Can Mainland License Plates Drive on the Hong Kong-Zhuhai-Macao Bridge?

1 Answers
OscarRose
07/30/25 2:16am
Mainland license plates cannot drive on the Hong Kong-Zhuhai-Macao Bridge. Below is relevant information about vehicles allowed on the bridge: Vehicles permitted on the bridge: In addition to cross-border buses, shuttle buses, cross-border taxis, and freight vehicles, approved Guangdong-Hong Kong dual-plate vehicles from the Huanggang, Wenjindu, Shatoujiao, and Shenzhen Bay ports can drive on the bridge without additional permits. These license plates are temporarily allowed to use the bridge for a period of two years. Important notes: Vehicles that have applied for a one-time quota and other vehicles approved by Guangdong, Hong Kong, and Macao authorities can also drive on the bridge. However, vehicles with a one-time quota do not have entry privileges and must remain in the port parking lot or on the artificial island.
Was this review help?
19
1
Share
More Forum Discussions

What procedures are required for motorcycle registration?

First, take the certificate of conformity to the traffic police team for stamping, then bring the invoice, ID card, and other attachments purchased with the motorcycle to the State Taxation Bureau to pay the vehicle purchase tax. Mainland residents should provide the mainland "Resident Identity Card" (including residence or temporary residence certificate) or "Household Register" or military (including armed police) identity proof.
19
2
Share

How to Connect Bluetooth in Wuling Hongguang Mini?

First, start the vehicle, then locate the "Mode" button on the center console panel. Enable the Bluetooth function on your phone and turn on the option to make it visible to nearby devices. Then, press the "Mode" button in the car to select the "BLUE" mode. After that, find the Bluetooth signal of the car on your phone and connect to it to enable Bluetooth functions such as listening to music or other features.
20
3
Share

How to Replace Car Seat Foam?

First, locate the four screws (hexagonal) under the seat, then use a hexagonal screw tool to loosen them, after which you can remove the seat. If the seat is electrically adjustable, there will also be wires connected at the bottom. Simply disconnect the wire connectors, and the job is done.
15
1
Share

How to Replace the Rubber Blade of a Beam Wiper?

After locating the sliding part of the rubber blade, you can remove the clip that secures this end. If it's particularly tight, you can use needle-nose pliers to assist in disassembly. Use a clip or similar tool to pry up the metal buckle, and then you can remove the rubber blade. The metal buckle that secures the rubber blade must be fastened tightly; otherwise, the rubber blade may shift during use, affecting its performance.
11
2
Share

How to Engage the Forward Gear?

Press the clutch with your left foot while simultaneously pressing the brake with your right foot. Once the car stops reversing and comes to a complete halt, use your right hand to shift the gear lever from reverse to neutral, then quickly push the lever into first gear. Gently release the clutch with your left foot while slowly pressing the accelerator with your right foot, and the car will smoothly move forward.
9
0
Share

What is the penalty for parking on grid lines?

Parking on grid lines will result in a fine and a deduction of three points from the driver's license. According to the "Scoring Standards for Road Traffic Safety Violations," motor vehicle drivers who violate prohibitory signs or markings will be penalized with a deduction of three points for each offense.
3
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.