Automatic Transmission Subject 3 Lighting Operations?
3 Answers
Automatic transmission Subject 3 lighting operations include high beam, low beam, switching between beams, and combined operations for different situations. Specific details are as follows: The light must be set to low beam when turning on. After high beam, the next operation must be low beam. Upon hearing "pass" or "overtake," the corresponding action is to switch between high and low beams. Driving in foggy conditions: headlights + fog lights + hazard warning lights. Vehicle breakdown with difficulty moving: position lights + hazard warning lights. "Oncoming traffic" must always use low beam. Note: Before the test, always remember to check if the lights are set to low beam. More detailed information: Driving at night without illumination or under poor lighting conditions — headlights. Please change the headlights to high beam — high beam. Following a vehicle or oncoming traffic — low beam. Important notes: When hearing an instruction, think about the operation first before pressing the button. Always wait for the computer to finish announcing before performing the operation. Remember, no answering in advance, or you will fail the test directly.
I practiced the light operations a lot before the test, mainly memorizing several key steps during the exam. You need to react quickly after the examiner's instructions, such as turning on the headlights and switching to low beams when simulating night driving; flashing the headlights when passing intersections or crosswalks; and remembering to activate the turn signal a few seconds before turning, then turning it off once the steering is correct. If the lights don't work or are delayed, you'll fail the test immediately, so during practice, I often checked the vehicle's lighting system to ensure the bulbs and fuses were functioning properly. Driving an automatic is easier, but manual light operations are no different—I had to develop habits to avoid mistakes. Nervousness during the test can lead to errors, so simulating it multiple times helps build familiarity. After all, safety comes first, and proper lighting reduces the risk of nighttime accidents.
Over the years of my driving experience, the core of Subject 3 lighting operations is to cultivate safe habits. During the test, the examiner will simulate different scenarios requiring you to switch lights: for example, turning on fog lights in foggy conditions or activating hazard warning lights when pulling over. Automatic transmission vehicles make the operation simpler as their light panels are standardized. Remember to signal turns one or two seconds in advance—don't wait until you're actually turning. Common mistakes include failing to turn on headlights at startup or forgetting to switch off high beams in tunnels, both of which will cost points. I recommend combining practice sessions with real-road driving; delayed lighting can easily lead to rear-end collisions. Passing the test isn't the end goal—these fundamentals matter in daily driving too. Remember, lights are your vehicle's language; getting them wrong misleads others.
