···
Log in / Register

Can a Newly Installed Pedal on a Car Be Registered?

4 Answers
VanElliott
07/29/25 5:21pm
Newly installed pedals on a car cannot be registered. Before registration, the vehicle's exterior must match the photo. The photo must be consistent with the content of the vehicle's certificate. Vehicle Modification Recommendations: If modifications are desired, it is advisable to wait until after obtaining the license plate to make changes. Additionally, modifications must comply with the "Motor Vehicle Registration Regulations"; otherwise, they will be considered illegal modifications, subject to penalties such as fines by traffic police. Article 9 of the "Motor Vehicle Registration Regulations" states that registration will not be granted under the following circumstances: If the proofs and certificates submitted by the vehicle owner are invalid; if the vehicle's origin certificate has been altered or the vehicle owner listed on the origin certificate does not match the identity proof; if the proofs and certificates submitted by the vehicle owner do not match the vehicle; If the vehicle is produced without the approval of the State Council's motor vehicle product authority or imported without the approval of the national import motor vehicle authority; if the vehicle's technical data does not match the data announced by the State Council's motor vehicle product authority; If the vehicle's model, engine number, vehicle identification number, or other technical data do not comply with national safety technical standards; if the vehicle has reached the mandatory scrapping standard set by the state; if the vehicle has been legally seized or impounded by the People's Court, People's Procuratorate, or administrative law enforcement departments; if the vehicle is stolen; or other circumstances that do not comply with laws and administrative regulations.
Was this review help?
20
4
Share
McCarmen
08/14/25 8:08am
I also wondered about whether adding running boards to a new car would affect its registration when purchasing a vehicle. Based on experience, a new car must remain in its factory condition before its first registration. During the vehicle inspection at the DMV, they check for consistency between the vehicle certification and the actual car, and no major modifications are allowed. If the running boards are purely decorative side steps that don’t alter the vehicle’s height or chassis structure, they might not affect registration—but you must ensure they don’t obstruct lights or identification marks. If the running boards are too large or improperly positioned, the inspector might require their removal. So, it’s advisable not to rush into installing them right after getting the car; wait until after registration and have them installed at a reputable shop. This avoids unnecessary hassle and ensures smooth insurance and annual inspections later. I’ve seen a friend run into registration issues after installing running boards on a new car, ultimately costing extra for rework—just not worth it.
Was this review help?
18
5
Share
Expand All
LeAyla
10/13/25 6:29am
Haha, when I bought my SUV last year, I added running boards right away and had no issues with registration. The salesperson suggested completing the DMV procedures first before installation, explaining that new vehicle inspections focus on major modifications. Accessories like running boards are considered decorative as long as they don't obstruct pathways or exceed width limits, so the inspector didn't flag them. Just make sure they're installed securely without wobbling for safety. They've been super convenient, especially during rainy/snowy weather when getting in/out. Remember to get compliant product documentation from the shop for future proofing. Bottom line - don't rush to install boards on new cars; wait until after registration to avoid hassles. Don't cut corners like some online examples that ended up wasting trips.
Was this review help?
13
0
Share
Expand All
Gwendolyn
11/26/25 7:29am
It's best to install side steps on a new car after getting it licensed, as they may alter the vehicle's appearance or dimensions. Regulations require the vehicle to be in its original factory condition during license inspection, and the DMV will check the chassis and height. If the steps exceed limits or affect certified parameters, they may cause the inspection to fail. It's advisable to consult the 4S dealership when purchasing a new car, as they're familiar with local regulations. Like when I bought my car, I waited until after licensing to add them—simple modifications without hassle. Safety-wise, it's also reassuring, as improper installation can cause issues.
Was this review help?
16
3
Share
Expand All
More Forum Discussions

How Many Kilometers Should a New Car Drive Before Its First Maintenance?

It is recommended to perform the first maintenance on a new car after driving 5,000 kilometers. The first maintenance items include: 1. Check whether the liquid level of the car coolant meets the specified requirements; 2. Check the liquid level of the brake and clutch; 3. Check whether the oil level of the power steering oil tank meets the specified requirements, and check whether there is any oil leakage at the interfaces of the system oil pipes; 4. Check the liquid level of the battery and the windshield washer tank; 5. Check the tightness and aging of the belts of the generator, air conditioner, water pump, and power steering pump; 6. Check whether the front and rear lights of the car are complete; 7. Check the tire pressure and wear of the car tires, tighten the tire screws according to the specified torque, and supplement the tire pressure to the specified value for the model.
7
4
Share

How to Deal with Yellowing Plastic Headlight Covers?

The solutions for yellowing plastic headlight covers are: 1. Car owners can regularly maintain their vehicles by cleaning dirt and dust on the headlight surface with a clean soft cloth. Soapy water can also be used to wash the headlights, effectively removing surface contaminants like dirt and grease to prevent yellowing; 2. Sand the headlights with sandpaper and then polish them with specialized wax; 3. Apply sealing strips around the edges of the headlights, sand them with various grits of sandpaper, and finally apply a protective film using professional tools. The reason for yellowing plastic headlight covers is prolonged exposure to sunlight. Modern car headlight covers are made of polycarbonate plastic through compression molding. While this plastic is durable and transparent, it is still prone to oxidation and aging.
11
4
Share

What are the precautions for tire installation?

Tire installation precautions include: 1. Pay attention to installation direction and inflation. If using the original factory tires, follow the manufacturer's requirements for installation. For non-original tires, generally the side with the production date should face outward. For directional tires, the arrow on the tire should align with the vehicle's forward direction during installation; 2. During inflation, the tire can be inflated to its maximum allowable pressure first, then reduced to the standard pressure specified by the manufacturer. Tires are circular elastic rubber products assembled on various vehicles or machinery for ground rolling. They are usually mounted on metal rims to support the vehicle body, cushion external impacts, maintain contact with the road surface, and ensure driving performance.
1
0
Share

How to Replace the Wiper Blades on a Malibu?

To replace the wiper blades on a Malibu, follow these steps: 1. First, remove the old wiper blades by lifting the wiper arm and pulling the blade downward. 2. Install the new wiper blades by opening the wiper clip, aligning the blade with the hole on the arm, inserting the arm into the square hole of the blade, and securing it tightly. 3. Fasten the clip and press it firmly. The wiper is a blade structure installed in front of the windshield, composed of components such as the motor, reducer, four-bar linkage, wiper arm spindle, and wiper blade assembly. Its primary function is to clear rain, snow, and dust from the windshield that obstruct the driver's view. The Malibu has dimensions of 4855mm in length, 1854mm in width, and 1476mm in height, with a wheelbase of 2737mm. It is equipped with a 6-speed automatic transmission and can reach a top speed of 205 kilometers per hour.
20
0
Share

How to Remove the Wipers of Baojun 510?

The method to remove the wipers of Baojun 510 is simply to open the buckle on the wiper, then flip it 90 degrees, and pull it downward with force. The wiper is a blade structure installed in front of the windshield, composed of a motor, reducer, four-bar linkage, wiper arm spindle, wiper blade assembly, etc. Its main function is to clear rain, snow, and dust from the windshield that obstructs the view. In terms of safety features, the Baojun 510 is equipped with 4 airbags, ESP electronic stability system, tire pressure monitoring, anti-glare interior rearview mirror, reverse radar imaging, and four-wheel disc brakes, providing safety for drivers and passengers.
16
3
Share

What to Do If the Car Paint Gets Scratched?

The solutions for scratched car paint are: 1. For scratches that haven't damaged the primer, you can use a touch-up pen and then polish and wax the area; 2. For deeper scratches that reach the primer, it's recommended to visit a professional repair shop to determine if repainting or panel beating is needed; 3. For shallow scratches on the surface paint, you can use a compound. Apply it in straight lines until the scratch disappears, then use a finer compound and wax the area; 4. Use ordinary toothpaste by gently applying it in circular motions on the scratch. Reapply after rain or car washing to reduce the scratch mark and provide a simple protective layer to prevent rust.
11
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.