Can China VI vehicles use fuel from private gas stations?

What is the oil pressure of a diesel engine?

Diesel engine oil pressure is 3 to 5 units, and it is 1 unit at idle speed. A diesel engine is an engine that burns diesel to obtain energy release. Its working process is the same as that of a gasoline engine, with each working cycle also going through four strokes: intake, compression, power, and exhaust. In the intake stroke, a diesel engine draws in pure air. Near the end of the compression stroke, the diesel fuel is pressurized to over 10MPa by the fuel injection pump and then injected into the cylinder through the fuel injector, where it mixes with the compressed high-temperature air in a very short time to form a combustible mixture. Due to the high compression ratio of diesel engines, the air pressure in the cylinder at the end of compression can reach 3.5 to 4.5MPa, while the temperature reaches 750 to 1000K, exceeding the auto-ignition temperature of diesel. Therefore, after the diesel is injected into the cylinder, it mixes with the air and spontaneously ignites and burns almost immediately.

11

2

Share

What engine does the Jaguar E-PACE use?

Jaguar E-PACE is equipped with two types of 2.0-liter turbocharged engines, one is a low-power version and the other is a high-power version. The low-power 2.0-liter turbocharged engine delivers 200 horsepower and a maximum torque of 320 Nm, while the high-power 2.0-liter turbocharged engine produces 249 horsepower and a maximum torque of 365 Nm. Both engines feature direct fuel injection technology and use aluminum alloy cylinder heads and blocks. In terms of safety, the Jaguar E-PACE has a MacPherson independent front suspension and a multi-link independent rear suspension, and it is a front-engine, all-wheel-drive model. The dimensions of the Jaguar E-PACE are 4411 mm in length, 1900 mm in width, 1649 mm in height, with a wheelbase of 2681 mm.

3

5

Share

What does SRS mean on a car?

SRS stands for Supplemental Restraint System, which refers to the airbag system. The airbag system is a passive safety protection system (see vehicle safety performance) that works in conjunction with seat belts to provide effective collision protection for occupants. Airbags distribute the impact force evenly across the head and chest. The concept of airbags was first proposed by John W. Hetrick in August 1953, who obtained a U.S. patent for an "automobile safety cushion assembly." With the establishment of vehicle safety standards in various countries, the installation rate of airbags has been increasing. The working principle of a car airbag is as follows: When a collision occurs during driving, the airbag sensor first receives the impact signal. If the impact reaches the specified intensity, the sensor activates and sends a signal to the electronic controller. The electronic controller compares this signal with its stored data. If the conditions for airbag deployment are met, the controller sends a start signal to the gas generator in the airbag module via the drive circuit. Upon receiving the signal, the gas generator ignites the gas-producing agent, generating a large volume of gas. This gas is filtered and cooled before entering the airbag, causing it to rapidly inflate within milliseconds. The airbag forms an elastic cushion in front of the driver or passenger, then deflates and contracts to absorb the impact energy, effectively protecting the head and chest from injury or reducing the severity of injuries. A standard airbag must activate within 0.01 seconds after a collision, with the ignition device firing within 0.03 seconds, high-pressure gas entering the airbag within 0.05 seconds, the airbag expanding outward within 0.08 seconds, and fully inflating within 0.11 seconds. The Supplemental Restraint System (SRS), or airbag system, serves as an auxiliary device to seat belts for occupant restraint. It is a supplementary protection system that includes components such as sensor assemblies, inflators, folded airbags, igniters, solid-state nitrogen, and warning lights. According to vehicle test data, when a collision occurs and the airbag deploys, it can reduce the likelihood of head injuries by approximately 25% and facial injuries by about 80%. A typical airbag system consists of two main components: the collision detection ignition device (or sensor) and the gas-generating airbag (or cushion). When the sensor switch is activated, the control circuit begins operating and uses detection loops to determine if a collision has occurred. The airbag will only deploy if signals are received simultaneously from two sensors. Since the car's generator and battery are usually located in the front of the vehicle, which is prone to damage, the airbag control system has its own power supply to ensure functionality. Once the conditions for airbag deployment are confirmed, the control circuit sends current to the igniter, which rapidly heats up and ignites the sodium azide propellant inside. The airbag system mainly consists of four parts: collision sensors, the airbag control unit (ACU), the SRS indicator light, and the airbag module. Collision Sensors: Collision sensors are the primary input devices for control signals in the airbag system. Their role is to detect the intensity of a collision and send the signal to the ACU, which then determines whether to activate the inflator to deploy the airbag. Most airbag systems are equipped with 2-4 collision sensors, typically located on the left and right front fenders, the front bumper, or inside the cabin. Most collision sensors use an inertial mechanical switch structure. Collision sensors consist of a housing, an eccentric rotor, an eccentric weight, fixed contacts, and rotating contacts. A resistor R is also fixed outside the sensor to check for open or short circuits in the wiring between the ACU and the front airbag collision sensor during system self-tests. Under normal conditions, the eccentric rotor and weight are held against a stopper by a spiral spring, keeping the rotating and fixed contacts separate (switch "OFF"). During a collision, the inertial force causes the eccentric weight to rotate the rotor against the spring force. If the collision intensity meets the threshold, the rotor's rotation closes the contacts, sending an "ON" signal to the ACU. The ACU only triggers the inflator upon receiving this signal. Some vehicles also have side airbags, which require additional collision sensors on the sides to detect lateral impacts. Airbag Control Unit (ACU): The ACU is the control center of the airbag system. It receives signals from collision sensors and other sensors, decides whether to deploy the airbag, and performs self-diagnostics for system faults. The ACU continuously tests critical circuits (e.g., sensor circuits, backup power circuits, ignition circuits, SRS indicator light, and its driver circuit) and displays results via the SRS light and fault codes stored in memory. The SRS indicator on the dashboard provides the driver with system status information. Fault codes and status information can be retrieved using specialized tools or through the serial communication interface for inspection. Signal Processing Circuit: This circuit includes amplifiers and filters to shape, amplify, and filter sensor signals for the ACU to receive, identify, and process. Power Supply: The airbag system has two power sources: the vehicle's power (battery and alternator) and a backup power supply. The backup power consists of a power control circuit and capacitors. In single-airbag systems, there is one backup power for the ACU and one for the igniter. Dual-airbag systems have one ACU backup and two igniter backups (one for each ignition circuit). The backup power ensures the system remains operational for up to 6 seconds if the main power is cut during a collision. After 6 seconds, the backup power's capacity diminishes, and the system may fail to deploy the airbag. Protection and Voltage Regulation Circuits: To prevent damage from voltage spikes caused by inductive loads or sudden current changes in the vehicle's electrical system, the ACU includes protection circuits. Voltage regulation circuits ensure the airbag system functions correctly despite fluctuations in the vehicle's power supply. SRS Indicator Light: The SRS light, also known as the SRS warning or caution light, is located on the dashboard and labeled with "SRS" or "AIRBAG." It indicates whether the airbag system is functioning properly. When the ignition is turned to "ON" or "ACC," the light should illuminate or flash for about 6 seconds and then turn off, indicating normal operation. If the light stays on, fails to light, or activates while driving, it signals a fault that requires attention. The self-diagnosis system stores fault codes for troubleshooting. Note that after an airbag deployment, fault codes may not be retrievable, and the ACU must be replaced. Airbag Module: The airbag module consists of an inflator and the airbag, installed in the steering wheel or dashboard and not serviceable. The inflator includes a squib, ignition powder, and a gas-generating agent. The airbag is made of nylon fabric coated with resin. During a collision, the sensors trigger the ACU, which activates the squib. The squib ignites the gas-generating agent, producing gas that inflates the airbag, cushioning the impact for the driver and passengers.

12

2

Share

How Long Does It Take to Fully Charge a Car After Starting?

It takes about two hours to fully charge a car after starting. Factors such as the battery's discharge level, whether high-power devices are being used inside the car, the vehicle's RPM, and whether the air conditioning is turned on can all affect the charging time. The car's alternator is responsible for charging the battery, and the alternator's power source comes from the engine. Once the car is started, the engine begins to operate, transferring power to the alternator via a belt, which then starts charging the battery. A car battery, also known as a storage battery, is a type of battery that works by converting chemical energy into electrical energy. Car batteries are categorized into conventional lead-acid batteries, dry-charged batteries, and maintenance-free batteries.

19

4

Share

How to Replace the Battery in a Kia Sportage Key Fob?

The method to replace the battery in a Kia Sportage key fob is as follows: First, use a screwdriver to remove the remote cover, gently detach the key blade, insert the screwdriver into the hole, turn it clockwise to completely separate the two parts of the remote. After opening, remove the old battery, disassemble the circuit board, and finally replace it with a new battery. The Kia Sportage is equipped with a 1.4L turbocharged engine, paired with a 7-speed dual-clutch transmission, delivering a maximum power of 103 kW and a maximum torque of 242 Nm. In terms of appearance, the Kia Sportage offers 9 color options: Ebony Black, Crystal White, Titanium Silver, Diamond Silver, Tomato Red, Sunset Orange, Mineral Silver, Sand Gold, and Grape Blue. The front suspension features a MacPherson strut independent suspension, while the rear suspension is a multi-link independent suspension. The vehicle dimensions are 4460mm in length, 1850mm in width, and 1695mm in height, with a wheelbase of 2640mm.

13

5

Share

What are the differences between the Trumpchi GS5 235T and 270T?

The differences between the Trumpchi GS5 235T and 270T are as follows: 1. Different emission standards: All 235T models comply with the China 5 emission standard, while all 270T models meet the China 6 emission standard. 2. Different power outputs: The 235T model is a low-power version of the 1.5T engine, whereas the 270T model is a high-power version. The 235T model has a maximum power of 112 kW and a maximum torque of 235 Nm, while the 270T model delivers a maximum power of 124 kW and a maximum torque of 265 Nm. In terms of transmission, one variant of the 235T is equipped with a 6-speed manual transmission, while the rest, like the 270T models, come with a 6-speed automatic transmission.

11

4

Share

Can China VI vehicles use fuel from private gas stations?

What is the oil pressure of a diesel engine?

What engine does the Jaguar E-PACE use?

What does SRS mean on a car?

How Long Does It Take to Fully Charge a Car After Starting?

How to Replace the Battery in a Kia Sportage Key Fob?

What are the differences between the Trumpchi GS5 235T and 270T?

What grade of gasoline should be used for the BMW X5?

What is the structural composition of an automatic transmission?

What are the length and width of the Baojun RM5 body?

How to adjust the time on Jiake car dash cam?