Can a car run with the water temperature at 100 degrees?

Can I Bring My Phone into the Car During the Driving Test (Subject 3)?

Yes. You can bring your phone during Subject 3 of the driving test, but it's recommended to turn it off to avoid distractions. Here are some related tips for Subject 3: 1. Starting details: Walk counterclockwise around the vehicle from the driver's door, return to the driver's door, enter the car, adjust the seat and fasten the seat belt, lightly press the accelerator to check if the dashboard is functioning normally. 2. Lightly pressing the accelerator: Turn on the left turn signal and observe the road conditions behind the vehicle; shift to 1st gear, slowly release the clutch to start the vehicle, lightly press the accelerator to increase speed, and shift gears up or down based on road conditions to ensure timely and unobstructed driving. 4. Using the brake: To control speed, remember to release the accelerator and lightly press the brake to solve the problem. First, it's about getting familiar with the vehicle and building confidence. Second, it's about knowledge and ability to handle road conditions calmly and effectively. 5. Smooth driving techniques: During gear shifting, to ensure smooth driving, after pressing the accelerator to increase speed, the right foot should only touch the accelerator, then press the clutch and shift gears sequentially without skipping gears.

17

1

Share

What causes the jerking sensation when driving the Qashqai?

The reasons for the jerking sensation when driving the Qashqai are as follows: 1. Severe wear: The friction plates inside the transmission are severely worn, with uneven surfaces, causing jerking during contact. 2. Worn plungers: The plungers inside the valve body are severely worn, leading to poor operation of the plungers within the valve body. 3. Uneven road surface: Generally, when driving on uneven roads, the vehicle will experience a jerking sensation. Relevant information about the Qashqai is as follows: 1. Qashqai: It is the first product developed by Nissan's European Design Center, positioned between a compact SUV and a hatchback. 2. Body dimensions: The length, width, and height are 4315/1783/1606mm respectively, with a wheelbase of 2630mm.

10

3

Share

Can I have my car inspected in another location? Do I need to go in person?

You can have your car inspected in another location, and it is not necessary for you to go in person for the annual inspection. Below is the relevant information about cross-regional vehicle inspection: 1. Required documents: Original ID card; Vehicle registration certificate; Copy of compulsory traffic insurance; Proof of vehicle and vessel tax; Authorization letter for cross-regional vehicle inspection. 2. Authorized annual inspection: You can personally bring the documents to apply and then return; Alternatively, you can authorize a local friend or relative to handle the authorization letter on your behalf. However, the vehicle owner needs to provide the authorized person with a power of attorney. The authorized person must bring their own ID card, the power of attorney, the owner's original ID card, vehicle registration certificate, copy of compulsory traffic insurance, and proof of vehicle and vessel tax to proceed with the inspection on your behalf. After the inspection is completed, these documents must be mailed back to the vehicle owner for the annual inspection.

4

3

Share

How often should the UY gear oil be changed?

UY gear oil should generally be changed every 60,000 kilometers. The specific details are as follows: 1. Purpose of replacement: It can effectively improve the efficiency of gear transmission of engine power. 2. Replacement interval: Mainly based on mileage or usage time. If the vehicle manual clearly provides these two indicators, the earlier one must be followed. Information about gear oil is as follows: 1. Gear oil: (Gear-oil) is a type of lubricating oil mainly composed of petroleum lubricating base oil or synthetic lubricating oil, with the addition of extreme pressure anti-wear agents and oiliness agents. 2. Function: Gear oil mainly lubricates gears and bearings, prevents wear and corrosion, helps dissipate heat from gears, and is used in various gear transmission devices to extend their service life and improve power transmission efficiency.

19

3

Share

What does it mean when the document status is locked on the Traffic Management 12123 app?

Traffic Management 12123 document status being locked may be due to unpaid traffic violations or a revoked driver's license. Below are detailed reasons for vehicle document status being locked: 1. Unpaid violations or DUI: There are outstanding traffic violations on the driver's license; there is a DUI record that has not been cleared. 2. Points deduction: There is a record of being penalized with 12 points at once that has not been cleared. 3. Revoked driver's license: The driver's license is in a revoked, suspended, or temporarily seized status. The driver's license may also have been fraudulently used, requiring an in-person visit to the traffic management department to clarify and resolve the issue, and to restore the driver's license to its normal status.

12

2

Share

Has the gear shifting in Subject 3 been canceled?

Subject 3 examination has not canceled the gear shifting, but the fixed voice prompts are no longer provided. Candidates are required to perform gear shifting operations based on the situation, and this series of operations is still mandatory and included in the scoring. Below are the test techniques for gear shifting in Subject 3: 1. Conditions for shifting gears: When shifting gears, the clutch must be fully depressed to shift, and the speed must meet the requirements of the corresponding gear. For example, shifting from first gear to second gear requires first fully depressing the clutch, then slightly accelerating to increase the speed to 10km/h—20km/h before shifting; 2. Gradual upshifting: When upshifting, do it gradually, while downshifting can be done directly. During gear shifting operations, only gradual upshifting is allowed, and skipping gears is prohibited; 3. Look straight ahead when shifting gears: Do not look at the gear lever. Many candidates tend to naturally look down at the gear lever during practice, which is not allowed during the examination and will be marked as a failure; 4. Shift gears correctly and quickly: Gear shifting must be done swiftly and accurately. Once the operation command is given, perform the operation quickly without any pauses, otherwise, the electronic examiner may misjudge.

8

0

Share

Can a car run with the water temperature at 100 degrees?

Can I Bring My Phone into the Car During the Driving Test (Subject 3)?

What causes the jerking sensation when driving the Qashqai?

Can I have my car inspected in another location? Do I need to go in person?

How often should the UY gear oil be changed?

What does it mean when the document status is locked on the Traffic Management 12123 app?

Has the gear shifting in Subject 3 been canceled?

Choosing Uphill or Downhill for Overtaking in Mountainous Areas

Does the Lynk & Co vehicle automatically lock when the driver leaves?

Where is the Elantra alternator fuse located?

Can You Drive in Thick or Medium Heels?