BMW 5 Series Front Windshield Defogging

What are the reasons for the BYD F3 blower not working?

The reasons for the BYD F3 blower not working are: 1. Blower coil overheating: When the car is running the air conditioner for a long time under full load, the air conditioner blower will be overloaded, causing the coil to overheat. This is a normal phenomenon, and it will work normally after it stabilizes; 2. Poor contact of the connector: If the car frequently drives on bumpy roads, the blower connector may fall off due to vehicle vibration. In this case, simply reinstall it; 3. Fan jamming: If the blower or air filter is not cleaned for a long time, foreign objects such as sand, stones, or leaves may block it, causing the fan inside the blower to jam. As a result, the blower cannot work properly. In this case, simply clean the car's blower and air filter in time. It should be noted that the car's air filter should be replaced approximately every 10,000 kilometers. This car is 4533 mm long, 1705 mm wide, and 1490 mm high, with a wheelbase of 2600 mm. The BYD F3 uses a Mitsubishi 4G18 engine, paired with a 5-speed manual transmission.

8

4

Share

What are the length, width, and height of the Audi A4?

Body dimensions: The length, width, and height are 4851mm (Elegance model)/4858mm (Dynamic model), 1847mm, and 1439mm (comfort suspension)/1411mm (sport suspension), with a wheelbase of 2908mm. Here are the extended details: 1. The entire lineup is equipped with a 2.0L turbocharged engine paired with a longitudinal 7-speed Stronic dual-clutch transmission. 2. A 12V mild hybrid system is standard across all models. 3. In the 45TFSI quattro model, its 2.0L turbocharged engine is tuned for sporty performance, delivering a maximum power of 185kW and a maximum torque of 370Nm. Coupled with the quattro intelligent all-wheel-drive system, the 0-100km/h acceleration time is just 6.6 seconds. 4. In the 35TFSI and 40TFSI models, the 2.0L turbocharged engine is tuned for economy, with maximum power outputs of 110kW and 140kW, respectively. With the support of the 12V mild hybrid system, these models offer lower fuel consumption and superior economic performance.

4

0

Share

Do I Need to Replace the Entire Rear Axle If the Rear Axle Bushing Is Broken?

If the rear axle bushing is damaged but the axle itself is not deformed, and the bushing can be provided and replaced separately, then only the rear axle bushing needs to be replaced. If there is no separate bushing available, the entire rear axle assembly must be replaced. As long as the vehicle drives without issues, the rear axle bushing does not need replacement. A broken rear axle bushing will fail to provide shock absorption, leading to chassis vibrations and unusual noises. Severe vibrations can affect driving stability and reduce the comfort of the vehicle. Method for Replacing the Rear Axle Bushing: There are three fixing screws and one central screw. A 17-19 wrench is crucial for securing the rear axle. The brake fluid line is connected to the rear axle, and there is a fixing clip for the line. Use a hammer to slightly bend it for easier screw removal, but be careful not to break the fluid line. If it's your first time replacing the bushing, flatten the outer metal ring of the bushing by hammering it inward. Observe carefully—the bushing and rear axle should expose a small section of metal. Alternatively, use a sledgehammer with maximum force. If the metal gets deformed, smooth it with an angle grinder, then remove the bushing and repeat the installation process.

20

0

Share

What are the reasons why the trunk of a Chevrolet Cruze cannot be opened?

The trunk door of the Cruze is controlled by the remote. You need to press and hold the trunk unlock button to open it. The following are the reasons why it cannot be opened: 1. The trunk door lock switch is damaged. 2. Rainwater entering the trunk switch area causes corrosion, which has a relatively high failure rate. The only solution is to replace it. Solutions for a trunk that cannot be opened: 1. Issues with the linkage rod or lock cylinder. If you frequently use the key to open the trunk lid, it may be due to a broken linkage rod, and you should go to a repair shop to have it opened. If you always use the remote to open the trunk lid, it may be due to dust or rust in the lock cylinder. Spraying rust remover into the lock cylinder a few times can help open it. 2. The trunk is not unlocked. If the remote key is not used to unlock it, it will be difficult to open. Before opening, it's best to press the unlock button on the key or check if the key battery is dead. 3. Mechanical component failure, where the trunk itself has issues. 4. Generally, five-door cars cannot be opened from the inside. For example, some rugged off-road vehicles may not have an interior trunk switch to prevent accidental activation during driving, which could cause injuries or fatalities. Therefore, the trunk can only be opened from the outside.

10

5

Share

Is the Jetour X70 engine domestically produced?

Jetour X70 is equipped with a domestically produced engine. How the engine works: The working principle of an engine is to convert other forms of energy into mechanical energy. Two-stroke engines and four-stroke engines operate differently, with the vast majority of automotive engines being four-stroke. The working cycle of a four-stroke gasoline engine consists of four piston strokes: intake stroke, compression stroke, power stroke, and exhaust stroke. Symptoms of engine failure: Main manifestations of engine failure include abnormal noises, operational performance anomalies, leaks, abnormal exhaust smoke, abnormal consumption, overheating, etc.

2

0

Share

Where is the expansion valve of the Besturn B90 located?

The air conditioning expansion valve is located downstream of the dryer and upstream of the evaporator, with the installation position likely beneath the dashboard. Introduction to the expansion valve: The expansion valve is one of the four major components of a refrigeration system. It serves as a critical device for regulating and controlling the flow and pressure of refrigerant entering the evaporator, and also acts as the "dividing line" between the high and low-pressure sides. Characteristics of the refrigeration system: The expansion valve features an advanced dual-flow balanced orifice structure. By utilizing a bi-directional thermal expansion valve, the refrigeration system reduces the number of required components such as expansion valves, check valves, and solenoid valves. The expansion valve maintains stable superheat, ensuring consistent system operation.

16

0

Share

BMW 5 Series Front Windshield Defogging

What are the reasons for the BYD F3 blower not working?

What are the length, width, and height of the Audi A4?

Do I Need to Replace the Entire Rear Axle If the Rear Axle Bushing Is Broken?

What are the reasons why the trunk of a Chevrolet Cruze cannot be opened?

Is the Jetour X70 engine domestically produced?

Where is the expansion valve of the Besturn B90 located?

What Causes the Car Brake Pedal to Be Hard to Press Down?

What car is the KIN logo?

What are the body dimensions of the Dongfeng A9?

Does the Lynk & Co 03 Use a Volvo Engine?