···
Log in / Register

What is the fuel tank capacity of the 2016 Changan CS75?

3 Answers
Tyra
08/29/25 6:05am
The fuel tank capacity of the 2016 Changan CS75 is 58L. This data is official. Owners of the 2016 Changan CS75 can also check this information on the vehicle's configuration sheet. The 2016 Changan CS75 uses 92-octane gasoline. The 1.5T manual transmission model has an NEDC combined fuel consumption of 8.1L/100km, allowing a range of 716km on a full tank. The 1.8T automatic transmission model has an NEDC combined fuel consumption of 8.8L/100km, with a range of 659km on a full tank. The 2.0L manual transmission model has an NEDC combined fuel consumption of 8.5L/100km, offering a range of 682km on a full tank. During daily driving, it is essential to monitor the remaining fuel level in the tank. This is typically done by observing the fuel gauge inside the vehicle. If there are no other issues, the fuel level will be accurately reflected on the gauge. The fuel gauge usually has 5 to 6 segments, and it is advisable to refuel when only 2 segments remain to avoid running out of fuel mid-journey. During actual refueling, the amount of fuel may exceed the marked capacity. This is because the manufacturer's specified tank capacity is measured from the bottom of the tank to the safe limit, and there is additional space from the safe limit to the tank opening. This space ensures that the fuel can expand when temperatures rise without overflowing. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the marked capacity. Additionally, several factors can affect a car's fuel consumption: Vehicle weight: There is a direct correlation between weight and fuel consumption. A 10% reduction in weight can lead to a corresponding reduction in fuel consumption. Car design: A lower drag coefficient results in significantly reduced fuel consumption, while a higher drag coefficient increases fuel consumption proportionally. Low tire pressure: This increases friction and adhesion, leading to higher fuel consumption. Driving habits: Rapid acceleration and frequent braking can significantly increase fuel consumption. Wind direction: Driving with a tailwind reduces fuel consumption, while driving against a headwind increases the engine's workload and fuel consumption rate. Road conditions: Driving on flat roads consumes less fuel compared to driving on rough or steep roads. Use of additional electronic devices: Using extra equipment like air conditioning while driving increases fuel consumption.
Was this review help?
4
3
Share
DelDelilah
09/11/25 3:45am
As a long-distance driver, I've driven the 2016 Changan CS75 with a fuel tank capacity of 58 liters. With an average fuel consumption of 10L/100km, a full tank can cover about 580 kilometers, which is sufficient for cross-province trips. I particularly emphasize fuel tank maintenance and recommend owners regularly inspect the fuel cap seal to prevent gasoline evaporation or external contamination. For long trips, fill up in advance to reduce the risk of mid-journey stops. Also, pay attention to the tank material - this model uses plastic, which is lightweight but prone to aging. After 5 years, a leakage inspection is advisable. During daily driving, avoid waiting until the fuel gauge is empty before refueling; maintain at least 15% fuel to protect the fuel pump. Knowing the tank size gives me more confidence in trip planning.
Was this review help?
15
2
Share
Expand All
SanCalvin
10/25/25 4:36am
After years of car repair, I've often been asked by car owners about fuel tank capacity. The 2016 Changan CS75 has a standard 58-liter fuel tank. Don't rely on estimates when measuring capacity - official data is more reliable. I've seen owners mistakenly believe that fuel tanks expand with heat and contract with cold, but that's a misunderstanding about reserve space. In actual use, the capacity is fixed, and fuel consumption is affected by vehicle weight and road conditions. Regularly inspect the fuel system sensors to avoid false alarms that lead to panic refueling. External rustproofing treatment of the fuel tank is also crucial, especially in rainy areas to extend component lifespan. Understanding these details can help you save money and peace of mind.
Was this review help?
4
5
Share
Expand All
More Forum Discussions

What does it mean when the car prompts to check the engine system?

When the car prompts to check the engine system, it indicates that there is an issue with the components of the vehicle's engine. The engine warning light illuminates to alert the owner to inspect the engine components. The engine emission system fault light, commonly referred to as the engine fault light, will turn on the indicator on the dashboard when the ECU detects and reads a fault code. Possible causes for the engine exhaust system malfunction include substandard gasoline quality leading to catalytic converter poisoning, or damage to the oxygen sensor in the catalytic system. This can result in reduced power during driving, increased fuel consumption, and more severe exhaust pollution from the vehicle.
15
5
Share

What Causes the Vehicle's Engine Malfunction Light to Illuminate?

Reasons for the vehicle's engine malfunction light to illuminate: 1. Poor combustion state; 2. Engine knocking; 3. Poor fuel quality; 4. Dirty engine cylinder interior with accumulated carbon deposits; 5. The computer cannot obtain engine data. Solutions for the engine malfunction light: 1. Clean the engine. Once the engine malfunction light comes on, the owner should promptly clean the engine; 2. Improve fuel quality, such as using good fuel additives to enhance the fuel's cleanliness level; 3. Use higher-grade gasoline. After engine cleaning, to maintain the engine's good working condition, the owner can choose to use 95 or 97 octane gasoline, which usually resolves the issue of the engine malfunction light illuminating.
11
3
Share

Where to Check Tire Pressure on Buick Verano?

Buick Verano is equipped with an active tire pressure monitoring system, allowing drivers to view specific tire pressure values on the instrument panel during normal operation. Buick Verano tire pressure light reset tutorial: 1. Inflate tires to normal pressure range; 2. Start the vehicle; 3. Use the selection buttons on the steering wheel to locate the tire pressure option on the instrument panel display; 4. Press and hold the confirmation button on the right side of the steering wheel to complete the reset. Buick Verano is a mid-size sports sedan under SAIC-GM Buick, with dimensions of 4723mm in length, 1802mm in width, and 1466mm in height, and a wheelbase of 1476mm. The interior of Buick Verano inherits the 360-degree wraparound integrated design concept, with dynamic lines complemented by a new cool black color scheme, creating a more youthful and sporty atmosphere.
18
5
Share

How to Unlock the Steering Wheel on a Volkswagen?

Volkswagen steering wheel unlocking method: Hold the steering wheel with your left hand and gently shake it, while simultaneously turning the key with your right hand to unlock it. Volkswagen steering wheels are equipped with a locking mechanism, meaning that after turning off the engine and removing the key, turning the steering wheel slightly will engage the lock. To unlock it again, insert the key and turn the steering wheel back and forth. Volkswagen is an automobile manufacturer headquartered in Wolfsburg, Germany. The name Volkswagen translates to "the people's car," and the company's logo has undergone several changes throughout its history. The current Volkswagen logo features the letters VW, which are the initials of the full name, and the design resembles three V's formed by middle and index fingers.
10
1
Share

What is the positioning of the Junfeng E11K model?

Junfeng E11K is positioned as a pure electric compact car, with a length, width, and height of 4665 mm, 1700 mm, and 1540 mm respectively, and a wheelbase of 2700 mm. The Junfeng E11K adopts a front-engine, front-wheel-drive layout, featuring a MacPherson strut independent front suspension and a torsion beam non-independent rear suspension. In terms of power, the Junfeng E11K is equipped with a permanent magnet synchronous motor, which delivers a maximum horsepower of 136 hp, a total torque of 260 Nm, and a total power of 100 kW. It is paired with a single-speed transmission for electric vehicles.
17
3
Share

How to reset the maintenance light on Great Wall Fengjun 5?

Great Wall Fengjun 5 maintenance light reset method: 1. Turn off the car's engine, after the engine is turned off, press and hold the reset button; 2. While holding the reset button, insert the key to start the engine; 3. After the vehicle starts, release the reset button, then briefly press the clock adjustment button once; 4. At this time, the maintenance cycle light will display in reset mode, and after a few seconds it will return to the normal view, indicating the maintenance light reset is complete. The Great Wall Fengjun 5 is a pickup truck under the Great Wall brand. In terms of power, the Great Wall Fengjun 5 is equipped with a 2.0T diesel engine, 2.5T diesel engine, 2.8T diesel engine, and 2.2L and 2.4L gasoline engines, paired with a 5-speed manual transmission.
20
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.