Are Dust Spots on Car Film a Big Deal?

1 Answers
OCaden
07/29/25 11:01am
If the dust spots on the car film are large enough to affect the driver's vision, it is best to reapply the film. If dust spots are found inside the film after application, it is advisable to promptly visit a repair shop for treatment. If dust spots on the car film are not addressed in time, they may gradually enlarge. Moreover, dust spots can reduce the adhesive strength of the film, which may lead to further expansion during high-speed driving over time. Below is an introduction to car film application: 1. After applying the car film: It needs to be protected for about 3-7 days, depending on the actual environmental conditions. During this period, the main focus is waiting for the moisture inside the film to dry completely. Remember not to roll down the windows or wash the car, as the moisture may cause the film to curl or shift. 2. Observe recovery: Pay attention to the film's condition during these days. If any abnormalities, such as bubbles, occur, promptly visit the repair shop where the film was applied for fixes. Over time, the adhesive in the film will dry, making repairs more difficult and potentially leaving creases, which can be unsightly.
Was this review help?
13
4
Share
More Forum Discussions

What is the reason for a scooter's lack of power when going uphill but normal on flat roads?

If a motorcycle lacks power when going uphill, it indicates insufficient power and torque output from the engine, meaning the engine's combustion and work performance are not ideal. This can be divided into issues with the engine itself and external engine problems. Related explanations: 1. Abnormal fuel supply system: Apart from improper fuel supply caused by a clogged fuel filter, issues such as bent or blocked fuel lines cannot be ruled out. You can check if the fuel flow is normal by disconnecting the lower fuel line. 2. Ignition system: Whether it's a fuel-injected vehicle or a carburetor vehicle, both have an ignition system. However, fuel-injected vehicles usually integrate the ignition unit into the ECU, but they still need to drive the ignition coil and spark plugs externally. If the ignition unit has been used for too long, the performance of the internal transistors may degrade, or the capacitor capacity may decrease, leading to a reduction in the engine's power and torque output, making it difficult to climb hills.
5
0
Share

Will changing lanes in a tunnel result in penalty points?

If a driver changes lanes once in a tunnel where lane changes are prohibited and is captured by electronic police surveillance, they will be penalized with 3 demerit points and a fine of 200 yuan. Relevant information: 1. Reasons for prohibiting lane changes in tunnels: The road surface inside tunnels is relatively narrow with poor visibility. If the tunnel has curves, changing lanes can easily lead to accidents, hence the prohibition. 2. Legal basis: According to the "New Traffic Regulations on Driver's License Penalty Points": If a motor vehicle driver commits any of the following violations, they will be penalized with 3 demerit points: Driving a passenger vehicle (excluding buses) or school bus with passengers exceeding the approved number by less than 20%. Driving a medium-sized or larger passenger or cargo vehicle, or a hazardous materials transport vehicle on roads other than highways or urban expressways, or driving any other motor vehicle at a speed exceeding the limit by less than 20%.
11
3
Share

How Long After Passing Subject 2 Can You Schedule Subject 3?

Generally, there is a 10-20 day interval between Subject 2 and Subject 3. You can schedule the Subject 3 exam online 10 days after passing Subject 2. Difficulties in Subject 3 exam: 1. Stalling during the test: Stalling mainly occurs during the starting phase, due to improper control of the clutch's semi-engagement point. 2. Mismatch between speed and gear: The Subject 3 exam has specific speed requirements, and students need to know which gear matches which speed. Low gear at high speed or high gear at low speed will cause severe shaking of the vehicle, and the computer system will automatically deem the test as failed. 3. Parking more than 30cm from the roadside line: The Subject 3 exam standards clearly require that after parking, the distance between the wheels and the roadside curb should be within 30cm. During the test, many students overlook the parking distance and angle, leading to a failed exam.
12
4
Share

What is the process of obtaining a driver's license in Tianjin?

Tianjin's driver's license process generally includes: registration, subject one, subject two, subject three, and subject four. Related introduction: 1. Overview: The full name of a driver's license is a motor vehicle driver's license, also known as a "driver's license." It is a certificate required by law for motor vehicle drivers. In China, a driver's license is defined as a legal document issued by the management department after a person who is legally allowed to learn to drive a motor vehicle has studied, mastered traffic regulations and driving skills, and passed the examination, permitting them to drive a certain type of motor vehicle. 2. Expansion: Only after the driver has completed study, training, and assessment will the traffic police department of the Ministry of Public Security issue a qualified driver's certificate.
18
2
Share

Can I apply for a temporary license plate if my license plate is lost in another location?

No, you need to go to the place where the license plate was issued to handle it. You can apply for a temporary license plate at the local vehicle management office if you meet one of the following conditions: 1. When driving the vehicle back from the place of purchase to the place of use: you need to apply for a temporary license plate at the vehicle management office in the place of purchase; 2. When the vehicle is transferred and the official license plate has been surrendered: you need to apply for a temporary license plate at the local vehicle management office to drive back to your home location; 3. When a new vehicle that has not yet obtained an official license plate in the local area needs to be driven to another location for modification: you need to apply for a temporary license plate locally, and after the modification is completed, apply for a temporary license plate at the local vehicle management office to drive back to the original area; 4. When a vehicle purchased locally needs to be driven to another location: you need to apply for a temporary license plate locally to drive to the other location; the same applies vice versa; 5. When the vehicle registration is not yet fixed and a temporary trial is needed.
20
5
Share

Do I Have to Practice Subject 3 Continuously?

Subject 3 does not necessarily require continuous practice. Generally, practicing for about 3-7 days is sufficient before taking the test. Below are the basic requirements for obtaining a driver's license: 1. Height: Applicants for large buses, tractors, city buses, large trucks, and trolleybuses must be at least 155 cm tall. Applicants for medium-sized buses must be at least 150 cm tall; 2. Vision: For large buses, tractors, city buses, medium-sized buses, large trucks, trolleybuses, or trams, the naked or corrected vision of both eyes must reach at least 5.0 on the logarithmic visual acuity chart. (Note: Glasses are allowed.) For other vehicle types, the naked or corrected vision of both eyes must reach at least 4.9 on the logarithmic visual acuity chart; 3. Color vision: No red-green color blindness.
18
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.