Can motor vehicles use non-motorized vehicle lanes?

1 Answers
MacKhloe
07/24/25 10:03pm
Motor vehicles are not allowed to use non-motorized vehicle lanes. Here are the precautions for motor vehicles on the road: 1. Do not exceed the speed limit: When driving on the road, motor vehicles must not exceed the maximum speed indicated by speed limit signs. On road sections without speed limit signs, safe speeds should be maintained. When driving at night, on dangerous road sections, or under weather conditions such as sandstorms, hail, rain, snow, fog, or icy roads, driving speed should be reduced. 2. Drive in the designated lane: When encountering vehicles ahead that are stopped in a queue or moving slowly, motor vehicles must not overtake by using other lanes or occupy the opposite lane, nor should they cut into the queue of waiting vehicles. In sections or intersections where lanes are reduced, or at intersections without traffic lights, signs, markings, or police direction, motor vehicles should take turns to proceed in an orderly manner when encountering stopped or slow-moving queues.
Was this review help?
18
0
Share
More Forum Discussions

Is a Coolant Temperature of 90 Degrees Normal?

Coolant temperature of 90 degrees is normal. For traditional engines, the normal operating temperature range for coolant is between 80-90 degrees, while for high-performance engines, it is normal for the coolant temperature to be below 105 degrees. The engine coolant temperature should not be too low or too high; it needs to be within a certain range. The normal temperature is typically indicated by the central position of the gauge at 90°C. Additional information: Below is an introduction to coolant-related content: 1. After starting the vehicle, the antifreeze temperature rises rapidly. Once the pointer reaches the central position, the heat exchange balances out, and the antifreeze temperature stops rising. Generally, it is optimal to start driving when the temperature reaches the middle position, which is one of the reasons for warming up the car before driving. 2. If the coolant level is insufficient, do not continue driving. Instead, replenish the coolant promptly. In northern regions, it is essential to use antifreeze and identify the cause of the deficiency. 3. The cooling system circulates coolant via a water pump to dissipate heat from the engine. Insufficient coolant will prevent proper circulation and heat dissipation, potentially damaging the engine.
17
3
Share

What are the reasons for the high fuel consumption of the Chevrolet Lova?

There are many factors that can lead to excessive fuel consumption, such as driving habits (sudden acceleration, sudden braking, coasting in neutral, speed and gear mismatch), low tire pressure, use of poor-quality fuel, ignition system failure, and electronic control system failure, all of which can increase the vehicle's fuel consumption. Below is additional information: 1. The vehicle has not been maintained on schedule: For example, failure to replace the air filter, fuel filter, spark plugs, and clutch plates in a timely manner can also lead to increased fuel consumption. 2. Carbon buildup and electronic control system failures: For instance, carbon buildup on the throttle body, idle valve, and fuel injectors, or inaccurate signals from the oxygen sensor, air flow meter, and coolant temperature sensor, can all affect the vehicle's fuel consumption. If fuel consumption is too high, a comprehensive inspection is required.
20
4
Share

Can I directly apply for an A2 license?

You cannot directly apply for an A2 license, and you must be at least 24 years old. You must hold a B-class license to apply. Here is some additional information: 1. A2 driver's license: An A2 license cannot be obtained initially; it can only be acquired through an upgrade. You must have held a (B1) medium-sized bus or (B2) large truck driving qualification for at least three years, with no full-point penalty records in the two most recent scoring cycles before application. 2. People who cannot apply for an A2 license: Those who have caused a fatal traffic accident and bear full or primary responsibility; those who have driven under the influence of alcohol; and those who have driven after drinking alcohol within the current scoring cycle and the three most recent consecutive scoring cycles before application are not eligible to apply.
18
1
Share

Why does the car's fan keep running after the AC is turned off?

Car's fan keeps running after the AC is turned off because the fan coil circuit is not connected to the compressor (i.e., not connected to the AC system), but rather to the engine. The fan not only cools the compressor but also dissipates heat for the engine. Below is an introduction to the four circulation processes of the AC system: 1. Compression process: The compressor inhales low-temperature, low-pressure refrigerant gas from the evaporator outlet and compresses it into high-temperature, high-pressure gas before discharging it. 2. Heat dissipation process: The high-temperature, high-pressure superheated refrigerant gas enters the condenser, where, due to the reduction in pressure and temperature, the refrigerant gas condenses into liquid and releases a large amount of heat. 3. Throttling process: The higher-temperature and higher-pressure refrigerant liquid passes through the expansion device, causing its volume to increase, and its pressure and temperature to drop sharply, discharging as a mist (fine droplets). 4. Heat absorption process: The mist-like refrigerant liquid enters the evaporator, where, since the boiling point of the refrigerant is much lower than the temperature inside the evaporator, the refrigerant liquid evaporates into gas.
6
5
Share

What is the recommended engine oil specification for Buick Excelle maintenance?

Buick Excelle 1.4T models use Mobil 1 5W-30 full synthetic oil as original equipment, while the 1.5L models use OEM 5W-30 semi-synthetic oil with an approximate filling volume of 3.7L. For subsequent maintenance oil changes, you may choose brands such as Mobil, Shell, Castrol, or Total. The viscosity of engine oil varies with temperature changes, so special attention should be paid to its performance under both low and high temperature conditions. Taking 5W-30 as an example, the first number indicates low-temperature fluidity - 5W represents the oil's capability to withstand -30°C low temperatures. A smaller number indicates better low-temperature fluidity, resulting in smoother cold starts for the vehicle. The latter number represents the oil's kinematic viscosity at 100°C - higher values indicate better ability to maintain viscosity under high temperatures, which can also be understood as superior lubrication performance in high-temperature conditions. The oil change procedure for Buick Excelle is as follows: Wait for the engine temperature to decrease, allowing the oil to fully drain back to the oil pan; Loosen the drain plug with a wrench and collect the used oil in a drain pan until no more oil flows out. Start the engine and let it run for 30 seconds to allow oil in the main oil gallery to drain; Remove the oil filter using a special wrench; Apply oil to the seal of the new oil filter and hand-tighten it clockwise; Add new oil through the filler cap on the engine valve cover, typically filling about three-quarters of a standard oil container; Start the engine and let it run for 5 minutes, then check for leaks around the drain plug and oil filter. Address any leaks if found; After stopping the engine, pull out the dipstick to verify the oil level falls within the standard range.
16
3
Share

Where is the Mercedes-Benz Business Opening Button?

The electric door switches for both sides are located on the left and right sides of the central console on the dashboard. Here is some relevant information: 1. Electric Door: An electric door refers to various types of doors driven by motors. Electric doors play a decisive role in daily life. They provide safety, aesthetics, convenience, and significantly improve the quality of life. 2. Working Principle of Electric Doors: The system configuration of an electric door refers to the peripheral auxiliary control devices connected to the electric door controller according to usage requirements, such as door opening signal sources, access control systems, safety devices, centralized control, etc. 3. Precautions for Electric Doors: The electronic switch requires only a gentle pull. Do not apply excessive force to assist in opening the door.
1
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.