Are There Restrictions for Hebei License Plates Entering Beijing?

1 Answers
LaKira
07/30/25 6:48am
There are restrictions. Hebei license plates entering Beijing require an entry permit. During the COVID-19 pandemic in 2021, vehicles from Hebei also needed to provide a negative nucleic acid test certificate, while complying with Beijing's traffic restriction policies. Below is additional information: 1. Introduction: The Beijing Entry Permit is a temporary pass required for non-Beijing licensed vehicles entering areas within the Sixth Ring Road (excluding) and certain sections outside the Sixth Ring Road. It is valid for 7 days. An extension of 5 days can be applied for at the local traffic police station one day before, on the day of, or one day after the permit's expiration. 2. Required Documents for Application: According to regulations, the following documents are needed to apply for the Beijing Entry Permit: driver's license, vehicle registration certificate, ID card, compulsory traffic insurance policy, and a valid vehicle inspection sticker. However, in practice, only the driver's license, vehicle registration certificate, and ID card are required. The driver's license and ID card must belong to the same person (who does not have to be the vehicle owner), and the ID card holder must apply in person.
Was this review help?
9
2
Share
More Forum Discussions

How to Fix a Failed DIY Paint Touch-Up?

To completely remove rust, dirt, and grease from the paint surface. Carefully use tape to mask off the area around the scratch for better results. You can also use polishing compound to smooth out the scratch and paint surface. Follow the method used for modifying drawings in the past, trying to avoid damaging surrounding areas, and scrape off any raised paint marks.
11
5
Share

Why is the Land Cruiser called the Prado?

Land Cruiser is not called Prado; Land Cruiser and Prado are both series of vehicles produced by Toyota. The Land Cruiser is an imported ORV (Off-Road Vehicle) manufactured by Toyota. Its exterior design inherits the original DNA while evolving into a style that embodies a fresh, advanced feel of the new era. Below are the differences between the two: Road conditions: The Land Cruiser has superior off-road performance compared to the Prado, with stronger adaptability and a more stable chassis. It feels steady even at speeds of 130 km/h, whereas the Prado tends to feel unstable at high speeds, highlighting the difference in chassis quality. Interior: Compared to the Prado, the Land Cruiser is more luxurious, featuring three differential locks in the top configuration, which enhances its off-road capabilities. The Prado, on the other hand, only has two differential locks. However, both vehicles are genuine off-roaders with a ladder frame, slightly weaker in on-road performance but exceptionally strong in off-road capability.
19
3
Share

What Happens If You Leave the Car AC On All Night?

Leaving the car AC running all night while the engine is on can cause damage to the vehicle. Here is relevant information: Introduction to Car Air Conditioning: The car air conditioning system consists of a compressor, condenser, throttle element, evaporator, fan, and necessary control components. It is designed to regulate the temperature and humidity inside the car, providing a comfortable environment for the driver. Working Principle: When the compressor operates, it draws in low-temperature, low-pressure gaseous refrigerant from the evaporator. After compression, the refrigerant's temperature and pressure increase, and it is sent to the condenser. Inside the condenser, the high-temperature, high-pressure gaseous refrigerant transfers heat to the outside air passing through the condenser, causing it to liquefy into a liquid. The liquid refrigerant flows through the throttle device, where its temperature and pressure decrease, and then enters the evaporator. Inside the evaporator, the low-temperature, low-pressure liquid refrigerant absorbs heat from the cabin air passing through the evaporator, evaporating into a gas. The gas is then drawn back into the compressor for the next cycle.
8
0
Share

What Could Be the Reasons for Interior Lights Not Working?

Interior lights not working could be due to a burnt-out bulb or a blown fuse, which requires inspection and replacement. The location of the interior light fuse varies by car model, but most are found in the fuse box behind the center console. Once the fuse is located, replace it according to the model specifications. If the bulb is burnt out, you'll need to pry open the exterior decorative panel of the interior light with a screwdriver and remove it. After taking out the entire interior light panel, you'll see three small bulbs at the front. Remove and replace them as needed. Interior lighting includes dashboard lights, ambient lights, and dome lights. Most of these lights have two types of switches: a manual switch, usually a button located near the light for direct on/off control, and an automatic switch. Precautions for using car lights include: turning on low beams when driving at night; avoiding high beams when driving closely behind another vehicle in the same direction; and alternating between high and low beams when passing through sharp curves, slopes, arched bridges, crosswalks, or intersections without traffic signals at night.
20
2
Share

What are the in-car video formats?

Car DVD navigators generally support video formats such as WMV, AVI, ASF, 3GP, MP4, and MPEG. Here is relevant information: Car Head Unit: The car head unit is the core component of the in-car audio-visual system, primarily functioning to play audio sources, equivalent to the DVD player in a home theater. However, to better suit the limited space inside a car, the head unit often includes some amplification capability. If the speaker requirements are not too high, there is no need for an external amplifier, making it simpler to set up the audio-visual system. Functions of the Head Unit: Tone adjustment, harmonizing signals across high, mid, and low-frequency ranges for better balance; Loudness adjustment, compensating for signals with insufficient loudness to make the sound fuller; Built-in equalizer, applying different frequency gain enhancements for various music styles. For example, pressing the 'ROCK' button on the panel will enhance bass and treble to emphasize the rock music experience.
20
4
Share

Where is the wiper switch for Subject 3?

The wiper switch is located on the lever behind the left side of the steering wheel, divided into front wiper and rear wiper switches. Here is relevant information: Introduction: The wiper is a blade structure installed in front of the windshield, consisting of a motor, reducer, four-bar linkage, wiper arm spindle, wiper blade assembly, etc. Function: The wiper is a device used to remove dust and raindrops attached to the car windshield, effectively improving the driver's field of vision and increasing driving safety. Principle: The power source of the wiper comes from the motor, which is the core of the entire wiper system. The quality requirements for the wiper motor are quite high. It uses a DC permanent magnet motor.
5
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.