Can an A2 driver's license with 3 points deducted be handled online?

Why Must Cars Have Their Engine Oil Changed?

Cars need engine oil changes for the following reasons: 1. To improve and enhance lubrication for moving friction components in the engine. 2. To extend the engine's service life. 3. To optimize the engine's lubrication conditions and reduce friction between moving parts. Steps for changing engine oil: 1. Lift the vehicle, remove the underbody shield, and place a container with approximately 10-liter capacity beneath the drain plug. 2. Loosen the drain plug, use an air gun to blow into the oil filler opening for two minutes. After complete drainage, tighten the drain plug and wipe it with a tissue to check for leaks. 3. Reinstall the underbody shield, lower the vehicle, and use a funnel to add new oil through the filler opening.

6

2

Share

Does the Porsche 718 Have Four Seats?

The Porsche 718 does not have four seats; it is a mid-engine, rear-wheel-drive model and a standard two-seater. The Porsche 718 is Porsche's entry-level sports car, equipped with a 2.0T inline 4-cylinder turbocharged engine, delivering a maximum horsepower of 250 PS, a maximum torque of 310 Nm, and a maximum power of 184 kW. It is paired with a 7-speed dual-clutch transmission. The dimensions of the Porsche 718 are: length 4379 mm, width 1801 mm, height 1295 mm, with a wheelbase of 2475 mm, a minimum ground clearance of 106 mm, and a body weight of 1365 kg.

6

1

Share

What are the causes of low oil pressure in the MG GS?

The causes of low oil pressure in the MG GS are: 1. The oil level in the oil pan is too low; 2. The oil passage before the oil pressure sensor is obstructed or the oil supply is insufficient; 3. The oil passage after the oil pressure sensor leaks oil too quickly; 4. The oil filter is clogged; 5. The oil pressure relief valve is faulty or the oil pressure spring is weak. Methods to troubleshoot low oil pressure: 1. Unscrew the oil dipstick to check if the oil in the oil pan is sufficient and not too thin; 2. Check if the oil pressure gauge and sensor are malfunctioning by disconnecting the sensor wire and grounding it directly; 3. Inspect the oil pipes for cracks, the pressure relief valve for sticking, and the oil filter for blockages; 4. Check the oil pump for wear.

18

0

Share

How to Set the Auto-Locking Function for Passat?

Passat auto-locking setting method is: 1. Press the vehicle power button twice; 2. Hold the lock button for 5 to 10 seconds until the hazard lights flash, indicating the auto-locking setup is complete. The advantages of auto-locking are: 1. Anti-theft; 2. Prevents accidental door opening while driving. Taking the 2020 Business Edition Passat as an example, its body dimensions are: length 4933mm, width 1836mm, height 1469mm, wheelbase 2871mm, fuel tank capacity 68.5l, and trunk capacity 521l. The 2020 Business Edition Passat is equipped with a 1.4L 4-cylinder turbocharged engine, delivering a maximum horsepower of 150ps, maximum power of 110kw, maximum torque of 250nm, paired with a 7-speed dual-clutch transmission.

7

1

Share

How to Turn Off the Engine Start-Stop Function?

To turn off the engine start-stop function, simply press the automatic start-stop switch located on the center console. The switch is a mechanical button featuring a capital letter A surrounded by an arrow ring. The primary purpose of this feature is to save energy and reduce exhaust pollution. By disabling the automatic start-stop, drivers can have better control over the vehicle. The engine automatic start-stop system automatically shuts off the engine when the vehicle comes to a temporary stop during driving and restarts it when it's time to move forward again. This system is implemented by integrating an enhanced motor with idle start-stop capability into a traditional engine. When the vehicle meets the idle stop conditions, the engine completely shuts down. When the vehicle needs to start moving again, the idle start-stop motor system quickly responds to the driver's command, restarting the engine instantly for seamless transition.

18

5

Share

What is the Audi model without a badge at the rear?

It can only be identified by its exterior appearance. Whether it's the smallest A1 model or the highest-performance R8, whether it's the extended L model or the performance RS model, all Audi vehicles have model badges at the rear. Generally, the absence of a rear badge is due to the owner's pursuit of individuality by deliberately removing it. Additional information: To determine the model, you can also check the vehicle's frame number. The frame number is very important, as it, along with the engine number, is required when registering the vehicle. If you cannot locate the frame number during registration, you can seek assistance from the vehicle registration office staff. The car engine number contains relevant signals about the engine, while the car's frame number is called the VIN code, which is equivalent to a car's ID number. Each vehicle's frame number is unique.

15

0

Share

Can an A2 driver's license with 3 points deducted be handled online?

Why Must Cars Have Their Engine Oil Changed?

Does the Porsche 718 Have Four Seats?

What are the causes of low oil pressure in the MG GS?

How to Set the Auto-Locking Function for Passat?

How to Turn Off the Engine Start-Stop Function?

What is the Audi model without a badge at the rear?

What does 102v tire mean?

What is the method for installing a license plate?

What is the function of the button on the gear shift lever of an automatic transmission car?

What is the normal range for oil pressure?