BMW Engine Abnormal Noise?

What does a continuously flashing yellow light indicate?

A continuously flashing yellow light indicates the need to slow down and proceed with caution. Legally, a yellow light serves as a warning. A flashing yellow light alone means that the intersection is not controlled by traffic signals, and vehicles passing through must observe the surroundings to decide whether to stop or proceed. Such signals are typically installed at intersections with low traffic volume or during off-peak hours like nighttime. Below are relevant explanations: 1. Traffic signals consist of red, green, and yellow lights. A red light prohibits passage, a green light permits passage, and a yellow light serves as a warning. 2. According to regulations, when a yellow light is on, vehicles that have already crossed the stop line may continue to proceed, while vehicles that have not crossed the stop line must stop. Proceeding under such circumstances constitutes a traffic violation for disobeying traffic signal instructions and may be subject to penalties.

5

1

Share

Why do you receive messages when your vehicle has traffic violations?

The reason why you receive messages when your vehicle has traffic violations is that the driver has completed real-name registration at the registered vehicle management office and activated real-time traffic violation notifications online. Below is the relevant introduction: Timeliness of receiving violation messages: The time from the violation to receiving the SMS notification is approximately 2-7 days. In cities with fewer vehicles, you might receive the violation SMS the next day. In larger cities with more vehicles, the violation SMS may be slower. Generally, violations will not take more than 10 days. If you do not receive a violation SMS within 10 days after committing a violation, it is possible that the location of the violation was not monitored or recorded. Timeliness of violation processing: The party involved should pay the fine at the designated bank within 15 days from the date of receiving the administrative penalty decision.

10

5

Share

Why does the motorcycle suddenly fail to start?

Fuel and electrical circuit issues. Abnormal fuel supply: Check if there is fuel in the carburetor. If there is no fuel, it indicates a blockage in the fuel line from the fuel tank to the carburetor, which should be cleaned and unclogged. If there is fuel in the carburetor but the engine still fails to start, inspect whether the carburetor fuel filter is clogged or if the main jet is dirty. Even if the engine starts, the issue should not be ignored, as it suggests an undetected fault somewhere in the fuel system. The fuel supply system pipelines must be thoroughly unclogged. Otherwise, the issue of the engine stalling automatically may recur. Electrical circuit fault: The cause of sudden engine power loss is generally related to wiring issues. Check all connectors and the trigger coil, clean off any oil stains, increase the clamping force of the connector tabs and sockets, and enhance contact strength to ensure stable contact.

5

Share

If the compulsory traffic insurance for a motorcycle is missed for one year, does it need to be paid back for the annual inspection?

If the compulsory traffic insurance for a motorcycle is missed for one year, you need to purchase the compulsory traffic insurance before the annual inspection. The insurance company will not require you to pay back the missed premiums. The newly purchased compulsory traffic insurance will take effect from 00:00 the next day after purchase, and the insurance period is one year. Driving without insurance is not allowed: Compulsory traffic insurance is a mandatory insurance required by the state. If the compulsory traffic insurance for a vehicle is not renewed, the vehicle is not allowed on the road. If caught by traffic police, you may face fines, points deduction, and vehicle impoundment. No insurance coverage during the lapse period: If the insurance is not renewed in time, there will be no insurance coverage during the lapse period. In the event of a traffic accident, all losses incurred will have to be borne by yourself.

9

5

Share

How to Clean Dirty Fabric Seats?

Fabric seats can be cleaned using the following methods: 1. Surface Cleaning: For small stains, spray a small amount of foam cleaner onto the fabric for about 10 seconds, then wipe with a clean, soft cloth. Avoid using stain removers as they may cause discoloration and marks. 2. Dirt Cleaning: For dry dirt like dust or sand, simply pat it off or use a vacuum cleaner. For granular sand, use a soft brush to gently brush inward, but avoid hard brushes to prevent fabric damage. For spills like drinks or juice, first blot the moisture with a paper towel, then wipe with warm water mixed with mild detergent, and finally dry with a clean soft cloth and low-temperature drying. 3. Maintenance: Regular maintenance involves wiping with a clean, soft cloth. For long-term stains, the ideal method is to first wipe with warm water diluted with mild detergent, then remove the cleaning solution with a damp cloth, and finally polish with a dry cloth. Once completely dry, apply an appropriate amount of leather conditioner evenly for protection.

17

2

Share

What is the proper air pressure for painting?

Painting normally requires an air pressure of 0.3~0.6Mpa. Painting: Paint is a type of synthetic lacquer made from nitrocellulose, resins, pigments, solvents, etc. It is typically applied evenly onto surfaces using a spray gun, offering water resistance, oil resistance, and quick drying. It is used for painting cars, airplanes, wooden objects, leather, etc. This substance is toxic and can have certain effects on the body. The toxicity varies depending on the brand due to differences in ingredient composition. Special care should be taken during use to avoid inhalation and skin contact. Air pressure spraying method: Air pressure spraying is a type of spraying technique. It involves atomizing the paint with compressed air and spraying it onto the surface of the substrate (plastic or other materials) through a nozzle. This method is suitable for coating porous materials and substrates that should not be saturated. Air pressure spraying is further divided into suction-type spraying and pressurized air spraying.

8

3

Share

BMW Engine Abnormal Noise?

What does a continuously flashing yellow light indicate?

Why do you receive messages when your vehicle has traffic violations?

Why does the motorcycle suddenly fail to start?

If the compulsory traffic insurance for a motorcycle is missed for one year, does it need to be paid back for the annual inspection?

How to Clean Dirty Fabric Seats?

What is the proper air pressure for painting?

What are the mandatory insurances required when purchasing a new car?

What is the function of the P gear?

How to Drive an Automatic Transmission Car Uphill?

Is 81 kilometers normal when picking up a new car?