Are there speed requirements for automatic transmission in Subject 3?

[MacSadie]

In the automatic transmission Subject 3 test, there is a section where you need to accelerate to above 45 km/h and maintain that speed for at least three seconds. Below is relevant information about driving test Subject 3: 1. Introduction: Subject 3 includes road driving skills test and safe civilized driving knowledge test. It is part of the motor vehicle driver's license assessment, and is the abbreviated name for the road driving skills and safe civilized driving knowledge test subjects in motor vehicle driver examinations. Different permitted driving models have different road driving skills test content. 2. Specific test content for Subject 3: The road driving skills test generally includes: vehicle preparation, light simulation test, starting, straight-line driving, gear shifting operations, lane changing, parking by the roadside, going straight through intersections, left turns at intersections, right turns at intersections, passing pedestrian crossings, passing school zones, passing bus stops, meeting vehicles, overtaking, U-turns, and nighttime driving. The safe civilized driving knowledge test generally includes: safe civilized driving operation requirements, safe driving knowledge under adverse weather and complex road conditions, emergency handling methods for situations like tire blowouts, and post-accident handling knowledge.

[SanMaci]

The Category 3 driving test does have specific speed requirements for automatic transmission vehicles. I remember when I was learning, the instructor repeatedly emphasized maintaining 25-30km/h during straight-line driving sections, as this range is most likely to pass electronic evaluation. When passing bus stops or school zones, it's best to keep the speed around 20km/h - going too fast will directly result in point deductions. The most easily overlooked part is the U-turn maneuver; you need to reduce speed below 10km/h as soon as you start turning the steering wheel. Many remember the 50km/h limit for high-speed sections but often forget the minimum speed requirement - driving below 30km/h for extended periods will also result in failure. It's recommended to keep a speed reference chart in the car during practice, paying special attention to the correlation between throttle depth and speedometer readings.

[CoraLynn]

For automatic transmission in Subject 3, it's not just about not exceeding the speed limit; different test items have specific speed requirements. During the straight-line driving test, you must maintain a speed between 25-35 km/h—a deviation of just 3 km/h could result in failure. In school zones, the speed limit is 30 km/h, but it's safer to keep it around 25 km/h. When making a U-turn, avoid stepping on the accelerator hastily; gently apply the brake once the car starts moving. Night tests have stricter requirements for maintaining speed with low beams. From my experience as a test companion, candidates often fail due to unsteady acceleration and deceleration, such as sudden braking at crosswalks, which the system may flag as dangerous driving. The dashboard of the test car usually has speed indicator stickers—glance at them frequently to build the habit. Crawling at very low speeds for over 15 seconds will also incur penalties, so don't be overly cautious.

[SanAdriana]

When taking the automatic transmission driving test (Subject 3), pay attention to speed control in different scenarios. Maintain a steady 30km/h on straight sections – going too slow may be judged as unskilled. In specific zones like bus stops, decelerate to 20km/h in advance; sudden braking can be dangerous. Excessive power during U-turns is the most common point deduction – 10km/h is safest. I've seen candidates fail instantly for exceeding 50km/h, and others penalized for prolonged speeds below 35km/h. Focus on throttle control during practice – without clutch concerns in automatics, speed depends entirely on your right foot's precision. Don't relax in the final 100 meters; maintain consistent speed until fully stopped.