This was a project rig I picked up several years ago and never finished. I bought a Jeep last year instead , now this rig needs to go! It's been sitting for a couple years now but does run and drive. I've put a LOT of new parts in it (around $1000) however it still needs work. The last thing I did was replace the water pump, it had a leak when I finished but I never got around to tearing it back down to fix it, so it should probably be trailered. 3.3L V6 - VG33E Engine. Manual Transmission with a good clutch, 4wd works well...fun rig to drive. Needs a thorough cleaning! WILL NOT PART OUT - Dont Ask! $2,500.00 or OFFER Long list of new parts with receipts. Battery (new in 2021...been maintaining it) Front Brake Caliper - Drive/Pass Front Brake Pads - Drive/Pass Front Crankshaft Seal Timing Belt & Tensioner Timing Cover Bushings Water Pump Drive Belts Knock Sensor Thermostat Coolant Temperature Sensor - ECM Coolant Temperature Sensor - Gauge Throttle Position Sensor Crankshaft Position Sensor Intake Air Control Valve PCV Valve Spark Plugs Plug Wires Upper & Lower Intake Plenum Gaskets Throttle-body Gasket EGR Valve Gasket Valve Cover Gaskets Valve Cover Bolts Fuel Injector Cap Bolts Fuel Injector O-rings & Bushings Radiator Hoses Fuel line Hoses Intake Plenum Coolant Hoses Heater-to-Intake Plenum Coolant hose Plenum-to-Throttle-body Coolant Hoses Throttle-body Air Intake Boot Hose Clamps Antifreeze/Coolant Front Drive Axle - Drive/Pass Front Inner/Outer Wheel Bearings/Races - Drive/Pass (reused seals) Coolant Reservoir Cleaned Upper & Lower Intake Plenums Cleaned Throttle-body