Can the excessive brake pedal travel of the Hongguang be adjusted?
1 Answers
The excessive brake pedal travel of the Hongguang can be adjusted. Adjustment method: Start the vehicle and wait for the idle speed to stabilize (approximately 2-3 minutes), then firmly press the brake pedal all the way down. Make sure to hold it down forcefully for two seconds before pulling up the handbrake. Continue to press the foot brake firmly for a few seconds without releasing it, then slowly release the foot brake and lower the handbrake. If there is no change in the brake pedal travel after this operation, it is necessary to promptly visit a repair shop to check for detailed causes. Reasons for excessive brake pedal travel: Faults in the brake system, including issues with brake fluid, the hydraulic system, wear on brake pads and discs, etc.; among these, the contamination of brake fluid with water is a relatively common fault. Most cars currently use a hydraulic brake system, which has completely replaced the previous cable-operated brake systems. Moreover, the brake fluid reservoir is not completely sealed, leaving certain gaps that allow moisture from the air or external environment to seep into the brake fluid.