···
Log in / Register

Can the BMW X3 be remotely started?

3 Answers
VonAbel
07/29/25 3:50pm
BMW X3 can be remotely started. Here are the specific details about the BMW X3: Body dimensions: The BMW X3 has a length, width, and height of 5106×1868×1500mm. The strong waistline adopts BMW's consistent design approach, enhancing the sporty atmosphere and sense of power. Powertrain: The new BMW X3 is equipped with a high-performance 2.0T turbocharged engine, with maximum output power of 184 horsepower and 252 horsepower, an 8-speed automatic transmission, and a multi-link rear suspension system, providing excellent road handling.
Was this review help?
19
4
Share
MaggieLynn
08/15/25 3:36am
The new BMW X3 indeed supports remote engine start via a mobile app, which I personally use quite often. Using the My BMW app on my phone, I can start the car from the underground parking or office, and after a few minutes of engine warm-up, the air conditioning automatically turns on. Once during winter when it was below minus ten degrees, I started the car five minutes before leaving, and by the time I got in, the steering wheel was already warm. However, this requires the original ConnectedDrive service to be activated and a stable network signal. Sometimes the connection can be unstable when the car is parked in an underground garage, so it's best to ensure the key is inside the car. The engine will automatically shut off if no one enters the vehicle within ten minutes after remote start.
Was this review help?
7
0
Share
Expand All
CourtneyAnn
10/12/25 4:10am
My 2019 X3 can be started remotely, but the vehicle configuration needs to be confirmed. First, check if there is a remote start module antenna under the windshield. To operate, lock the car first, then press and hold the circular arrow key on the key fob for three seconds to start the engine. This is especially useful in summer for turning on the air conditioning in advance to lower the cabin temperature. This feature was optional for X3 models after 2018. If you didn't opt for the Comfort Access system when purchasing the car, you may need to return to the 4S dealership to have the hardware module installed. After starting, the headlights will turn on to alert pedestrians, and the fuel consumption is roughly the same as in idle state.
Was this review help?
8
3
Share
Expand All
More Forum Discussions

Why Can't the Hydraulic Valve Lifter in a Car Be Pressed Down by Hand?

There are several reasons why the hydraulic valve lifter in a car cannot be pressed down by hand: 1. Excessive oil level: If the engine oil level is too high or too low, it may cause aerated oil to enter the hydraulic lifter, forming an elastic body and resulting in valve tapping noise. 2. Low oil pressure: Insufficient lubrication in the hydraulic lifter allows air to enter, causing valve tapping noise. 3. Prolonged engine inactivity: This can lead to excessive compression of the hydraulic lifter, and upon restarting, insufficient oil replenishment may allow air to enter, resulting in valve tapping noise. 4. Hydraulic lifter failure: When valve tapping noise occurs in an engine equipped with hydraulic lifters, the oil level should be checked first. If the oil level is too low, it should be topped up to the standard height.
15
0
Share

Does the Dash Cam Record Automatically?

After the vehicle is parked and turned off, the dash cam will automatically shut down and enter a low-power sleep mode. However, once it detects a collision or movement of objects in front, it will immediately wake up and capture the surrounding footage. This ensures both vehicle parking safety monitoring and energy conservation, preventing the risk of battery drain. Below is more information about dash cams: 1. A dash cam refers to a device that records images, sounds, and related information during vehicle operation. It essentially functions as an automotive camera, capable of high-definition recording to fully document the vehicle's journey, including images, sounds, and vehicle status data. 2. Dash cams with parking monitoring features can continue recording after the vehicle is turned off, but typically only for a few minutes, as the dash cam is not charging when the vehicle is off. The parking monitoring function of dash cams comes in two types: one is continuous recording, and the other is short-duration recording triggered only when the vehicle experiences vibrations.
16
4
Share

What is the principle of the Accord hybrid car?

The Accord hybrid system has three driving modes: pure electric, hybrid, and internal combustion engine driving. In electric mode, the motor obtains energy from the lithium battery pack and drives the vehicle alone. The maximum speed is 60 mph, and the maximum driving range is not high. Once the battery energy is exhausted, it automatically switches to hybrid mode. The following is an introduction to the hybrid system: 1. Hybrid mode: The working principle of the Accord hybrid is similar to that of the Chevrolet Volt. The 2.0-liter gasoline engine drives the generator to produce electricity, which is then used for the electric motor. Honda refers to the combination of the generator and the motor as a dual motor. In this mode, the vehicle is driven solely by the electric motor. Internal combustion engine driving mode: In this mode, the motor is decoupled from the transmission system. 2. The engine directly drives the wheels through a single-speed transmission. According to Honda, the efficiency of this single-speed transmission is similar to that of a 6-speed manual transmission under highway conditions. Atkinson cycle engines are also used in hybrid vehicles from Ford and Toyota.
1
3
Share

What is the dumbest method for parallel parking in Subject 3?

When parallel parking the vehicle, drive slowly with the car body parallel to the sideline, and use the right side mirror to judge the distance between the car body and the sideline. When the distance is less than 30 centimeters, park the vehicle by the roadside to complete the parallel parking test in Subject 3. More relevant information is as follows: 1. Deduction: After the vehicle is completely parked, if the distance between the side of the vehicle and the sideline is more than 30 centimeters, 10 points will be deducted. If no points were deducted in the previous test items, it will not affect the final test result and the test will be judged as passed. If the vehicle directly hits the curb during parking, 100 points will be deducted, leading directly to test failure. 2. Practice time: The Subject 3 test requires 3-6 days of practice. The main practice items for the Subject 3 test are straight-line gear shifting, starting and stopping the vehicle, and the use of vehicle lights. Only after passing the Subject 3 test can one take the Subject 4 test and finally obtain a motor vehicle driver's license.
20
3
Share

How is the Subject 3 route selected?

How the Subject 3 exam routes are arranged depends on the circumstances, as driving school systems vary across regions. Some driving schools conduct the route selection on the exam day. After candidates arrive at the test center, submit their exam documents, and enter the waiting room, the exam route is randomly selected by a computer. The result will be displayed on the screen along with the candidate's exam information. Additional Information: Note 1: If fingerprint verification fails, the candidate should exit the vehicle to re-collect their fingerprint before rejoining the queue for the exam. Note 2: If a candidate's score falls below the passing threshold during the exam, the system will automatically prompt them to pull over. After completing the pull-over maneuver, the system will indicate the next exam step. Note 3: After completing all required exam items and driving a distance exceeding 3 kilometers, the system will automatically prompt the candidate to pull over. Upon hearing the pull-over instruction, the candidate should choose a clear curb (or solid road edge line) along the exam route and complete the maneuver safely. The system will then announce the exam results.
8
0
Share

How to turn on the air conditioning cold air in Chevrolet Cavalier?

To turn on the air conditioning cold air in Chevrolet Cavalier, follow these steps: The temperature adjustment knob is located on the left side of the air conditioning panel. Turn it clockwise to increase the temperature and counterclockwise to decrease it. Press the A/C button to activate the cold air. The fan speed adjustment button can be used to control the airflow volume. Possible reasons for the air conditioning not cooling include: 1. Refrigerant leakage. 2. Damaged or faulty compressor capacitor, causing the compressor to stop working. 3. Changed resistance value of the room temperature sensor, leading to the outdoor unit not functioning. 4. Faulty remote control or air conditioning receiver. 5. Malfunctioning four-way valve (not applicable to cooling-only units) or high-low pressure gas mixing in the compressor, where the air conditioning operates but has no effect. 6. Faulty control board in the indoor or outdoor unit causing the air conditioning to not cool. 7. Incorrect wiring of the power supply's live and neutral wires. 8. Damaged fan in the indoor or outdoor unit.
1
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.