Are illegal photography and violation photography the same?

Where is the wiper relay located in the Bora Classic?

The wiper relay of the Bora Classic is located in the fuse box in the engine compartment of the car. By carefully observing the fuse box, you can see the relay. The main function of the wiper relay in the Volkswagen Bora is to ensure that the car's electrical circuit maintains a normal state and to prevent short circuits in the car's electrical system. Therefore, car owners need to regularly inspect and maintain the wiper relay to avoid any impact on the car's electrical circuit due to relay failure. The car's relay can display the three-phase power supply voltage in real time and, in case of overvoltage or phase sequence errors in the power supply, provide alarm output and protective circuit action output through relay output, offering contact control signals for alarm and protection purposes.

19

4

Share

What is the reason why the trunk of Qoros 3 cannot be opened?

The trunk lock of Qoros 3 is damaged or the interior switch of the trunk is damaged, which will cause the trunk to fail to open. Just replace the lock or switch to return to normal. There are three common ways to open the trunk: 1. Open with a mechanical key: Insert the key into the tailgate lock hole to switch the tailgate. 2. Open directly with the remote key: The most direct and simplest way to open, it is also relatively simple to use. Take out the remote key and press the trunk opening button directly to open it. 3. Induction opening: If the car is equipped with intelligent induction or electric tailgate, even if the key is left in the car, the trunk can be opened manually, and it can even be opened by kicking the induction.

3

4

Share

Why does the headlight turn on when braking on a motorcycle?

The main cause of this malfunction lies in the brake light switch, which is divided into front and rear switches. Therefore, you can check the front brake light switch first, as in actual repairs, this issue is often caused by the front brake light switch. Simply unplug the connector on the front brake light switch temporarily, and the vehicle's brake light will turn off. If this is the case, purchasing and replacing the front brake light switch will resolve the issue, and users can easily perform this operation themselves. However, if the issue is not caused by the front brake switch, then the rear brake switch might be adjusted too tightly, with too small of a return gap. In this case, readjusting the gap can also eliminate the fault.

7

1

Share

What is the appropriate tire pressure for a Mercedes-Benz C-Class?

The appropriate tire pressure for a Mercedes-Benz C-Class is as follows: 1. The front tire pressure should be 2.2 to 2.3 bar when unloaded and 2.4 to 2.5 bar when fully loaded; 2. The rear tire pressure should be 2.4 to 2.5 bar when unloaded and 2.6 to 2.8 bar when fully loaded. The recommended tire pressure range may vary depending on the tire model, and the standard tire pressure is usually indicated by the manufacturer at the time of production. Tire pressure can be affected by temperature changes. In high-temperature conditions or during summer, it is advisable to reduce the tire pressure by 0.1 to 0.2 bar. Conversely, in extremely low temperatures, such as during winter, the tire pressure should be increased by 0.1 to 0.2 bar.

15

0

Share

Why is one side wider than the other when reversing into a parking space?

The reason is that if you turn the steering wheel too early when reversing into a right-side parking space, the wheels will be closer to the corner of the parking space, resulting in a left-wide and right-narrow situation after parking. Below is some relevant information about reversing: 1. Precautions: Whether you are a beginner or an experienced driver, this is a crucial point to keep in mind. Not only should you avoid pressing the accelerator while reversing, but you should also avoid half-pressing the brake. Beginners, in particular, should drive at a speed slower than idle speed when reversing. This allows more time to observe the surrounding environment. 2. Basic principles: When entering a parking space, first estimate the width of the space, check for any obstacles behind, whether there are vehicles parked on either side, and whether the length is suitable for your vehicle. If visibility is poor at night, get out and check the exact position before reversing.

13

2

Share

How to Replace the Battery in a CS75 Key?

cs75's key battery replacement steps are as follows: 1. Use a small flat-head screwdriver or a plastic pry tool to gently pry open the remote shell: Be careful not to damage the internal circuits during the prying process, especially in winter; you can touch metal to discharge static electricity before operation. 2. For detachable mechanical keys: First, remove the mechanical key. You can use the mechanical key to pry at the gap. Once pried open along the gap, the entire cover can be opened. 3. After opening the remote key cover, you can see the battery: The model is CR2032. Simply remove and replace it. Pay attention to the positive and negative polarity when installing the battery. After installing the battery, close the key cover and press the button to test if the function is normal.

19

0

Share

Are illegal photography and violation photography the same?

Where is the wiper relay located in the Bora Classic?

What is the reason why the trunk of Qoros 3 cannot be opened?

Why does the headlight turn on when braking on a motorcycle?

What is the appropriate tire pressure for a Mercedes-Benz C-Class?

Why is one side wider than the other when reversing into a parking space?

How to Replace the Battery in a CS75 Key?

How to Fold the Rearview Mirrors on the T-Roc?

Can motorcycles be inspected in a different location?

What Violations Do Electronic Police Capture?

What transmission is used in the Jetta VS5?