Can Fault Codes Still Be Detected After Being Cleared?

1 Answers
GiaAnn
07/30/25 6:47am
Fault codes are generally stored. Additional information: 1. Passenger cars are primarily designed and technically characterized for transporting passengers and their personal belongings and/or temporary items, including the driver's seat, with a maximum of 9 seats. 2. Passenger cars are divided into the following 11 types. Mainly including: standard passenger cars, convertible passenger cars, luxury passenger cars, compact passenger cars, roadsters, hatchback passenger cars, station wagons, multi-purpose passenger cars, forward control passenger cars, off-road passenger cars, and special-purpose passenger cars. 3. Commercial vehicles are designed and technically characterized for transporting people and goods, and can tow trailers, but do not include passenger cars. Mainly including: buses, semi-trailer tractors, and trucks.
Was this review help?
17
3
Share
More Forum Discussions

What to Do During the Driving Test (Subject Three) on a Rainy Day?

When encountering rainy weather during the Subject Three road test, it's important to reduce speed, maintain a safe distance, and control the throttle. Additionally, use the windshield wipers to clear rainwater; otherwise, the water on the windshield can blur visibility and compromise driving safety. Key points to remember during the Subject Three road test on a rainy day: 1. Adjust Your Mindset If it rains during the Subject Three test, first adjust your mindset—stay calm and avoid being affected by the weather. 2. Control Your Speed Drive slower than usual during rainy conditions. Safety comes first, and examiners also prioritize safe driving over test performance. 3. Maintain a Safe Distance Keep a sufficient distance from the vehicle ahead during the test. Avoid sudden braking; instead, use gentle or intermittent braking to prevent test failure. 4. Manage the Throttle When passing through waterlogged areas or under bridges, shift to a low gear, maintain steady throttle control, and proceed slowly without stopping, shifting gears, or making sharp turns to avoid stalling the vehicle. 5. Use Windshield Wipers Since practice sessions often occur in good weather, you might forget about the wipers. However, during the rainy test, remember to turn them on. The wiper switch is located on the lower right side of the steering wheel, opposite the turn signal switch. Adjust the wiper speed according to rainfall intensity.
14
0
Share

What are the dimensions of the trunk of the 2020 Haval H6?

2020 Haval H6 trunk dimensions: trunk height is 910mm, maximum depth is 1620mm, minimum depth is 1010mm, and minimum width is 1040mm. Relevant details are as follows: 1. The Haval H6's luggage compartment has a volume of 808L, which can be expanded to a maximum of 2010L when the rear seats are folded down. The luggage compartment is pre-equipped with two horizontal partitions, allowing the space to be divided into three independent areas for convenient storage of miscellaneous items. 2. In terms of trunk space, the interior of the Haval H6 is relatively flat, and the net pocket on the right side can be used to store small items that are prone to rolling around.
10
3
Share

How to Adjust Car Air Conditioning Temperature?

Taking the Hyundai Elantra's air conditioning system as an example: The cabin allows direct control of air conditioning functions. The left knob adjusts the temperature (higher/lower), the middle knob controls airflow volume, and the right knob regulates vent direction. The AC button activates the cooling function - press to engage cooling. Adjust settings according to personal preference. A car's air conditioning system performs four essential functions: cooling, heating, ventilation, and air purification. It creates a comfortable cabin environment, reduces driver fatigue, and enhances driving safety. Modern vehicle air conditioners have become a standard feature indicating comprehensive automotive functionality. Contemporary automotive AC systems provide four core capabilities: 1) Temperature regulation - heating or cooling air to maintain optimal cabin comfort; 2) Humidity control - removing moisture to improve comfort by facilitating sweat evaporation; 3) Fresh air intake - providing proper ventilation; 4) Air filtration - eliminating dust and pollen from circulated air.
16
2
Share

What is the real fuel consumption of Hyundai ix35?

The real fuel consumption of the Hyundai ix35 2.0L model is an average of 8.8L/100km, calculated after consuming 9.2 liters of 92-octane gasoline to complete 105 kilometers of mixed road conditions at an average speed of 30.5km/h. Below is the official fuel consumption data from the Ministry of Industry and Information Technology for the Hyundai ix35: 1. The Beijing Hyundai 1.4T, 7-speed dual-clutch model has an official combined cycle fuel consumption of 6.2L/100km. 2. The Beijing Hyundai 2.0L, 6-speed automatic transmission two-wheel drive model has an official combined cycle fuel consumption of 7.1L/100km. 3. The Beijing Hyundai 2.0L, 6-speed automatic transmission four-wheel drive model has an official combined cycle fuel consumption of 7.8L/100km.
6
5
Share

What Causes the Engine Malfunction Light to Illuminate After Driving Through Water?

There are primarily 7 reasons why the engine malfunction light illuminates: Sensor Failure: The sensors mentioned here include coolant temperature, crankshaft position, air flow, intake air temperature, oxygen sensors, etc. When these sensors are damaged, have poor contact, or experience signal interruption, the vehicle's ECU cannot accurately obtain engine data, which triggers the engine malfunction light. Fuel or Oil Quality Issues: If fuel or engine oil is not added as required by the manufacturer, it may cause engine wear, leading to the illumination of the malfunction light. Poor Combustion of Air-Fuel Mixture: Poor combustion can result in engine carbon buildup or knocking. When detected by the oxygen sensor and reported to the ECU, the malfunction light will illuminate as a warning. Spark plug failure, ignition coil failure, fuel pump failure, or clogged fuel lines can all cause poor combustion of the air-fuel mixture in the engine. Turbocharger Issues: The intake boost pipeline or turbocharger can also cause the engine malfunction light to illuminate. The most common issue is turbocharger damage, accompanied by symptoms such as oil leakage, excessive oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust pipe. Intake Problems: If the vehicle's intake system malfunctions, it may lead to clogged engine pipelines, and in severe cases, trigger the engine malfunction light. A dirty air filter that hasn't been cleaned regularly can cause intake problems. Exhaust Problems: Exhaust system failures can also cause the engine malfunction light to illuminate. Common causes include rear oxygen sensor failure, catalytic converter issues, or faults in the exhaust camshaft and bearings. The catalytic converter is the most frequently affected component. Using leaded gasoline, lead- or silicon-based lubricant additives, physical damage to the catalytic converter, or fuel system failures can easily lead to catalytic converter problems. Anti-Theft System Malfunction: If the vehicle's electronic anti-theft system fails or if the anti-theft controller does not match the engine electronic controller, the anti-theft system can prevent the engine from operating normally, and the engine malfunction light will illuminate. If the engine malfunction light illuminates, follow these steps: First, check if the engine is running normally and whether there are issues such as shaking or smoke. If so, avoid restarting the engine. Particularly, do not restart the engine if a red warning light is illuminated. If the engine can start, turn it off for 5-10 minutes. Then, without pressing the brake, press the start button once or turn the key halfway to the 'ON' position without depressing the clutch. The vehicle will enter self-test mode after powering on. Wait for 5-10 seconds and observe whether the malfunction light on the dashboard turns off. If the malfunction light remains on, visit a service station as soon as possible for diagnosis. The service station can use a portable diagnostic tool to read the fault codes, identify the issue, and perform targeted repairs.
20
4
Share

What is the minimum age requirement for obtaining a driver's license?

Generally speaking, you can apply for a driver's license at the age of 18 or above. However, different types of driver's licenses have different age requirements. According to Article 11 of the Regulations on the Application and Use of Motor Vehicle Driver's Licenses (Ministry of Public Security Order No. 71), the age requirements for applying for a motor vehicle driver's license are as follows: 1. For small cars, small automatic transmission cars, and light motorcycles, the applicant must be between 18 and 70 years old. 2. For low-speed trucks, three-wheeled cars, ordinary three-wheeled motorcycles, ordinary two-wheeled motorcycles, or wheeled self-propelled machinery, the applicant must be between 18 and 60 years old. 3. For city buses, medium-sized buses, large trucks, trolleybuses, or trams, the applicant must be between 21 and 50 years old. 4. For tractor licenses, the applicant must be between 24 and 50 years old. 5. For large passenger vehicle licenses, the applicant must be between 26 and 50 years old.
20
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.