Can I continue if one item fails in Subject 2?

1 Answers
DelAndres
07/28/25 10:42pm
If any one of the five items in Subject 2 is failed on the first attempt, regardless of how many items have been completed, you must start over. If any item fails again on the second attempt, the entire test will be considered failed. Below is a detailed introduction to Subject 2: Test content: (1) The test includes pile driving, hill start, parallel parking, single-plank bridge, curve driving, right-angle turn, narrow gate, continuous obstacles, bumpy road driving, narrow road U-turn, as well as simulated highway driving, continuous sharp turns on mountain roads, rain (fog) conditions, slippery roads, and emergency handling. (2) For small cars, small automatic transmission cars, small automatic transmission cars for disabled passengers, and low-speed trucks, the test includes reverse parking, hill start (canceled from June 1, 2021), parallel parking, curve driving, and right-angle turn. (3) For three-wheeled cars, ordinary three-wheeled motorcycles, ordinary two-wheeled motorcycles, and mopeds, the test includes pile driving, hill start, and single-plank bridge.
Was this review help?
17
3
Share
More Forum Discussions

Do You Need to Depress the Clutch When Starting a Manual Transmission Car?

Starting a manual transmission car requires depressing the clutch. Below are the specific steps for starting a manual transmission car: 1. Step One: Insert the car key into the ignition switch. 2. Step Two: Turn the key upward to the first position and pause briefly to allow the fuel pump to start supplying fuel to the electrical equipment. Ensure the gear lever is in the neutral position. 3. Step Three: Depress the clutch. Turn the key upward and hold it for two seconds until you hear the engine start normally, then release the key and wait for the dashboard to light up. 4. Step Four: Lift your left foot off the clutch pedal according to the proper technique while moderately pressing the accelerator pedal to ensure a smooth start.
13
2
Share

How is the hybrid function of the Lexus ES300h?

Lexus ES300h is equipped with Lexus' fourth-generation hybrid technology, consisting of a 2.5L four-cylinder engine and an electric motor, and incorporates the AGC automatic gliding system, which can control inertial gliding, engine drag torque, and energy recovery. The specific details are as follows: 1. The gliding system can control inertial gliding, engine drag torque, and energy recovery. 2. According to the manufacturer's introduction, the new generation hybrid system has higher battery performance and more efficient hybrid system control. The AGC can glide in neutral and reduce its fuel consumption. The new ES300h has a fuel consumption of only 4.2 liters per 100 kilometers, which is one point lower than the current model.
10
4
Share

When did China 4 start?

China 4 emission standards started in 2011. Here are the specific methods to check which emission standard a vehicle belongs to: 1. Check the vehicle's environmental protection label, which usually has a clear mark on the back. 2. Visit the website of the Motor Vehicle Exhaust Pollution Supervision and Management Center to inquire. 3. Bring the original or a copy of the vehicle registration certificate to the local vehicle management office for inquiry. 4. For new vehicles, check the vehicle's factory certificate of conformity, which is usually kept at the vehicle management office. Therefore, it is recommended to make a copy for backup when purchasing a car. 5. Make a rough distinction based on the year the vehicle was registered. Most vehicles registered after 2008 are China 4, vehicles registered in 2007 could be either China 3 or China 4, vehicles registered before 2007 are mostly China 3 or China 2, and vehicles registered before 2005 are mostly China 2.
9
2
Share

What engine is equipped in Lamborghini's SUV?

Lamborghini's SUV is called the Urus, which is equipped with a 4.0-liter V8 twin-turbocharged engine. Here is more information about this engine: 1. The engine has a maximum power output of 478 kW, a maximum torque of 850 Nm, a maximum power speed of 6000 rpm, and a maximum torque speed range of 2250 to 4500 rpm. 2. This engine features direct fuel injection technology and uses an aluminum alloy cylinder head and block. It is paired with an 8-speed automatic transmission. 3. The Urus is equipped with a multi-link independent suspension at the front and rear.
19
0
Share

What brand is the audio system in the new Sagitar?

The Sagitar is equipped with Desay SV and Philips audio systems. Owners can choose to upgrade their car audio based on their sound quality requirements. Here is more information about the new Sagitar: 1. Taking the 2018 Sagitar as an example, it belongs to the compact car category, with body dimensions of length 4753mm, width 1800mm, height 1462mm, a wheelbase of 2731mm, and a fuel tank capacity of 50 liters. 2. The 2018 Sagitar features a MacPherson strut front suspension and a multi-link independent rear suspension. It is powered by a 1.2L turbocharged engine, delivering a maximum horsepower of 116PS, a maximum power of 85kW, and a maximum torque of 175Nm, paired with a 5-speed manual transmission.
5
2
Share

What causes the buzzing sound in the Haval H6 power steering pump?

The buzzing sound in the Haval H6 power steering pump is caused by either a damaged pump or insufficient power steering fluid. The power steering system primarily assists the driver in adjusting the vehicle's direction, reducing the effort required to turn the steering wheel. Power steering also plays a role in the safety and fuel efficiency of the vehicle. The specific reasons for the power steering pump noise are as follows: 1. Leakage in the power steering pump, resulting in low fluid levels, which causes noise when turning the steering wheel; 2. Poor lubrication of the power steering pump during cold starts, leading to internal wear and noise; 3. Loose installation of the power steering pump, causing noise during operation.
18
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.