Can I cancel after successfully scheduling the Subject 3 test?

1 Answers
FinnLee
07/25/25 2:06pm
Yes, you can cancel; Log in to the 122 platform to cancel the test before receiving the confirmation message. If the appointment has already been confirmed, bring your ID card to the vehicle management office at least one day before the test to cancel. Subject 3 road test content: 1. Preparation before starting: After confirming your identity, exit the vehicle and walk around it counterclockwise to observe the vehicle's condition and surrounding traffic, ensuring safety. 2. Starting off: Before starting, check if the doors are fully closed, adjust the seat and mirrors, and fasten the seatbelt. Observe the traffic behind through the mirrors, ensure safety, turn on the left turn signal, engage first gear, release the brake, and start off smoothly without jerking, rolling back, or stalling. 3. Light simulation test: Respond to voice prompts within 5 seconds with appropriate light operations. Use high beams on unlit or poorly lit roads; use low beams on well-lit roads, when meeting vehicles, turning at intersections, or following closely. Alternate between high and low beams when overtaking, passing sharp turns, slopes, arched bridges, crosswalks, or uncontrolled intersections. 4. Meeting vehicles: Control speed and maintain a safe distance when meeting other vehicles. 5. Going straight through intersections: Observe traffic, slow down in advance, use turn signals correctly, and adopt appropriate methods to pass intersections safely. 6. Passing crosswalks: Slow down to below 30km/h near crosswalks, school zones, and bus stops, and stop for pedestrians or students. 7. Making a U-turn: Slow down, choose a suitable spot, signal, and execute the turn. 8. Gear shifting: Shift gears smoothly according to speed without jerking. 9. Changing lanes: Signal in advance, check traffic via mirrors, and change lanes safely without affecting others. 10. Driving straight: Keep the vehicle straight with no more than 50cm deviation, checking mirrors periodically without looking away for over 2 seconds. 11. Overtaking: Observe left traffic via mirrors, signal, honk if safe, and pass from the left. 12. Pulling over: Slow down, signal right, observe traffic, and park smoothly within 30cm of the curb, applying the parking brake. Note: After stopping, the vehicle should be within 30cm of the right edge.
Was this review help?
5
5
Share
More Forum Discussions

How Powerful is the Skyactiv Technology?

Skyactiv Technology is a collective term for a series of technologies developed by Mazda, including engine technology, suspension technology, transmission technology, and body technology. Compared to other manufacturers, the most distinctive technical feature of Mazda's Skyactiv Technology lies in its naturally aspirated engine technology based on the Miller cycle. Mazda's Skyactiv engines primarily exhibit the following key characteristics: High Compression Ratio: A high compression ratio of 13:1, with European engines capable of reaching 14:1. A new piston and connecting rod design, 10% engine weight reduction, and an aluminum alloy cylinder block. High Efficiency: The Miller cycle enhances engine efficiency. The essence of the Miller cycle is to alter the engine's compression stroke, making the piston's expansion stroke longer than the compression stroke, thereby improving engine power and reducing fuel consumption. Others: Optimized internal structure with extensive use of electronic control devices. A new 4-2-1 exhaust layout effectively improves exhaust efficiency.
5
2
Share

Which gear is suitable for adjusting the low beam from 1 to 5?

Low beams are generally adjusted between gears 1 and 2. The height of the low beam typically ranges from 0 to 5, where 0 is the highest and 5 is the lowest. Generally, the numbers represent the degree to which the light is adjusted downward; the larger the number, the more the light is lowered. Gear 1 has a minimal reduction, followed by gear 2, while gear 3 has a more significant reduction. Below is a related introduction: Introduction: Low beams are designed for close-range illumination, with the design requirements focusing on a wide range (160 degrees), short projection distance, and non-adjustable focus. Adjustment of height: The adjustment of the light height is primarily based on the number of passengers in the rear seats and the weight of cargo in the trunk. If there are more passengers in the rear seats, the rear of the car will sink lower, causing the front of the car to rise accordingly. This, in turn, raises the height of the headlights, potentially dazzling oncoming drivers and distracting their attention, which can easily lead to traffic accidents.
5
0
Share

How to use the cruise control on the Malibu XL?

The method to use the cruise control on the Malibu XL is: 1. Press the activation button to turn on the cruise control system; 2. Reach the desired speed; 3. Press and release the SET button, the set speed will briefly appear on the instrument cluster; 4. Remove your foot from the accelerator pedal, and the cruise control will be successfully activated. Taking the Malibu XL 2021 535T Automatic Sharp Edition as an example, this car is a 4-door, 5-seater sedan with dimensions of 4933mm in length, 1854mm in width, and 1472mm in height. It is equipped with a 1.5T turbocharged engine and a 9-speed automatic transmission, delivering a maximum power of 124kW, a maximum torque of 250Nm, and a maximum horsepower of 116PS. The top speed is 205km/h, with a front-wheel-drive layout. The front suspension uses a MacPherson independent suspension, while the rear suspension employs an E-type multi-link independent suspension, featuring a unibody structure.
12
5
Share

What is the no-load voltage of a 12-volt battery charger?

12-volt battery chargers typically have a no-load voltage higher than 12 volts, usually around 15 volts. The key factors in charging are the current and the battery voltage after charging. As long as the charging current is normal and the battery voltage does not exceed 14.5 volts when fully charged, there is no need to worry about the no-load voltage. Here is more information about car batteries: Car voltage regulator: The limiting voltage of a car voltage regulator is not sufficient to fully charge the battery. When the regulator's limiting voltage is normal, during the charging process by the generator, each cell can only be charged to about 2.4V. Battery charger: The battery charger uses imported power modules and is the latest high-frequency electronic circuit intelligent automatic charger with low loss and high efficiency. The charger also has a reverse connection protection function. If it is not connected or the polarity is reversed, there will be no voltage output. It will only work properly when correctly connected and also has protections against overvoltage, overcurrent, and overheating.
14
0
Share

Will the car horn return to normal after getting wet and sounding quieter?

It can become louder. After the moisture inside the horn evaporates, the sound of the horn will return to normal. Generally, if the horn is not severely water-damaged, no excessive treatment is needed, and the moisture inside the horn can be allowed to evaporate naturally. Here are some related methods for dealing with severely water-damaged horns: 1. Use a hairdryer to dry: For horns located in accessible positions where a hairdryer can reach directly, you can use a hairdryer to heat the moisture inside, promoting rapid evaporation. Of course, once the moisture evaporates, the sound will return to normal. 2. Disassemble and clean: Remove the horn directly and thoroughly clean the moisture inside. Since most vehicle horns are located inside the bumper, it is difficult to remove the horn without dismantling the bumper. Therefore, disassembly and cleaning should be done at a professional 4S shop. 3. Replacement: For horns damaged by severe water ingress, the only solution is to replace the part.
17
4
Share

How to Open the Tow Hook Cover on a Sagitar?

The method to open the tow hook cover on a Sagitar is: repeatedly press around the edges of the tow hook cover at the lower part of the bumper until you find the right angle to pop it open. If it doesn't open easily, this may be due to prolonged non-use making the cover tight; in such cases, you can use a flathead screwdriver or car key to pry it open. Taking the Sagitar 2020 200TSI Manual Fashion model as an example, the vehicle dimensions are 4753mm in length, 1800mm in width, and 1462mm in height, with a wheelbase of 2731mm and a fuel tank capacity of 50 liters. It features a MacPherson strut front suspension and a multi-link independent rear suspension. The car is equipped with a 1.2L turbocharged engine delivering a maximum horsepower of 116PS, maximum power of 85kW, and maximum torque of 175Nm, paired with a 5-speed manual transmission.
15
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.