···
Log in / Register

Brief Introduction to Safe Driving Techniques in Fog

3 Answers
DeDallas
07/29/25 9:58am
When driving in foggy conditions, always observe the surroundings of the vehicle and use the car's lights correctly. The following are safe driving techniques in fog: 1. Turn on fog lights: When driving in fog, turn on the fog lights and low beams, but avoid using high beams. The high beams, with their elevated light, can be refracted by the dense fog and easily shine into the eyes of oncoming drivers, blurring their vision. 2. Use the horn frequently: Frequently honk the horn to alert pedestrians and other vehicles. Upon hearing another vehicle's horn, respond immediately to indicate your vehicle's position. 3. Maintain a safe distance: Drive at a low speed in fog and keep a sufficient safe distance from the vehicle ahead. 4. Stay towards the middle of the road, not the edge: Avoid driving along the roadside to guard against roadside drainage ditches. 5. Do not wipe the windshield while driving: In heavy fog, the condensation on the curved windshield can further impair your limited visibility. Consider using the windshield wipers to remove condensation from the front windshield. If you need to wipe the fog off the windshield manually, stop the car first and then wipe it. Never wipe while driving.
Was this review help?
14
4
Share
LeCooper
08/13/25 12:18pm
Driving in fog requires extra caution. Based on years of experience, I recommend reducing your speed to half the usual pace—for example, dropping from 60 to 30 mph on the highway. Increase your following distance to at least twice the normal amount, and frequently check the rearview mirror to avoid rear-end collisions. Always use fog lights and low beams; high beams are strictly off-limits as they cause glare and reduce visibility. Fog tends to accumulate on windows, so promptly use the air conditioner’s defogger or wipe them manually to maintain clear visibility. Avoid sharp turns or sudden braking—steer smoothly instead. Keep the radio tuned to weather updates and use navigation to prevent getting lost. If visibility becomes dangerously low, immediately pull over to a safe spot and wait for the fog to lift—never take risks. Carry a flashlight and reflective vest in the car for emergencies. Prioritize safety—never overlook these details.
Was this review help?
3
1
Share
Expand All
VanHazel
10/07/25 2:10am
When driving in foggy weather with my family, I am extra cautious. I slow down to a snail's pace and maintain a distance where I can't even see the taillights of the car in front. I adjust the lights properly: turning on both front and rear fog lights and setting them to low beam mode, while turning off the radio to avoid distractions. The defroster is always on to ensure clear visibility. I remind everyone, both in the front and back seats, to fasten their seat belts and keep phones silent to maintain focus. Before setting off, I check that the windshield wipers and lights are in good condition and that the tire pressure is normal. If the fog gets too thick, I pull over to a wide shoulder, turn on the hazard lights, and wait, keeping some water and snacks handy in case of prolonged stops. These small precautions ensure the safety of my entire family, allowing us to relax only after reaching home safely.
Was this review help?
18
5
Share
Expand All
More Forum Discussions

What are the reasons for sudden inability to play in-car music?

Here are the specific reasons for the sudden inability to play in-car music: 1. Loose USB flash drive: Since the USB flash drive is plugged into the vehicle's USB interface for a long time, when the vehicle is moving, the vibration and shaking of the car body may cause it to become loose. If the USB flash drive becomes loose with the USB interface, it is very likely to cause the music to suddenly stop playing. 2. Damaged USB flash drive: Although the possibility of a damaged USB flash drive is very small, due to the less-than-ideal environment inside the car (especially under high temperatures in summer), the possibility of damage cannot be ruled out. 3. File corruption: Corrupted music files may also suddenly cause the music in the USB flash drive to stop playing.
18
5
Share

What is the wading depth of the X-Trail?

The wading depth for the X-Trail SUV model should preferably not exceed 0.3 to 0.4 meters. More details about vehicle wading depth are as follows: 1. Point one: Since the exhaust outlet is lower than the air intake, referencing the position of the exhaust pipe is a safe approach. Once the water depth exceeds the height of the exhaust pipe, the probability of the vehicle stalling increases. 2. Point two: For ordinary sedans, the exhaust outlet is typically 20 to 30 centimeters from the ground, while for SUV models, it is 30 to 40 centimeters. Therefore, as long as the water level does not exceed two-thirds of the tire height, drivers can proceed with confidence. 3. Point three: When the water depth is one-third of the tire height, it is safe to pass through. However, caution is advised when the water depth exceeds half of the tire height, as this can easily lead to water entering the vehicle interior.
9
1
Share

What are the differences between the 2021 and 2022 T-Cross models?

The differences between the 2022 and 2021 T-Cross models are as follows: Different maximum engine torque: The 2022 T-Cross has a maximum engine torque of 320 N·m; the 2021 model has a maximum engine torque of 250 N·m. Different maximum engine horsepower: The 2022 T-Cross has a maximum engine horsepower of 186 hp; the 2021 model has a maximum engine horsepower of 150 hp. Both the 2022 and 2021 T-Cross models feature a 5-door, 5-seat SUV body type, equipped with a 7-speed dual-clutch transmission, a fuel tank capacity of 60L, a luggage compartment volume of 495L, front-wheel drive, MacPherson independent front suspension, and multi-link independent rear suspension.
4
5
Share

Can the Toyota Vios be driven on highways for long distances?

Toyota Vios can be driven on highways for long distances, and it is recommended to maintain a speed of around 110 km/h for better fuel efficiency. Introduction to Highways: Highways refer to high-speed roads, compared to medium-speed and low-speed roads. In environments where low speed is the norm, low speed is considered standard or normal speed, while in environments where medium speed is the norm, medium speed is considered standard or normal speed. Precautions before entering a highway: Check the weather and road conditions, perform a safety inspection of the vehicle, plan the driving route in advance, carry a vehicle breakdown warning sign and a fire extinguisher, and determine a driving and rest schedule beforehand. Items to prepare: The vehicle must have a license plate, and the owner should also bring their driver's license, vehicle registration, insurance card, and toll fees.
17
1
Share

What do the A and B buttons on the Nissan trip reset represent?

Nissan trip-reset button A represents kilometers, and button B represents miles. How to use the Nissan trip-reset button: First, locate the button position, which is below the left vent on the steering wheel. The button has short-press and long-press functions. A short press switches the display between total mileage, single-trip mileage, instant fuel consumption, and average fuel consumption—differences can be observed on the instrument panel. For a long press, first short-press to switch to single-trip mileage, then long-press the button to reset the single-trip mileage data displayed on the instrument panel. Upon reaching the destination, the displayed mileage will show the distance traveled. Function of the Nissan trip-reset button: "Trip" refers to the trip meter or can be understood as a single-trip mileage toggle button, displaying the mileage traveled for each trip on the instrument panel. "Reset" means to clear and reset the single-trip mileage data.
17
1
Share

What is the tire specification model for the ninth-generation Honda Accord?

The ninth-generation Accord tire specification is 215/60R16, where 215 refers to the tire width, 60 refers to the aspect ratio, R stands for radial tire, and 16 indicates the 16-inch wheel hub. Methods to distinguish tires: The model of a tire can be identified based on the data on the side of the car tire. Generally, the side of the tire will indicate the tire width, aspect ratio, tire type, and the applicable size of the tire. When purchasing tires, observe the data of your own tires and then make a purchase accordingly. Meaning of tire model: There will be a series of numbers marked on the side of the tire. These numbers are separated, and generally, the first three digits refer to the width of the car tire. Typically, the width of the tire ranges between 145 and 285, and different car displacements may also result in the use of different tire specifications.
18
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.