Can I Get the First Maintenance Before Reaching 5,000 Kilometers?

1 Answers
Margot
07/25/25 3:47pm
It is possible to get the first maintenance before reaching 5,000 kilometers. Below is an extended introduction about the first maintenance: 1. Meaning: The first maintenance of a car refers to the initial service after the new car has been driven. The timing of the first maintenance varies by vehicle, typically performed after driving 3,000-5,000 kilometers. Many brand 4S shops, aiming to shorten customers' maintenance cycles, have adjusted to remind customers to perform maintenance at 5,000 kilometers or 3 months. 2. Items: Replace engine oil, oil filter, gasoline filter, and air filter. Check whether the level of the car's coolant meets the specified requirements, the levels of brake and clutch fluid, whether the oil level in the power steering fluid reservoir meets the specified requirements, check for oil leaks at all oil pipe interfaces in the system, the levels of battery fluid and windshield washer fluid reservoir, the tension and aging of the belts of the generator, air conditioner, water pump, and power steering pump, whether the front and rear lights of the car are complete (including: headlights, marker lights, turn signals, brake lights, reverse lights, and fog lights), the tire pressure and wear of the car tires, tighten the tire bolts to the specified torque, supplement the tire pressure to within the specified value for the model, perform tire rotation based on wear conditions, and whether the car's exhaust emissions meet standards, etc.
Was this review help?
7
0
Share
More Forum Discussions

What is the solution for the buzzing noise at 2000 RPM in the X-Trail?

If there is abnormal noise during instant startup, it may be caused by the starter motor's gear not retracting quickly enough, resulting in flywheel gear grinding noise. The starter motor needs to be inspected. If there is abnormal noise during engine idle after startup, the fault point is likely due to excessive clearance between the hydraulic tappets and valves inside the engine cylinder head.
14
3
Share

How to Remove Adhesive from Paint Surface?

First, the car owner needs to prepare a bottle of tar and resin remover, which can be purchased at a regular hardware store. Because the resin remover can easily wipe off the tar on the car body without damaging the paint. Next, simply spray the resin remover onto the tar stains on the car body surface. Use a clean cloth to wipe the car body surface, and the tar stains will be easily removed, leaving the car body clean and free of tar.
8
2
Share

What to Do About Raised Particles on the Paint Surface?

First, perform a simple polish on the car body surface. Squeeze an appropriate amount of wax liquid onto the car body. Then use a polishing machine with the wax liquid to polish the surface. Next, wipe the car body with a towel to make the polished area smoother and shinier.
8
4
Share

What to Do When a Car Air Conditioning Condenser Leaks?

If there is an issue with the pipes, consider removing and replacing these hoses. If the problem is due to the compressor, where the sealing at the end of the compressor's stroke is insufficient, the compressor or its components need to be replaced. If the issue is with the expansion valve, where functional components are malfunctioning, refrigerant state changes can easily cause problems here. Timely replacement is necessary.
16
2
Share

How to Operate a 7-Speed Wet Dual Clutch Transmission?

Depress the brake pedal and press the one-touch start button. The dashboard will illuminate, indicating that the vehicle's power system is activated. Press the mirror folding button located on the control panel to the left of the steering wheel. Once the vehicle detects the locking signal, the side mirrors will automatically retract.
7
0
Share

How to Clean a Car's Air Conditioning Radiator?

The outermost layer covered is the condenser, not the radiator. Simply rinsing from the outside with a water gun won't achieve an effective cleaning. Remove the radiator for cleaning. Separate the radiator and condenser, then use a brush or high-pressure water gun to remove dirt from the gaps, followed by rinsing the surface with clean water. It's best not to attempt cleaning the radiator yourself. Removing the radiator is quite troublesome, and even repair shops are reluctant to disassemble the entire radiator for cleaning, so supervision is necessary.
8
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.