Maintain distance from trucks due to their large blind spots and heavy weight. Trucks require longer braking distances and often can't see smaller vehicles in their blind spots, making accidents more likely. In any collision, passenger vehicles typically sustain more damage than trucks. Never drive too close to large trucks, especially avoid driving parallel to them. When encountering trucks, overtake decisively if possible.
3
3
Share

What is Tesla's Charge Limit?

Tesla's charge limit refers to setting the maximum charging level for the battery. Setting a charge limit prevents the battery from being fully charged, thereby extending its lifespan. Additionally, when charging outside but with limited funds on your phone, setting a charge limit can help avoid overcharging. The Tesla mobile app and the vehicle's touchscreen both allow you to adjust the charge limit. Method to Adjust Tesla's Charge Limit: On the touchscreen, tap the battery icon to bring up the charging settings interface; click the [Set Limit] button, then drag the arrow on the upper graphic. For daily use, the leftmost tick mark represents 50%, with each increment being 10%, while the rightmost tick mark for long trips represents 100%; click [Done] to complete the setup. Reason Why the Charge Limit Keeps Changing: Some owners have reported that Tesla's charge limit keeps changing. This is because the system calculates the charge limit by dividing the current range by the battery percentage, which can result in slight inaccuracies.
11
4
Share

How to Adjust the Fuel Supply Angle of a Four-Cylinder Diesel Engine?

The steps to adjust the fuel supply angle of a four-cylinder diesel engine are as follows: 1. Remove the high-pressure fuel pipe of the first cylinder and connect a thin transparent small rubber tube to the outlet of the fuel injection pump. Place the throttle in the maximum position and rotate the crankshaft to eliminate air from the fuel line. Then, squeeze a few drops of oil from the small rubber tube, leaving a section at the end without oil to observe the fuel injection. 2. Slowly rotate the flywheel while observing the fuel injection in the rubber tube. When the oil level in the tube rises and just stops (i.e., the fuel supply from the injection pump has just ended), immediately stop rotating the flywheel. 3. Observe whether the piston has just reached the top dead center position at this time (the cylinder head can be removed in advance to facilitate observing the piston's upward position). If the fuel injection pump stops supplying fuel too early or continues supplying fuel for too long when the piston reaches top dead center, it indicates that the fuel supply advance angle is either too large or too small. Adjustments should be made to ensure they are basically consistent, which is considered good.
14
2
Share

How to Remove Odor from Car Air Conditioning?

Here are the methods to remove odor from car air conditioning: 1. Replace the cabin air filter during maintenance: The cabin air filter needs to be cleaned and replaced regularly. After prolonged use, especially in dusty and polluted urban environments, the filter can become clogged with dust. At this point, no amount of cleaning will restore its air filtration capability, and the accumulated dust and dirt may circulate into the car cabin with the air, causing more severe pollution. 2. Open doors and sunroof to air out in sunlight: For mild interior odors, you can park the car under direct sunlight on a sunny day. Set the air conditioning system to warm air mode, turn the fan to maximum speed, and leave all doors and windows open for about ten minutes. This serves two purposes: first, ultraviolet rays can help disinfect the interior; second, the warm air facilitates complete circulation of stale air in the ventilation ducts. The advantage is that this method costs nothing, but it can only eliminate relatively weak odors. 3. Clean ventilation ducts: Bacteria in the ducts can also cause air conditioning odors. A simple solution is to use an air conditioning duct cleaner to eliminate unpleasant smells from the ventilation system.
20
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.