Can I learn to drive a B1 vehicle when getting my driver's license for the first time?

1 Answers
AriannaFitz
07/24/25 10:01pm
You cannot learn to drive a B1 vehicle when getting your driver's license for the first time. For first-time applicants of a motor vehicle driver's license, you can apply for license categories that permit driving urban buses, large trucks, small cars, small automatic transmission cars, low-speed cargo vehicles, three-wheeled cars, small automatic transmission passenger vehicles for the disabled, ordinary three-wheeled motorcycles, ordinary two-wheeled motorcycles, light motorcycles, wheeled self-propelled machinery, trolleybuses, or trams. A driver's license is a certification document issued by the government transportation department to individuals who qualify to drive. It is usually a card. To obtain a driver's license, you need to meet the age requirements and pass a driving test. The driver's license typically specifies the types of motor vehicles the holder is permitted to drive, such as motorcycles, passenger cars, trucks, buses, etc.
Was this review help?
5
3
Share
More Forum Discussions

How to Check Car Battery Power Level?

Start the engine and let it run continuously for 5 to 10 seconds. Simultaneously observe the reading on the voltmeter. For a 12V battery, if the voltage is at or above 9.6V, it indicates the battery is in good condition. If it's below this value, it means the battery has insufficient charge.
1
2
Share

How to Remove the Small Round Mirror from the Car Rearview Mirror?

First, moisten the area where the adhesive of the small round mirror is attached with alcohol. Next, use the hot air setting of a hair dryer to blow on it. Don't worry about whether the heating will damage the glass. After blowing hot air for a while, the small round mirror will come off. Any remaining adhesive can be gently wiped away with alcohol to ensure no damage to the rearview mirror.
16
1
Share

How to activate cruise control in the Teramont?

The system can be controlled via the buttons on the left side of the steering wheel. The plus and minus buttons can be used to accelerate and decelerate. Press the set button when the speed is above 40 to activate cruise control.
5
2
Share

How to Remove Formaldehyde from Cars?

Activated carbon is internationally recognized as an excellent absorber of toxic substances, capable of adsorbing harmful gases such as formaldehyde and benzene. Photocatalyst is a high-quality product for removing formaldehyde, which can decompose harmful substances like formaldehyde in the air into carbon dioxide and water.
10
4
Share

How to Install Car Anti-Collision Strips?

Clean the area on the car door where the anti-collision strip needs to be installed. Peel off one end of the adhesive strip on the back of the anti-collision strip and attach it to the edge of the car door. Press the anti-collision strip firmly and peel off the adhesive strip in one motion. Trim any excess adhesive strip at the edge of the car door, and the entire process is complete.
15
0
Share

How to Start and Park a Car?

Turn on the power, shift from P (Park) to N (Neutral). Start the engine, wait until the engine speed reaches the idle range and runs smoothly. Shift from N to D (Drive), release the handbrake, and slowly release the foot brake to start moving. Press the brake, wait until the car comes to a complete stop, then shift from D to N, and engage the handbrake. Turn off the engine and release the foot brake. Once the vehicle is stationary, shift from N to P. Remove the key and lock the car doors.
7
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.