How to Reset the Tire Pressure Warning on a Lynk & Co?
3 Answers
To reset the tire pressure warning on a Lynk & Co, follow these steps: 1. Use the central display screen to set or modify the reference value for the tire pressure monitoring system. 2. Click on the function on the central display screen, locate the tire pressure monitoring system button for calibration, and the system will display a message indicating that calibration has started. 3. After calibration is complete, drive the car at a speed of approximately 30 kilometers per hour for about ten minutes. Taking the 2021 Lynk & Co 03 as an example, it is a compact car with the following dimensions: length 4639mm, width 1840mm, height 1472mm, wheelbase 2730mm, and a curb weight of 1395kg.
I remember when I first bought my Lynk & Co, the tire pressure warning light freaked me out. I immediately pulled over and used my portable tire pressure gauge to check all four tires. The front left tire was below 2.0 bar, so I quickly inflated it to the recommended standard of 2.5 bar. Back in the car, the warning light was still on—that's when I realized I needed to operate through the central control screen. I opened the vehicle system settings, entered the vehicle status menu, found the tire pressure monitoring option, and selected reset. Problem solved. Actually it's quite simple—new drivers shouldn't panic. First check the tire pressure to ensure safety, then reset to clear the warning. But remember, if the warning keeps reappearing, it's likely due to sensor aging or air leakage. You must visit a service station for thorough inspection to avoid road hazards. Now I'm proficient—I check tire pressure quarterly to prevent issues, which saves money and gives peace of mind.
As a car enthusiast, I always enjoy fixing minor issues myself, and I'm very familiar with the tire pressure warning. Just last week, I dealt with it: first, I used a precise tire pressure gauge to check all tires and inflated them to 2.5 bar (the recommended value for Lynk & Co can be found in the maintenance manual). Then, without starting the engine, I turned on the ignition, found the settings button on the center console, scrolled to the tire pressure system, and held the confirm button for a few seconds until the beeping stopped. The whole process took just a few minutes, saving me a trip to the shop. Sometimes, the warning is triggered by dirty sensors—just wipe the wheel hub sensors with a damp cloth. However, I must remind you that if the light flashes or stays on after resetting, it's likely due to loose wiring or a faulty module, which requires replacement. DIY replacement costs around a hundred yuan, while a shop might charge a few hundred. If you're handy, give it a try.
