Can a car pass the annual inspection after replacing the bulbs with LED ones?

1 Answers
SanHarley
07/30/25 2:30am
Whether a car can pass the annual inspection after replacing the bulbs with LED ones depends on the specifications and performance of the modified headlights. If the color temperature, brightness, and beam angle of the modified headlights, which affect driving safety, meet the national requirements, the car can pass the annual inspection. There are mainly two aspects to check: Whether the brightness meets the requirements, meaning the brightness should not be less than 1400 lumens. Whether the beam angle is up to standard, as long as the high and low beam angles are normal. Essentially, as long as the modified LED headlights do not affect driving safety, the car can pass the annual inspection smoothly. Relevant regulations for the annual inspection of vehicles: Vehicles that fail the annual inspection should be repaired within a specified time limit. If they still fail after the deadline, the vehicle management office should confiscate their license plates and prohibit them from continuing to drive. Vehicles that do not participate in the annual inspection without reason or fail the inspection are not allowed to drive on the road or transfer ownership. Vehicles that meet the scrapping conditions or have exceeded the prescribed service life will not be inspected, and their license plates will be revoked, their files canceled, and they will be scrapped.
Was this review help?
2
1
Share
More Forum Discussions

How to turn on the cold air conditioning in a Buick Excelle?

Generally, the blue button in a car represents cold air, while the red one represents warm air, and the middle one represents moderate temperature. To turn on the cold air, adjust the button towards the blue area. The other two buttons are for adjusting the fan speed and the mode respectively.
11
4
Share

How to Use Buick Remote Start?

First press the lock button to ensure the vehicle is locked, then press and hold the Buick logo button on the remote key to start the vehicle. First press the lock button to ensure the vehicle is locked, then press and hold the remote start button to start the vehicle.
11
3
Share

How to turn on the high beam on a Mercedes-Benz?

The button for the high beam is located on the left control lever, which is on the driver's side. Simply push the lever forward. When the high beam is on, the lever will automatically reset after releasing it. Pulling the lever back turns off the high beam and switches back to the low beam.
16
1
Share

What are the assembly process steps for a transmission?

Clutch housing, transmission housing, differential sub-assembly, shift fork, shift shaft sub-assembly, input and output shaft sub-assembly. Assembly line process: differential assembly, differential bearing shim adjustment; shaft assembly; transmission housing assembly; fifth gear assembly, rear cover assembly, shift mechanism assembly. Air tightness testing; bench testing.
14
2
Share

How to Adjust the Car Seat?

First, open the car door and enter the vehicle, then observe the visibility effect before sitting down on the seat. Place your feet and hands naturally, then adjust the seat height to ensure clear visibility. Additionally, adjust the seat back angle to ensure comfort for your lower back. Also, adjust the seat's forward and backward position to ensure your hands can comfortably control the steering wheel.
8
1
Share

How should beginners perform parallel parking?

Align the rear of your car parallel to the parked car with a 0.5-meter gap, then start reversing. When your side mirror aligns with the center pillar between the front and rear doors of the parked car, turn the steering wheel fully to the right. When your car forms a 45-degree angle with the parking space, turn the steering wheel fully to the left. Wait until the front of your car straightens out, then return the steering wheel to the center position.
5
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.