Are there any speed requirements for night driving?

1 Answers
LaEvelyn
07/30/25 1:12am
Passenger vehicles must not exceed 80% of the daytime speed limit when driving at night. Regulations for motor vehicles driving on roads: Do not exceed the speed indicated by speed limit signs or markings; On roads with two or more motor vehicle lanes in the same direction and without speed limit signs or markings, the maximum speed on urban roads is 70 km/h. The maximum speed on closed motor vehicle-only roads and highways is 80 km/h. Precautions for driving speed on urban roads: Speeding within 10% of the prescribed speed limit will not result in a fine but will incur 3 demerit points. Speeding between 10% and 20% of the prescribed speed limit will result in a fine and 3 demerit points. Speeding over 70% of the prescribed speed limit will result in a fine, 6 demerit points, and may also lead to the revocation of the driver's license.
Was this review help?
10
5
Share
More Forum Discussions

What is the correct method for adding refrigerant to a car?

Automotive air conditioning refrigerant, commonly referred to as car refrigerant, is mainly divided into two types: environmentally friendly 134a and non-environmentally friendly R12. The correct method for adding refrigerant to a car is as follows: 1. After the system is vacuumed, close the high and low pressure manual valves on the manifold pressure gauge. 2. Connect one end of the middle hose to the joint of the refrigerant tank injection valve, open the refrigerant tank valve, then loosen the nut at one end of the manifold pressure gauge hose to allow gas to escape for a few minutes, and then tighten the nut. 3. Fully open the high-pressure side manual valve and invert the refrigerant tank. 4. Inject the specified amount of liquid refrigerant from the high-pressure side, close the refrigerant tank injection valve and the high-pressure manual valve on the manifold pressure gauge, then remove the gauge. When adding refrigerant to the system from the high-pressure side, ensure the engine is not running, and do not open the low-pressure manual valve on the manifold pressure gauge to prevent hydraulic shock.
13
0
Share

How much engine oil should be added to a 2.0T Mondeo?

The 2.0T Mondeo requires 4.5 liters of engine oil, but the exact amount should be determined based on the oil dipstick's scale. The Mondeo is a mid-size sedan sold by Ford Motor Company in various global markets. Below are the model configurations of the Mondeo: 1. Exterior: Features a mesh grille and chrome trim on the taillights, enhancing both texture and sportiness. 2. Features: The Intelligent Control Edition adds Baidu Carlife and a parking fresh air function. 3. Powertrain: The new model is equipped with 1.5T and 2.0T turbocharged engines in both high and low power versions.
7
5
Share

What brand of car is naval?

There is no car brand called naval. It should be Haval, Great Wall Haval, an SUV brand under Great Wall Motors. More information about Great Wall Haval is as follows: 1. Haval is a sub-brand of Great Wall Motors, established on March 29, 2013. The Haval brand, mainly focusing on SUV models, operates in parallel with the Great Wall brand, using independent logos and independent product development, production, and service systems. 2. The English name of Haval is "Haval", which means "free soaring". Great Wall no longer uses the "Sai" series naming method for this new car, reflecting the characteristics of Haval that are different from any previous Great Wall product. 3. Among Haval cars, the Haval H6 model has higher sales. In terms of body design, its appearance is full of sportiness, with a stable and grand body and smooth body lines, highlighting a steady and tough temperament. The Haval H6 has a high space utilization rate. Although it is a compact SUV, the interior space is designed to be very spacious.
4
1
Share

What are the emergency solutions for a car with a dead battery?

There are several emergency solutions for a car with a dead battery: 1. Jump-starting. First, connect the positive terminals of both cars with a red cable, and the negative terminals with a black cable. In this case, you can use a metal part in the engine compartment as the negative terminal, commonly known as grounding. After connecting, start the ignition. 2. Push-starting. First, turn the key to the ignition position, press the clutch, release the handbrake, and put the gear in 1st or 2nd. Keep the clutch pressed and start pushing the car. When the speed reaches 5 km/h, slowly release the clutch and press the accelerator to start the car. 3. Using a portable car emergency charger. The principle of a car emergency charger is similar to that of a phone power bank. When the battery is dead, you can charge the car to start it. Simply clip the charger's clamps onto the battery terminals and press the charger's switch.
5
5
Share

How to Choose Xenon Lamp Models?

Here are the methods for selecting xenon lamp models: 1. Pay attention to the origin of the product when choosing xenon lamps. Avoid counterfeit name brands. It is best to choose complete sets of xenon lamps produced by well-known imported brands or domestic manufacturers with technical patents. 2. Check for the EU e-mark certification. The EU e-mark certification is a globally recognized technical standard. If the xenon lamp product has obtained this certification, it ensures compatibility with other electronic devices in the car. 3. Examine the craftsmanship details of the product, such as polarity markings on wire ports and waterproof design. These details reflect the maturity of the product. Not only do they ensure qualified product quality, but they also prevent interference during use. When selecting, carefully inspect the product's craftsmanship, such as the connection of the ballast to the fixed bracket, as these areas are often overlooked. 4. The color temperature of xenon lamps is not necessarily better when higher. The typical color temperature of xenon lamps ranges from 4000K to 6000K. Higher values, such as 8000K or above, can actually reduce lighting effectiveness. Common color temperatures for xenon lamps include 4300K, 6000K, and 9000K.
14
3
Share

How many retake opportunities are there for the driving license test subject 3?

There are 5 retake opportunities for the driving license test subject 3. Below are the precautions for the subject 3 test: 1. If the candidate's fingerprint verification fails, please exit the vehicle to re-collect the fingerprint before queuing again for the test. 2. When walking around the vehicle to inspect its appearance and surrounding environment, maintain a distance of within 1 meter between yourself and the vehicle to ensure the accuracy of radar signal detection. 3. If multiple candidates are preparing for the test simultaneously, after one candidate finishes, the next candidate must follow the standard procedure, including exiting the vehicle, preparing to board, walking around the vehicle, and simulating nighttime lights, before starting the test.
12
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.