Can objects be hung on rearview mirrors?

How to Distinguish Between Good and Bad Motorcycle Spark Plugs?

To determine whether a motorcycle spark plug is good or bad, the first step is to perform a spark test. When the spark plug accurately jumps from the center electrode to the negative electrode at the top of the spark plug, it is functioning normally. During the spark test, the spark plug must be grounded at the cylinder head or cylinder block. If the spark does not jump accurately to the upper electrode of the spark plug but instead jumps to other parts of the spark plug, it indicates a short circuit between the two electrodes. This is usually caused by carbon deposits and can be repaired by baking. Alternatively, upon close inspection, you may notice that the center electrode is biased to one side, but it fails to produce the correct spark during ignition! In such cases, replacing the spark plug is necessary to resolve the issue. The optimal operating temperature for a spark plug is generally between 400-800 degrees. If the spark plug appears black, it indicates that the operating temperature is too low, caused by an overly rich air-fuel mixture (or prolonged idling). If it appears white, it means the operating temperature is too high, due to an overly lean air-fuel mixture. The normal working state should be light brown. Remove the spark plug, place it against the cylinder block (connected to the high-voltage wire), and press the starter pedal to observe. Check if there is carbon buildup inside the spark plug, and clean it before testing again. If there is still no carbon buildup, the spark plug is essentially useless.

8

5

Share

What is the appropriate speed for a new car on the highway?

For the first 500 kilometers, avoid heavy loads and keep the speed below 80 km/h. Within the first 1,000 kilometers, slight loads are acceptable, but the speed should not exceed 100 km/h. For the first 2,000 kilometers, the speed should not exceed 120 km/h. Here are some precautions for driving a new car on the highway: 1. Maintain a reasonable speed: A reasonable speed does not mean driving at a constant speed like cruise control, but avoiding both low-speed driving and high-RPM sudden acceleration. The speed should ideally be kept below 100 km/h, and pay attention to the engine RPM and speedometer during driving, ensuring the engine RPM does not exceed 3,000. 2. Avoid flooring the accelerator when starting or slamming on the brakes: Emergency braking can shock the braking system and increase the impact load on the chassis and engine. 3. Use gears appropriately for manual transmission cars: Avoid prolonged low-gear driving, and neither high-gear low-speed nor low-gear high-speed driving is optimal. For automatic transmission cars, relying solely on "D mode" is not recommended; using modes like S or manual mode appropriately is beneficial for the transmission. 4. Avoid full loads and especially overloading: This can cause damage to mechanical components. Additionally, if the new car is used in northern winters, it is best to allow the engine sufficient time to lubricate before starting.

3

5

Share

What are the reasons why the driver's door is unlocked but cannot be opened?

There may be several reasons why the driver's door is unlocked but cannot be opened: 1. Water in the door handle sensing area: The vehicle door handle uses a capacitive sensor, and the capacitive noise generated by water interferes with the capacitive detection of the door handle antenna, causing the antenna to enter a self-protection mode, reducing the sensitivity of unlocking and locking, and in severe cases, temporarily disabling the unlocking and locking function. 2. Snow and ice weather: Heavy snow, water, or ice attached to the door handle unlocking area during snow and ice weather can reduce the sensitivity of unlocking and locking. 3. Continuous impact of raindrops on the door handle during rain: Under the impact of rain, the capacitive sensor of the door handle continuously detects changes in capacitance. To avoid false triggering, the door handle antenna enters a rain mode, where the locking sensing time is extended, and the sensitivity of unlocking and locking is reduced. 4. Electromagnetic interference or shielding: Radio communication can be affected by co-channel interference and shielding effects. If an interference source is present, it can disrupt the normal communication between the remote key and the antenna. 5. Obstruction of the sensing area: Installing decorative devices on the door handle, having an overly small opening in the sensing area, or excessively thick decorative parts can prevent the finger from fully covering the sensing area, leading to the failure of the unlocking and locking function.

6

2

Share

What to Do If You Discover Repainted Areas When Purchasing a New Car?

You can request the 4S store to replace the car with a new one. If the 4S store refuses, you can directly apply for a refund and demand triple compensation, or file a lawsuit in court. Methods to identify whether a new car has been repainted: 1. Check for color differences: Due to variations in paint color and repainting techniques, a repainted used car will inevitably have some color difference compared to the original paint. Under good lighting conditions, the owner can inspect the car from multiple angles to carefully observe any color discrepancies. You can also place your hand on your forehead at a 45-degree angle to the car body and judge whether the area has been repainted by comparing the brightness of the reflected light, as repainted areas usually reflect light more dimly. 2. Feel the smoothness: After a used car has been repainted, the repainted areas may exhibit microscopic unevenness that can be detected by touch. Although painters may use sandpaper for water sanding to improve the smoothness of the repainted surface, even with careful operation, it cannot restore the original factory-level smoothness. 3. Listen to the knocking sound to determine if the car has been repainted: You can also tap the car body with your fingers and judge by the sound. A crisp sound indicates that the area has not been repainted. 4. Inspect edges and seals: Examine the edges, seals, decorative strips, and rubber seals of the car body for any residual paint marks. If the car has been repainted, traces will inevitably be left in these areas. Pay special attention to the paint on the engine hood. If you notice that the paint layer lacks the fullness of the original paint or shows signs of orange peel, sagging, pinholes, bubbles, cracks, discoloration, or putty marks, it may indicate repainting.

8

2

Share

What is the appropriate tire pressure for the Q5?

A tire pressure of 2.4-2.5 bar is most suitable for the Audi Q5. Due to seasonal factors, the tire pressure can be appropriately increased by 0.2 bar in winter and reduced by 0.1 bar in summer. This data is based on the international GBT2978-2008 standard requirements. The Audi Q5's tire pressure monitoring can be viewed on the central display. The tire pressure monitoring system uses ABS tire speed sensors to detect differences in rotation speeds between tires, determining if there is abnormal tire pressure. If an abnormality is detected, it will prompt immediately. Generally, a tire pressure above 2.8 bar is considered too high, while a pressure below 2.0 bar is too low. Hazards of overinflated tires: Reduced tire friction and adhesion, affecting braking performance; causes steering wheel vibration and deviation, reducing driving comfort; accelerates wear on the central tread pattern, shortening tire lifespan; increases vehicle vibration, indirectly affecting the lifespan of other components; overstretches tire cords, reducing elasticity and increasing the load on the vehicle during driving. Hazards of underinflated tires: Increased friction coefficient with the road surface, leading to higher fuel consumption; makes the steering wheel heavy and prone to deviation, compromising driving safety; increases movement in various parts of the tire, causing abnormal heat due to excessive rolling; reduces the functionality of cords and rubber, leading to delamination or cord breakage and excessive friction with the rim, damaging the tire bead and causing abnormal wear; multiplies friction between the tire and ground, rapidly increasing tire temperature, softening the tire, and drastically reducing strength. High-speed driving may result in a tire blowout. If the tire pressure monitoring indicator light illuminates (a yellow symbol with an irregular circle, no stamp on top, four small spikes below, and an exclamation mark inside), there are generally three possible reasons: Abnormal tire pressure: Typically, it will alert if the pressure is below 1.8 bar or above 3.0 bar. In this case, tire inspection and pressure adjustment are required. Tire pressure monitoring not reset: After inflating the tires, if the tire pressure is not reset promptly, the system will still record the previous data, causing the indicator light to illuminate. Simply reset the tire pressure to resolve this issue. Damaged tire pressure sensor: The tire pressure sensor, installed inside the tire and connected to the inflation valve, monitors tire pressure. If the sensor is damaged due to impact while driving, it can trigger the tire pressure warning light. For sensor damage, replacement with a new part is the only solution.

11

5

Share

What should you do when visibility is between 100 and 200 meters?

Turn on fog lights, low beams, clearance lights, and front and rear position lights. The speed should not exceed 60 kilometers per hour, and maintain a distance of more than 100 meters from the vehicle in front in the same lane. Turn on fog lights, low beams, clearance lights, front and rear position lights, and hazard warning flashers. The speed should not exceed 40 kilometers per hour, and maintain an appropriate distance from the vehicle in front.

11

2

Share

Can objects be hung on rearview mirrors?

How to Distinguish Between Good and Bad Motorcycle Spark Plugs?

What is the appropriate speed for a new car on the highway?

What are the reasons why the driver's door is unlocked but cannot be opened?

What to Do If You Discover Repainted Areas When Purchasing a New Car?

What is the appropriate tire pressure for the Q5?

What should you do when visibility is between 100 and 200 meters?

How to Use Rearview Mirrors When Driving?

What are the engine specifications of the Nissan New Murano?

What does the air conditioning MONO mean?

Which has more space, a small SUV or a compact SUV?