Can I Apply for a Replacement Vehicle License Online?

What is the spark plug model for the New Alto?

The spark plug model for the New Alto is NGK platinum spark plugs. Under normal maintenance conditions, car spark plugs should be replaced after driving 40,000 to 60,000 kilometers. However, this may vary depending on the brand and engine, so it is recommended to follow the user manual. The following standards can be used as a reference for maintenance and replacement: platinum spark plugs should be replaced at 40,000 kilometers, ordinary nickel alloy spark plugs at 20,000 kilometers, and iridium spark plugs at 60,000 to 80,000 kilometers. Steps for replacing spark plugs: Open the hood, lift the plastic cover of the engine, remove the high-voltage wires, and mark each cylinder's position to avoid confusion. Use a spark plug socket to remove the spark plugs one by one. While removing them, check for external debris like leaves or dust and ensure they are cleaned thoroughly. Place the new spark plug into the spark plug hole, hand-tighten it a few turns, and then use the socket to tighten it further. Reinstall the removed high-voltage wires according to the firing order and secure the cover.

9

5

Share

What kind of road surface is indicated when the headlights change from far to near?

When driving, if the headlight illumination distance changes from far to near, it indicates that the vehicle is approaching an uphill slope, or is nearing the bottom of a downhill slope, or is approaching a curve. Additional information: 1. From near to far: When the headlight illumination distance changes from near to far, it indicates a sharp curve ahead, a large pothole, the vehicle reaching the top of a hill, or an upcoming steep downhill slope. 2. Moving from the center to the side of the road: When the headlights shift from the center to the side of the road, it indicates an upcoming curve in the opposite direction of the illuminated side. If the lights shift from one side of the road to the other, it means the vehicle is entering a series of curves. 3. Shadows appearing and disappearing: If shadows continuously appear on the road ahead and disappear as the vehicle approaches, it indicates shallow continuous depressions on the road. If the shadows do not disappear, there may be significant depressions or transverse ditches. 4. Dim light: If the headlights illuminate the road surface with dim light, it indicates an asphalt road. If the road appears bright and the light is clear, it indicates a gravel road.

18

1

Share

Examination Process After One Year of Holding a B2 Driver's License?

B2 driver's license examination after the one-year probation period mainly tests knowledge of road traffic safety laws and regulations, safe and civilized driving, emergency handling, etc. After the exam, there is also a mandatory traffic accident case warning education session lasting no less than half an hour. Even with a perfect score, the exam is still required. Basic introduction to B2 driver's license: 1. Purpose of B2 driver's license: It allows driving heavy and medium-duty trucks or large, heavy, and medium-sized special-purpose vehicles. Heavy and medium-duty trucks are mostly trucks, such as the large dump trucks commonly seen on roads, which fall under the category of heavy-duty trucks. Large, heavy, and medium-sized special-purpose vehicles refer to vehicles equipped with special devices or equipment, such as sprinkler trucks, concrete mixer trucks, fire trucks, etc. 2. Other permitted vehicle types: Other vehicle types permitted under the B2 license include C1 (small cars), C2 (small automatic transmission cars), C3 (low-speed trucks), C4 (three-wheeled cars), and M (wheeled self-propelled machinery), which is the same as the B1 driver's license.

2

5

Share

Why is the brake of Buick Excelle soft?

There are several reasons for the soft brake of Buick Excelle: 1. Air in the brake oil pipe: If air enters the oil pipe, the brake oil will appear insufficient in strength under high pressure. Although there is still braking force, the maximum braking force is significantly weakened. At this time, the air should be exhausted at the maintenance station in time; 2. Water in the brake: The brake system is actually composed of a set of hydraulic system. The brake caliper is braked by the hydraulic transmission of brake oil. When braking, the brake pads and brake discs generate heat through friction. These heat is transmitted to the brake oil through the brake cylinder, eventually leading to the increase of the temperature of the brake oil. When the brake oil is at high temperature, water will vaporize to form compressible gas. These gases are not fixed in position and quantity in the brake pipeline, resulting in soft brakes; 3. Oil leakage in the brake oil pipe: Oil leakage in the brake master cylinder or brake oil pipe cannot ensure sufficient oil pressure; 4. Replacement of oversized tires: Too large tires will lead to insufficient brake torque and weakened braking force; 5. The brake pads are too soft: The material of the brake pads is too soft and the high-temperature performance is poor. Brake pads that meet national standards should be replaced.

20

1

Share

What are the models of oil nozzles?

The models of oil nozzles include M10*1, M8*1, and M6*1. More information about oil nozzles is as follows: 1. Low-pressure oil nozzle: Uses the power of combustion air to atomize fuel oil. Its advantages are lower power consumption for atomization and better atomization quality. The disadvantages are the complex structure of the nozzle itself, limited air preheating temperature, and smaller nozzle specifications. It is suitable for small heating furnaces without superheated steam. 2. High-pressure oil nozzle: Uses high-pressure superheated steam or compressed air for atomization, providing good and stable atomization quality. The combustion air does not directly contact the oil spray port, so air preheating is not limited, and the adjustment range is relatively large. It is easy to automate in centralized control and air-fuel ratio adjustment. The disadvantage is slightly higher energy consumption for atomization. This nozzle is suitable for large and medium-sized heating furnaces or general heating furnaces with superheated steam supply. 3. Mechanical atomization oil nozzle: A typical mechanical atomization oil nozzle is a high-speed rotating cup-shaped device. The oil forms a thin film adhering to the cup wall in the rotating cup and is atomized by centrifugal force at the cup mouth. Due to its rotating mechanism, this nozzle has a complex structure, and the atomization flame angle is too large, making it rarely used in heating furnaces.

3

Share

Where is the center point of the wiper?

The midpoint of the wiper is usually marked on training vehicles. If there is no mark, you can communicate with the instructor or classmates. The midpoint of the wiper refers to the middle position of the wiper when it stops in its original position on the front windshield. Since there is no mark, you need to rely on your own judgment. More information about wipers is as follows: 1. Determining the position of the left wheel: You need to know where the left wheel will pass to avoid the tire pressing on solid lines or obstacles like potholes and stones on the road. When the line of sight aligns the protruding node of the left wiper with an object on the ground, the left wheel will pass over that object. For example, if the wiper node aligns with the centerline on the ground, the tire will pass over the centerline. 2. Driving 60 centimeters from the centerline: Maintaining a distance of 60 centimeters from the centerline is generally safe during normal driving. When the line of sight aligns the lower left corner of the front windshield with the road centerline, the vehicle body is exactly 60 centimeters away from the centerline. 3. Determining the position of the right wheel: When the line of sight aligns the right wiper with the target, the tire will pass over that target.

10

4

Share

Can I Apply for a Replacement Vehicle License Online?

What is the spark plug model for the New Alto?

What kind of road surface is indicated when the headlights change from far to near?

Examination Process After One Year of Holding a B2 Driver's License?

Why is the brake of Buick Excelle soft?

What are the models of oil nozzles?

Where is the center point of the wiper?

How Many Parts Does a Car Chassis Consist Of?

How Long Does It Take to Charge a New Energy Electric Vehicle?

Must a driver's license renewal be processed locally when it expires?

How to Deal with Fogging on the Outside of the Car Windshield on Rainy Days?