Browse

Antiques Collectibles Apparel Baby Kids Items Books， Movies And Music Electronics Free Stuff Garden Outdoor Health Beauty Home Goods Home Improvement Supplies Musical Instruments Office Supplies Pet Supplies Sporting Goods Ticket Toys Games Transportation Others

Used Cars New Cars Others

Business Crafts Design And Web Events Home Improvement Legal Lessons Personal Pets Photography Repair And Technical Support Wellness Writing， Translation， And Transcription Others

Activities & Groups Artists & Musicians Classes & Lessons Events Friendship & Networking Lost & Found Rideshare Sports Teams Volunteers Travel & Travel Partners Skills & Language Swap Other

Can an automatic transmission license drive a manual-automatic integrated car?

1 Answers

SanFelicity

07/29/25 11:37pm

An automatic transmission license can drive a manual-automatic integrated car. A manual-automatic integrated car also belongs to the automatic transmission category. According to regulations, a C2 license can drive small and micro automatic transmission passenger cars, as well as light and micro automatic transmission cargo vehicles. Since a manual-automatic transmission is actually a type of automatic transmission, it is permissible. A manual-automatic transmission combines manual gear shifting with automatic gear shifting. Essentially, it is still an automatic transmission that simulates the operation of a manual transmission through an electronic control system. The manual-automatic transmission is designed to enhance the fuel efficiency and controllability of automatic transmissions, allowing the driver to decide the gear shifting timing instead of the computer. At the same time, in urban traffic congestion situations, the automatic mode can still be used for convenience.

Was this review help?

6

4

Share

More Forum Discussions

What to Do If the Rear Bumper of the Car Is Scratched?

The solutions for a scratched rear bumper of the car are: 1. Minor scratches: If the paint damage is on the surface layer of the topcoat, it can be completely repaired by waxing; 2. Large-area scratches: A touch-up pen can be used for treatment. Bumpers are made of plastic, and scratches that are left untreated will not affect the quality of the car. Composition of the car bumper: 1. The outer panel and cushioning material are made of plastic, and the crossbeam is a U-shaped channel pressed from cold-rolled thin plates about 1.5 mm thick; 2. The outer panel and cushioning material are attached to the crossbeam, and the crossbeam is connected to the frame longitudinal beam with screws, allowing it to be detached at any time.

What does reduced engine power in the Chevrolet Malibu XL mean?

There are five reasons for reduced engine power in the Chevrolet Malibu XL, as detailed below: The causes of reduced engine power in the Chevrolet Malibu XL are poor gasoline quality, clogged fuel lines, improper tire pressure, excessive carbon buildup, and a dirty throttle body. Additional precautions for using a car engine: Avoid coasting in neutral: The engine itself has a fuel-cut function during deceleration, and coasting in neutral is not conducive to fuel economy. Pay attention to observation while using the vehicle. If oil is found on the ground, determine whether there is an engine oil leak and promptly communicate with the car dealership to eliminate potential safety hazards. If water is mixed into or absorbed by the brake fluid, it should be replaced or carefully filtered immediately. Otherwise, it may lead to insufficient braking pressure, affecting braking performance.

What are the reasons why a manual transmission car suddenly cannot shift gears?

Reasons why a manual transmission car suddenly cannot shift gears: 1. Failure of the P-gear lock solenoid valve. This solenoid valve requires a signal from the brake pedal to release, so these two components are interconnected. If either component fails, it will prevent the gear lever from being pushed out of P-gear into other gears; 2. Internal failure of the gear lever assembly, causing the gear lever to get stuck. Difficulty in moving it back and forth leads to the inability to shift gears or difficulty in shifting; 3. Incomplete clutch disengagement, caused by failure of the clutch disc or clutch pressure plate. This requires replacement of the clutch three-piece set (friction disc, pressure plate, and release bearing); 4. Presence of debris in the transmission oil affecting the gear shifting of manual transmission cars.

What Causes the Exhaust Pipe to Make a Puffing Sound?

Exhaust pipe puffing noises may be caused by individual exhaust valve erosion or poor sealing, individual intake valve sealing failure with severe air leakage, carbon deposits at the contact surfaces between certain intake/exhaust valves and their seats, zero clearance on some valve stems, uneven adjustment or blockage of one idle jet in dual-barrel carburetors. When engine speed increases, the relative air leakage rate of valves decreases, resulting in smoother engine operation and disappearance of the exhaust pipe puffing sound. After identifying the fault nature, use the single-cylinder cut-off method to locate cylinders with leaking valves. There are many reasons for valve leakage. To simplify diagnosis, first remove the valve cover and inspect the valve stem clearance of non-operating cylinders. If normal, proceed with valve lapping. Intake valves only cause cylinder misfire at low speeds when severely leaking, occasionally accompanied by carburetor backfire during driving.

How to Use Cruise Control in the X-Trail?

To use the cruise control in the X-Trail: Press the SET button to activate it, and the CANCEL button to deactivate the cruise control. Cruise control, also known as speed control system or autonomous driving system, automatically maintains the vehicle's speed as set by the driver without the need to press the accelerator pedal. This allows the vehicle to travel at a constant speed, reducing driver fatigue and unnecessary speed fluctuations, which can save fuel. The X-Trail is a vehicle under Dongfeng Nissan, equipped with advanced technologies such as the ASCD cruise control system, rearview camera, side-view system, multimedia entertainment system, external temperature display, and intermittent multi-stage adjustable front wipers.

Where is the production location of Dongfeng Nissan?

Dongfeng Nissan's production bases are located in Huadu, Xiangyang, Dalian, and Zhengzhou. Dongfeng Nissan Passenger Vehicle Company is a passenger vehicle manufacturing enterprise under Dongfeng Motor Co., Ltd. The company is primarily engaged in the research and development, procurement, manufacturing, sales, and service of NISSAN brand passenger vehicles. The automotive brands under Dongfeng Nissan include: Bluebird, Tiida, Sylphy, Sylphy Zero Emission, and Teana. Taking the Bluebird as an example: The Bluebird has a length of 4683mm, width of 1780mm, height of 1465mm, a wheelbase of 2700mm, a body type of 4-door 5-seater sedan, a CVT continuously variable transmission, and a top speed of 185 kilometers per hour.

Trending Ranking

How to Set the Speed on the Volkswagen Lavida Screen?

How to Test if a Car Has an Electrical Leak?

What should be paid attention to for the first car maintenance?

What is the murano?

Which country produces Audi?

What is the minimum ground clearance of the Leiling?

When will BMW's new logo be used?

How Long Is the Warranty for Car Brake Discs?

What are the techniques for car window tinting?

How Long Do Platinum Spark Plugs Last?

More Forum Discussions

What Causes Steering Wheel Vibration at 100 km/h?

What is the tire model of the Mercedes-Benz E300?

Can Modified Car Wheels Pass Annual Inspection?

What does mph mean on a car?

Help

Cookie

Cookie Settings

© 2025 Servanan International Pte. Ltd.