Are Cars in Taiwan Left-Hand Drive or Right-Hand Drive?

1 Answers
LaDakota
07/30/25 1:19am
Taiwanese cars are left-hand drive. Below is a partial introduction about global road traffic directions: 1. Introduction: Road traffic direction is an important aspect of traffic regulations in countries worldwide, stipulating the driving orientation of vehicles on roads to avoid confusion and accidents. Road traffic directions can be divided into two categories: driving on the left side of the road and driving on the right side of the road. 34% of countries drive on the left, while 66% drive on the right. If calculated by road mileage, 28% of the world's passable roads are left-hand drive, and 72% are right-hand drive. 2. Vehicle Driving Direction in Taiwan: Cars in Taiwan are left-hand drive, and vehicles drive on the right side of the road. Taiwanese license plates consist of two English letters at the front followed by four numbers, such as AD-1234.
Was this review help?
20
2
Share
More Forum Discussions

How to Switch to Sport Mode in the Lynk & Co?

The steps to switch to sport mode in the Lynk & Co are as follows: 1. Press the 'DRIVE MODE' knob next to the gear lever, and the central display will show the driving mode selection interface. 2. Rotate the 'DRIVE MODE' knob to select the driving mode on the central control screen. After selecting 'Sport Mode', press the knob to activate the mode. The corresponding mode icon will be highlighted on the central display, and the dashboard will also display a corresponding icon. (Note: In sport mode, the engine speed will increase by approximately 250 RPM, the vehicle response will be faster, the system will reduce power steering assistance, and accelerate steering response, thereby further enhancing the vehicle's sporty characteristics.)
3
0
Share

Where is the Camry trunk switch located?

Camry trunk switch is located below the left side of the driver's seat. The position of the car trunk switch button varies depending on different manufacturers and models. There are two methods to open the Camry trunk: using the trunk opening button on the car key, or directly pressing the red circle button under the driver's seat. Below are the reasons why a car trunk may not open: 1. Linkage rod or lock cylinder issue: If you frequently use the key to open the trunk, the linkage rod may be broken and needs to be repaired at a service center. If you always use the remote to open the trunk, the lock cylinder may be dirty or rusty; spraying rust remover into the lock cylinder a few times can help open it. 2. Mechanical part failure: The trunk itself may have issues, such as a broken wire or other trunk-related problems causing the car trunk not to open.
9
3
Share

How Many Cabin Air Filters Does a Car Have?

Cabin air filters are generally one per car, while some high-end vehicles may have two. The cabin air filter is typically installed inside the glove compartment on the passenger side, and it can be seen by opening the glove box. Here are the functions of the cabin air filter: 1. The car cabin air filter is a specialized filter designed for air purification inside the vehicle cabin. 2. It uses a high-efficiency adsorption material—activated carbon composite filter cloth made of activated carbon and long-fiber non-woven fabric; compact in structure, it effectively filters smoke odors, pollen, dust, harmful gases, and various odors. 3. The filter efficiently traps and adsorbs particulate impurities, achieving oil filtration and air purification performance, while also effectively removing organic gases such as TVOC, benzene, phenol, ammonia, formaldehyde, xylene, and styrene. It is an ideal material for cabin air filters in various high-end cars, sedans, and commercial vehicles.
5
3
Share

What is the normal idle speed for a vehicle?

For an engine with good working performance, the idle speed is generally between 550-800 RPM. Idle speed refers to the operation of the engine under no load, where it only needs to overcome the internal friction resistance of its components without delivering power externally. The minimum speed required to maintain stable engine operation is called idle speed, which is one of the five basic operating conditions of an engine. Generally, different vehicle models may have slight variations in idle speed, and the specific value should be determined based on the vehicle model. Below are some relevant details: 1. There are two types of engines on the market: turbocharged and naturally aspirated. Due to the differences in engines, the idle speed values also vary. Even for the same engine model, different tuning can result in different idle speeds. However, under normal circumstances, for a properly functioning vehicle without any engine abnormalities, the idle speed is generally below 1000 RPM, typically maintained between 600-900 RPM. 2. Under different environmental conditions, the vehicle may exhibit a higher idle speed when first started. For example, during cold weather or a cold start, the engine requires reaching a certain temperature to achieve optimal operating conditions.
17
1
Share

What model of battery does a car key use?

There are three types of batteries commonly used in car keys: 1. CR2016 button-type battery. This model of button battery is highly prevalent in modern car key remotes and is one of the most universal car remote batteries. These batteries have a voltage of 3V, and since car key remotes typically require 9V, all three batteries need to be replaced at the same time. 2. CR2025 button-type battery. This model is far less commonly used than the CR2016. It is thicker than the CR2016 but has a higher energy storage capacity. The specifications of the CR2025 are: battery diameter of 20mm and thickness of 2.5mm. This model is often used in audio remote controls. 3. Alkaline 12V battery. The 12V alkaline battery was commonly used in early car key remotes and electric rolling doors in shops. Older models of car key remotes, such as those from Honda and Toyota, often used this type of battery.
15
0
Share

What causes the steering wheel to not automatically return to center?

There are several main reasons why the steering wheel fails to automatically return to center: 1. Uneven tire inflation pressure between left and right wheels. Inconsistent tire pressure is one of the primary causes of weak return force. To diagnose this issue, a tire pressure gauge must be used. Kicking the tread with your foot can only provide a rough estimate of tire pressure. The reason uneven tire pressure causes failure to return to center is that the side with lower pressure has increased ground contact area, naturally encountering greater road resistance, thus causing the vehicle to pull toward the side with lower pressure. In this case, the left and right tire pressures should be readjusted to maintain consistent inflation pressure on both sides. 2. Uneven tire wear between left and right wheels with significant differences. If there is substantial disparity in tire wear between the left and right wheels, it can pull the steering wheel to one side. This issue can usually be addressed through tire rotation. To resolve steering wheel pull and extend tire service life, vehicles should undergo tire rotation every 10,000 kilometers of driving.
10
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.