Are there cameras at highway exit ramps?

1 Answers
McAugust
07/29/25 1:41pm
There are cameras at highway exit ramps. Here are specific details about highway ramps: 1. Introduction: Ramps are part of the highway, and reversing on highway sections is not allowed. Typically, surveillance cameras are installed at ramp entrances. If a vehicle reverses on a ramp, it will definitely be captured and subject to corresponding penalties. 2. Reversing: Stopping, making U-turns, backing up, or reversing on highways are extremely dangerous traffic behaviors. Due to the high speed, drivers have very short reaction times, making it easy to cause traffic accidents with unimaginable consequences. Highway accidents are often catastrophic, harming both oneself and others. Therefore, reversing is prohibited on highways. If discovered, the driver will have 12 points deducted from their license and may face suspension of their driving permit. 3. Precautions: When exiting the highway, drivers should pay attention to exit warning signs, change lanes in advance, and follow the instructions to enter the lane connected to the exit for deceleration. If an exit is missed, drivers must continue forward until the next exit to leave the highway. They must not reverse, drive in the opposite direction, overtake, or stop.
Was this review help?
2
4
Share
More Forum Discussions

How Long Is the Warranty for Car Brake Discs?

Car brake discs are typically covered by a warranty for 12 months or 60,000 kilometers, though this may vary depending on the vehicle brand. The steps for replacing brake discs are as follows: 1. Open the engine compartment and check the brake fluid level to prevent overflow during replacement. 2. Remove the wheel and caliper bolts of the affected brake. 3. Take off the old brake disc. 4. Install the new brake disc, tighten the guide bolts, and complete the replacement. Brake maintenance methods include: 1. High-temperature protection to prevent corrosion of the braking system and avoid brake pad seizure due to overheating. 2. Clean oil stains from brake discs and drums to ensure proper heat dissipation. 3. Regularly replace brake fluid. 4. Periodically inspect the thickness of brake pads or shoes.
14
3
Share

What are the techniques for car window tinting?

Car window tinting techniques include: 1. External cleaning: Before applying the film, thoroughly clean each piece of car glass in a clockwise motion, paying special attention to the corners. Proper preparation ensures better tinting results; 2. Outline trimming: Spray a small amount of window film installation solution on the outer surface of the window glass, then cover it with the tint film and trim the edges; 3. Heat shaping: This process makes the film smoother, improves its appearance, and helps it set faster; 4. Edge inspection and sealing: After application, carefully examine the edges of the tint film for any bubbles or unevenness.
1
4
Share

How Long Do Platinum Spark Plugs Last?

Platinum spark plug lifespan varies depending on the type: single platinum spark plugs last 30,000 to 40,000 kilometers, while double platinum spark plugs last approximately 80,000 kilometers. The functions of spark plugs are: 1. Introducing high-voltage electricity generated by the ignition coil into the engine cylinder; 2. Generating sparks between the spark plug electrode gaps to ignite the air-fuel mixture, ensuring normal engine operation. The removal method for spark plugs is: 1. Clean any dust or debris around the spark plug area using compressed air or a soft tube for blowing; 2. Ensure the engine is in a cold state; 3. Protect the spark plug installation port immediately after removal to prevent debris or dust from entering the cylinder; 4. Avoid damaging the insulating porcelain body when using a wrench; 5. Do not bend or strike the center electrode when adjusting the spark plug gap.
6
3
Share

What Causes Steering Wheel Vibration at 100 km/h?

The reason for steering wheel vibration at 100 km/h is loose ball joints or detached rubber bushings at connection points. The steering wheel is the round control device used to direct vehicles like cars, ships, and aircraft. Typically connected to the steering shaft via splines, its function is to convert the driver's applied force at the wheel's edge into torque transmitted to the steering shaft. A larger diameter steering wheel requires less manual force from the driver during turns. The steering intermediate shaft serves as a connector between the steering gear and steering shaft, facilitating steering gear standardization while compensating for manufacturing and installation errors, thereby optimizing the installation of steering components in the vehicle.
9
1
Share

What is the tire model of the Mercedes-Benz E300?

The tire model of the Mercedes-Benz E300 is 245/45R18, where 245 represents the section width (mm), 45 represents the aspect ratio, R stands for radial tire, and 18 indicates the diameter. Tires are circular elastic rubber products mounted on various vehicles or machinery, installed on metal rims to support the vehicle body, absorb external shocks, maintain contact with the road surface, and ensure driving performance. The length, width, and height of the Mercedes-Benz E300 are: 4942mm, 1860mm, 1458mm, with a wheelbase of 2939mm and a top speed of 250 kilometers per hour.
18
1
Share

Can Modified Car Wheels Pass Annual Inspection?

Modification of car wheels requires approval from the traffic management authorities. Only approved wheel modifications can pass the annual inspection. Without such approval, the vehicle will fail the inspection. According to current regulations, any changes to the color, model, performance, purpose, or structure of a licensed vehicle, including replacement of the frame, body, or engine, must be reported to the vehicle management office for modification registration. Annual vehicle inspection is a mandatory test for all vehicles with official license plates and registration certificates, equivalent to an annual health check based on the safety technical conditions for motor vehicle operation.
13
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.